Programming Remote

How do you program one remote to work with the television and the satellite receiver?

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by TommyFwithDISHNetwork on December 24th, 2010 6:47 AM

This answer was accepted by the poster of the original question.

TommyFwithDISHNetwork

Member since:
December 23rd, 2010

Points: 146,120

1,100
points

Hello, my name is Tommy Faust with DISH Network. To program your remote to the receiver first.

1. Go to System Information screen.

2. Press and hold the SAT(Satellite) button until all buttons light up.

3. Release and it will be blinking. Enter a number between 1-15 and press #, then press record and the number on the bottom should change.

As for the tv we can get you the code to do that, just let me know on here what brand of tv you have! Hope this helped!

Tommy Faust
DISH Social Media Representative
Sunday-Wednesday 6A-5P MST
[email protected]

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : Tech Depot : HDTV
... to the standard and high definition DISH Network digital satellite programming already supported. It has a built in addition to the digital television standard we use . The 622 satellite receiver delivers local off -air digital programming. The 622 receiver also supports 8PSK for off -air analog and digital HDTV programming (where available), in addition to 30 hours of both...
Tech Portal : Remotes : 3.1/3.2 Remote : How To : Addressing to DTVPal
...program the DISH Network remote to press record. Simply start this procedure and at the top of the remote until all mode button backlights illuminate (about 3 seconds), then release. Note: you must use 1) Press # (pound) on the remote.... There is no need to the receiver, follow these steps. If you have to see if the remote works with the receiver. Press and hold the SAT button at...
Tech Portal : 322 : Receiver Information : Receiver Images
... advance six hours, press the 6 button followed by the receiver for TV1. Capable of storing a combined total of information with one satellite receiver TV-1 uses 3.0 IR Remote, green #1 TV-2 uses 4.0 IR/UHF Pro Remote, blue #2 Tuners do not correspond to block out channels or individual programs based on two TV's with quick access. Go to see...