How To Program Remote And Tv2

need steps in order to program second tv

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by Anonymous-40186 on October 13th, 2011 11:54 AM

This answer was accepted by the poster of the original question.

Anonymous-40186

Member since:
October 13th, 2011

Points: 1,060

1,060
points

I saw your post, jmvaller, and would be happy to help! To get that done, follow these instructions:

With the desired equipment on, press and hold the correct Mode button until all mode button backlights illuminate, then release.
Press and release the Power button.
AUX Mode: Before pressing and releasing the Power button
- Press 0 for a TV
- Press 1 for a VCR/DVD
- Press 2 for any other device
Then Press STAR (*)
Press the Up button once a second while pointing the remote at the desired equipment.
If the code for the equipment comes up, the equipment will power off.
Press the POUND (#) button.
If the code entered is valid for the remote, the mode light flashes three times.

If you have any questions or need any further assistance, please don't hesitate to let me know! I hope that helps!

Mike LeMar

DISH Network

Customer Service

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : (choose receiver model) : Remotes : (choose remote)
... PAGE DOWN instead of RCA TV codes). The light will need two discrete buttons for Power ...TV (and if applicable VCR) inputs until all mode lights flash three times, slowly press the Recover button to highlight and select System Info. Put the Green UHF Pro Indicator Tab with part number 137174. The Primary Remote address field should change ) the desired TV2 channel Program Remote...
Tech Portal : (choose receiver model) : Install : Connector Color Code Chart
... either the "Air" on the television as normal. button on the remote control and change channels on the TV where satellite programming can be to use the TV2 composite audio/video output. This is accomplished by simply changing the TV channel to 28, changing the mode of coaxial cable within the setup menus...
Tech Portal : 942 : Install : 942 Initial Install
...off -air channels or select Add Locals to see a picture, temporarily connect the RCA-type TV2 outputs to the nearby HDTV, and change the HDTV to the appropriate input to add them ... Install These steps are finished finding off -air antenna cable near the receiver. Off-Air Antenna: If you may need to this completed before calling in the remote control and press RECORD. Program TV mode and ...