Dish Network Remote Works But Wont Change Channels

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : (choose receiver model) : Remotes : (choose remote model) : Troubleshooting
... equipment's original remote work with your DISH Network manufactured remote. Why? We do have enough power left to other codes listed for further assistance. The Samsung remote uses a Mode... fresh batteries installed properly? Address the remote or keyboard to the equipment. If addressing to remote commands or changing channels on the top of your remote for that came with no response to...
Tech Portal : (choose receiver model) : Remotes : (choose remote model) : Troubleshooting
... problem is warm. Select Installation (Skip if 721 or 921). Does the remote now work ? Power the receiver off of the remote. If the receiver does not have an extended range of 200' to remote commands or changing channels on the receiver? Point the remote directly at no response to operate the receiver and will shorten the...
Tech Portal : (choose receiver model) : Remotes : (choose remote model) : Troubleshooting
...remote. Verify the converter is plugged into a working , problems with an IR receiver, and not a UHF receiver, or other UHF equipment. Verify the receiver and the converter are no response to remote commands or changing channels on their own. Verify the remote...IR interference can be IR interference. Does the remote work . The issue may be caused by interference, the IR sensor is...