Denon DN X1700 Support Question
Denon DN X1700 Support Question
Find answers below for this question about Denon DN X1700 - PROFESSIONAL DIGITAL DJ MIXER.Need a Denon DN X1700 manual? We have 1 online manual for this item!
Question posted by whito420 on April 8th, 2013
Avr 1700 Display Is Dim And Hard To Read, Can This Be Fixed?
Display is dim and hard to read. can it be fixed?
Current Answers
Related Denon DN X1700 Manual Pages
Owners Manual - Page 2
...place metal objects or spill liquid inside the DJ mixer. Electric shock or malfunction may cause undesired ... used in the literature accompanying the appliance. Read these instructions.
3. A polarized plug has ... of the FCC Rules. Model No. DN-X1700 Serial No.
LABELS:
CAUTION
TO PREVENT... near any ventilation openings. This Class B digital apparatus complies with Part 15 of uninsulated "...
Owners Manual - Page 5
...Panel 3 Rear Panel 5 Display 6
Connections
Preparations 7 ...audio 13
Setting the USB audio output 13 Setting the USB audio input 13 MIDI 14 Setting the MIDI channels 14 Setting the MIDI clock 14 MIDI layer operations 14
Getting Started
Installation
When the DN-X1700 is mounted inside a coffin or DJ booth, we recommend leaving a 20 mm (Bottom 2.5 mm) blank space above the mixer...
Owners Manual - Page 6
... synchronization with external devices.
2. USB audio and MIDI interfaces • 8-channel (4 stereo channels) 96 kHz USB audio input/output function • ASIO driver...DJ full digital mixer which supports 96 kHz/32-bit digital-to-analog conversion and which achieves a low latency packed together with the unit • USB assign switch function enabling system switching for professional...
Owners Manual - Page 7
... Refer to 4). Q4 DRY/WET control
Use this to adjust the ratio of the USB audio input signals supplied from the USB MIDI and MIDI output terminals to adjust the filter ...started.
When it is measured using the u BEAT , buttons. Q3 PARAMETER MIX/MAX control
This is displayed.
AUTO BPM: When the button is held down for the master output signals.
STOP: Sending the MIDI...
Owners Manual - Page 8
...SEND LEVEL control
This is selected, the LED of the corresponding button lights up blue.
When DIGITAL is used to the master output. At the -∞ position, the frequencies of all of... output. W1 SPLIT CUE button
There are displayed. E0 MIC1, MIC2 TRIM controls
Adjusts the level of the channel fader. Split CUE OFF: The master output audio level is attenuated. * The ducking attenuation ...
Owners Manual - Page 9
... the USB MIDI, HID and USB audio signals.
i REC OUT terminals
These are used to connect devices such as a USB memory or USB hard disk drive can be connected to this...digital output data. GND, 2.
e COAXIAL DIGITAL OUT terminal (44.1/ 48/
96kHz) Output from an audio/video store.)
r LINE 1, 2, 3, 4 FADER output terminals
Connect these terminals to the Fader input terminals of the DN-S1200, DN...
Owners Manual - Page 10
t Navigation display This indicates the current statuses when operations have been performed.
6 w ... when MIDI communication is being performed. Getting Started Connections Basic Operations Effector Function Fader Start USB Utility Specifications Troubleshooting
Display
q
w
e
r
t
q INT/EXT indicator This indicates the location of the Preset currently being used. USB A: USB...
Owners Manual - Page 11
... fastened.
Connect the stereo outputs to the DN-X1700 by turning off while making connections.
2. Be sure plugs and terminals are at very high volume as CD players first, then your mixer, and finally any effects into the stereo Effect, if used. Use high-quality, audio cables.
3. Computer OS versions that could...
Owners Manual - Page 12
... functions to the mic input, set the CD or PHONO as EFX 1 and EFX 2 can be assigned using the MIC2 TRIM control. While inputting the audio signals to select the STEREO or SPLIT CUE mode. CUE monitoring for cue are output from -30 dB +/-10 dB in the CUE button lights...
Owners Manual - Page 13
... reverberation signals which have been delayed by the 2 effectors and which differ between channel input and master output, and present a wide range of other Denon DJ products. The beat pattern is changed.
2. As a result, it possible to send the signals of a multiple number of input channels simultaneously to the effectors.
Initiates...
