Dish Network No Signal And Wont Change Channels

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by waelsaidani1 on October 23rd, 2014 6:00 AM

This answer was accepted by the poster of the original question.

waelsaidani1

Member since:
May 12th, 2013

Points: 19,501,787

1,100
points

check the MODE button on the receiver itself (blue light should light or amber light under the dual TV icon) . If you push it and a picture shows up, you're done. If not, try running a channel scan or set-up on your TV's menu (may have to use the remote that came with the TV).

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : (choose receiver model) : Install : Connector Color Code Chart
... becomes the "input" option or "Cable" This, however, is amplified to compensate for signal loss that option's range. Following are combined onto a single cable. button on the remote control and change channels on the TV. Selection of coaxial cable within the home. To meet requirements covered under FCC Compliance...
Tech Portal : 3750 : Errors & Troubleshooting
..., blooming picture, washed out picture, dark colors, pink or yellow screen, “No Signal” or “Unusable Signal” Black screen could be caused by the transmission of these conditions, the receiver will... remote. (TV, ANT A, PIP1, S-Video, AUX, VIDEO 2, CHAN99, AUX, VIDEO 2, etc.) Change channels on the TV, bypass the VCR. Insert a pre-recorded tape into a wall outlet. S-Video cable Verify...
Tech Portal : TR-50 : A615
... assistance, please select “help” Errors A602, A615, intermittent signal loss messages, low signal on . Rain outage only occurs during the heaviest rains with only a small portion of the antenna, a possible antenna blown off -air system to the last viewed channel. Please wait. [channel info] To change channels, press the UP or DOWN arrow buttons on your...