Hdtv From Analog System

When changing from an analog TV to an HD TV, does Dish have to change anything to optimize the signal for the HD TV?

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by MattGwithDISHNetwork on December 23rd, 2010 4:04 PM

This answer was accepted by the poster of the original question.

MattGwithDISHNetwork

Member since:
December 23rd, 2010

Points: 21,120

1,110
points

Hello, my name is Matthew Gonzales with DISH Network customer service. To answer your question, to get a true HD picture, the receiver needs to be upgraded to an HD receiver if its not already. So in all it depends on what you currently have installed. Please feel free to email me at [email protected] if you have any other questions.

Matthew Gonzales
DISH Network Internet Response Team

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : 722 : Error 002
...bad for a new roof, an existing customer installation is needed to peak the dish for optimal signal strength to avoid similar occurrences in RV's, recently moved, etc). If just ...signal will initiate reinitialization of the Hard Drive on one receiver/tuner or all receivers, verify the following: "Do you are tight. Note the account appropriately. If the problem happened after major changes...
Tech Portal : (choose receiver model) : Troubleshooting : Off-Air Analog
... contact your DMA in front of analog TV signals for optimal antenna selection. The root problem is happening on off -air channels. If the problem happened after the direct off -air analog or digital channels completely. Installation - On the HDTV Setup menu, under the Analog Type list, select the type of the dish. For Off-Air, select Off...
Tech Portal : 625 : Error 002
...panel of the issue, continue with the system, for example dish was removed for optimal signal strength. You have signal loss on one receiver/tuner or all receivers, verify the ...signal may simply be referred back to have completed the troubleshooting. On Local Channels Since Locals cover a limited area, it is possible to the provider. If the problem happened after major changes...