Owners Manual - Page 14
... BPM
1 When the auto BPM counter is measured at the same time for which the TAP buttons are displayed here. The BPM value can be set directly by pressing the BEAT , buttons.
4 BPM is off,... the EFX SEND 1 and 2 buttons, select the effect units to be used . INPUT : INPUT is displayed when AUTO BPM has been selected as the channel used for the auto BPM counter measurement.
3 Press and hold...
Owners Manual - Page 17
... supports up to the buses shown below.
The USB audio output level can be established when the unit's power is displayed.
2 Using the EFX SELECT control (EFX2), select Audio Setting USB Audio Setting Output Source Select. Setting the USB audio input
One of the DJ software and the DN-X1700's functions.
q CH INPUT mode Select this mode when...
Owners Manual - Page 18
... with USB MIDI input/output and 5-pin DIN MIDI output functions. The LED in the DN-X1700. Channel Fader • MIDI input operation block The channel level meter; Set the MIDI channels. channel EFX SEND 1, 2 buttons; CUE button display
3 When the MIDI layer selector button is pressed again, the EQ control rings change...
Owners Manual - Page 21
... Cue Setting 5 Head Phones EQ 6 EFX Send/Rtn
7 USB Audio Setting
8 Digital I/O Setting
9 X-Fader Setting 10 Beat Breaker Setting 1 Sampling Frequency 2 Display Brightness 3 Display Backlight 4 Display Contrast 5 PC/MAC*³ 6 Version(SYS) 1 MIDI INPUT CH 2 MIDI OUTPUT CH 3 MIDI Output Enable 4 MIDI CLK 1 Preset Export 2 DN-X1700 Initialize Display only
Parameter
1 MONO 1 Ducking Level
2 Mic EQ...
Owners Manual - Page 22
...to be called appears.
3 When OK is selected, the preset Audio Setting and MIDI Setting of the export files.
* Bear in ... is to be updated appears.
3 When OK is to the factory settings. DN-X1700 Initalize Exit / Execute*2
Default OFF 20dB
44.1kHz USB A
-
*1: Using... the Owner Setting mode, set the POWER switch to 10dB
3. Digital Output FS
INT / 44.1kHz / 48kHz / 96kHz
4.
Getting...
Owners Manual - Page 23
...MIDI1.0, MIDI Clock
5pin DIN
PPM 16-point LEDs from -40 to +10 dB, peak display
PPM 24-point LEDs from -50 to +60ºC
379mm 357mm
320mm
90mm 112mm
Unit:...• SEND output Load impedance: Level: • Headphones output Load impedance: Level: • Digital coaxial output
• USB audio output
n GENERAL USB MIDI I/O: MIDI OUT: Channel level meters: Cue master level meters: Channel ...
Owners Manual - Page 25
..., application, OS, etc., properly raised? • Is the appropriate device selected on your audio application? • Is the sampling frequency setting appropriate? Either make the same settings in the DN-X1700's preset mode and on your audio application, it may indicate trouble in the table below may not be broken.
21
If your...
Owners Manual - Page 26
TOKYO, JAPAN www.denon.com
Professional Business Company, D&M Holdings Inc.
Similar Questions
Avr 790 Headphone Problem, Where No Headphone Is Plugged In. How Do I Get It Fix
my receivers not outputting to my speakers because it thinks a headphone is inserted. There is nothi...
my receivers not outputting to my speakers because it thinks a headphone is inserted. There is nothi...
(Posted by Colink2000au 9 years ago)
How To Fix The Slider Pitch On Denon 5000 Cd Player
(Posted by klgiga9 9 years ago)
Denton Avr 1700
I have denon avr 1700 while switching it on it is going to standby .this is happening when my conver...
I have denon avr 1700 while switching it on it is going to standby .this is happening when my conver...
(Posted by abhi1987s 10 years ago)
Fader Problems
My cross fader and up and down faders for individual channels will begin or stop a song as they are ...
My cross fader and up and down faders for individual channels will begin or stop a song as they are ...
(Posted by jay25jay2006 11 years ago)
Denon Avr 1700 Rc-855 Remote
I'm looking for a remote control for my second Denon receiver, UK based if possible. The model is an...
I'm looking for a remote control for my second Denon receiver, UK based if possible. The model is an...
(Posted by HIFIve 12 years ago)