How To Program A Dish Remote To Control Volume On Vizio Tv

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by kimesco on April 29th, 2014 2:45 PM

This answer was accepted by the poster of the original question.

kimesco

Member since:
December 23rd, 2010

Points: 303,510

1,100
points

I have listed the steps below to assist with programming the remote to your TV. If you have any other questions, let me know at [email protected]!

Follow this link to obtain the code/s to program the remote to your Tv: http://www.mydish.com/support/apps/remotecodes.aspx?WT.svl=leftnav

1.) Press and hold the clear TV button until all mode lights light up.
2.) Release and TV light will be blinking.
3.) Enter code and press #. The TV button should flash 3 times.
4.) Try functions (Volume, Power, etc..) and see if it is working.
5.) If no function, repeat steps 1-4 with another code.

Kimberly Escobar

Social Media Representative

DISH L.L.C

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : 942 : Install : 942 Initial Install
...Remote Control 2 to the existing wall cable outlet. No analog off -air antenna to the remote TV(s), do so at the nearby HDTV, go to program the TV in Cable Mode. Set each remote TV to the same mode (Air or Cable) as each remote TV... to the TV. Note: If you set in limited mode to only send power and volume commands, add a ‘1’ to press RECORD on either remote. Program TV mode and ...
Tech Portal : (Choose Receiver) : Receiver Information : DVR Recording
... Program Guide is full screen and not in the program. When the program ends, press the remote control ...remote. Move the highlight in TV volume will not reach the TV2 location. RECORDING TWO LIVE PROGRAMS WHILE WATCHING A RECORDED PROGRAM to a program...programming. RECORDING A LIVE PROGRAM WHILE VIEWING A PRE-RECORDED PROGRAM Set up to open the Program Guide. DVR Recording The DISH...
Tech Portal : Remotes : How To : SAT TV Autotune
... the steps under Setting SAT Auto-Tune Channel. SAT Auto-Tune can also be on newer DISH Network remote controls lets the user program into the remote control the correct TV channel used for three seconds until all four mode buttons are lit. Because of this, SAT Auto-Tune is enabled by default on TV2, and ...