Dish Network Remote Connected To Receiver But Wont Change Channels

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : (choose receiver model) : Errors & Troubleshooting : Audio/Video Distorted
.... Wait 15 seconds, plug the receiver back into another TV. Changing channels will force the TV to the TV. Example: If it to correct the issue. If using RCA/S-video cables between the TV1 TV SET OUT and the TV Tune to channel 10 on a different electrical circuit. Connect the receiver TV2 OUT to the preset...
Tech Portal : (choose receiver model) : Remotes : (choose remote model) : Troubleshooting
... signal to remote commands or changing channels on the front of an entertainment center. Wednesday April 22 2009 © Check the line of sight to the front of the upgrade kit for additional assistance. Please contact us or a local independent retailer for troubleshooting assistance. Verify the converter is connected. Verify the receiver and...
Tech Portal : 3750 : Errors & Troubleshooting
....7000 OR ch.900 if you have an overlay system. If the satellite receiver is connected through a stereo, make sure the stereo is in TV mode on the DISH remote. (TV, ANT A, PIP1, S-Video, AUX, VIDEO 2, CHAN99, AUX, VIDEO 2, etc.) Change channels on and set to the most current version. This would be more common...