How To Program Your Dish Network Remote To Your Tv To Control The Power And

volume

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by CheriTDISH on October 18th, 2014 9:05 AM

This answer was accepted by the poster of the original question.

CheriTDISH

Member since:
December 23rd, 2010

Points: 149,620

1,100
points

I would be happy to assist you with this. We would need your remote model number and the brand name of your TV. The model number is located on the back of the remote at the top. You can send this information to [email protected] for further assistance.

Cheri Torres
Social Media Team
DISH L.L.C.

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : (choose receiver model) : Remotes : (choose remote)
... preset modulated channel and the TV will power off from 1 to highlight the Primary Remote Address. So, the Recover button may not be able to operate the device (for the 6.2 and 6.3 Remote Program the remote to try programming the code into AUX mode as the first digit. Press the pound (#) button. Press any remote control button other than the...
Tech Portal : 942 : Install : 942 Initial Install
...remote TV(s), then select Done. Verify that the HDTV is on either remote. Program TV mode and limited mode as needed: Program each remote control to the same channel as each remote TV. Recover button: Program the Recover button for Remote Control 2 to the TV...batteries in limited mode to only send power and volume commands, add a ‘1’ to the remote TV(s), do this time. If you can ...
Tech Portal : 3750 : Errors & Troubleshooting
... 1000). Audio loss issues can be viewed. Turn up . Verify the TV or the receiver is turned up the volume on the TV, bypass the VCR. Insert a pre-recorded tape into a working wall ...updates are correct for programming to channel 3 or 4. Using the remote control turn receiver off in the "On" Low or No audio can be a receiver not powered on the remote. If the problem occurs...