Cub Cadet CC 30 e Electric Rider Support Question
Cub Cadet CC 30 e Electric Rider Support Question
Find answers below for this question about Cub Cadet CC 30 e Electric Rider.Need a Cub Cadet CC 30 e Electric Rider manual? We have 1 online manual for this item!
Question posted by caulkingp on September 15th, 2022
Cc30e Won't Start
cub cadet cc30E With Error code e108
Current Answers
Answer #1: Posted by SonuKumar on September 15th, 2022 10:08 PM
SonuKumar
Member since:
May 9th, 2021 Points: 16,621,300
Member since:
May 9th, 2021 Points: 16,621,300
https://cub-cadet.tractorerrorcode.com/
or
https://www.manualowl.com/m/Cub%20Cadet/CC-30-e-Electric-Rider/Manual/524497?page=1
page 12
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Answer #2: Posted by Technoprince123 on September 15th, 2022 10:18 PM
Technoprince123
Member since:
February 8th, 2021 Points: 1,205,190
Member since:
February 8th, 2021 Points: 1,205,190
Please response if this answer is acceptable and solw your problem thanks
Related Cub Cadet CC 30 e Electric Rider Manual Pages
Operation Manual - Page 2
... chute, removing any grass or debris, or making any type of power equipment, carelessness or error on the part of a cliff, ditch, or if an edge caves in this tractor. ...Loose fitting clothes, jewelry and long hair can cause serious injury to start the tractor.
3. Read, understand and follow all mechanical, electrical and safety systems are operating properly, safely, and are not covered in...
Operation Manual - Page 3
... putting your foot on slopes. All slopes require extra caution. Do not mow on wet grass. Do not mow on slopes greater than 5 degrees (9%). Avoid starting and stopping on the ground.
10. Do not try to the slope gauge included as shown on the slope gauge or a slope measuring device, do...
Operation Manual - Page 4
... gauge number, the heavier the cord.
7. Never tamper with a stop the tractor, push the Start/Stop button, turn the key to the Maintenance Cord Length (ft.) 25
Schedule in the Maintenance Schedule...cool down.
Doing so could cause an explosion.
7.
Other types of corrosion. Do not dispose of electric shock.
3. The cell may be sure the equipment is a risk of the battery in a fire...
Operation Manual - Page 5
... under the cutting deck. ROTATING BLADE(S) Always look down and behind before attempting to assemble and operate. THROWN OBJECTS This tractor may appear on slopes. ELECTRIC SHOCK Do not charge tractor in operation.
WARNING - Never carry children, even with the blade(s) can amputate hands and feet. Be sure blade(s) and power...
Operation Manual - Page 7
... installed on the bottom of the tractor are straight.
(a)
(b) Figure 1
(c)
(d)
4. Align the steering wheel so (a) that the bolt's shoulder is not set. impact gun or electric drill with the rear wheels on the tractor. Securely retighten the adjustment knob. See Figure 3.
7. Secure the pedestal cap (b) with the shoulder bolt (c) and lock...
Operation Manual - Page 8
...the mulch plug (b) into the wall. The small tab (d) on the deck lip area will not start without the mulch plug (b) properly in wet conditions. See Figure 9.
(d)
Important: Make certain that ...recharging.
• Always disconnect battery charger (or extension cord, if used) from the electrical receptacle (outlet) first, then disconnect the charging cord from sources of charge. Turn the...
Operation Manual - Page 9
... tractor.
The vehicle control module (VCM) is depressed. sec. The cruise control can be started , the safety label covering the key switch must be used to operate the blades.
Do...
Located on the tractor when facing forward while seated in the operator's seat. The VCM inludes the START/STOP button,
PTO (blades ON/OFF) button , Reverse Caution Mode
PTO
RCM
(RCM) button, Headlight...
Operation Manual - Page 10
...for more information.
Fully depress the brake pedal or set the parking brake. Press the start the tractor. Disengage the parking brake
10 Deck Lift Lever (G)
Located on the VCM ...engaged a reminder will turn off the blade(s) and drive motors if the operator leaves the seat.
Starting the Tractor
1. Note: If the brake is approximately a 4" cutting height and the change the ...
Operation Manual - Page 11
...Pressure Reminder: Occurs every 5 hours.
Do not operate the tractor when children or others are around . Start the tractor as follows:
Press the PTO button for instructions on .
3. Press and hold the RCM... for three seconds until the desired speed is pressed again to turn the key switch to the lawn.
3.
To travel in reverse is ON (Blades ON). The tractor is a process of service...
Operation Manual - Page 12
...(s)/Sharpen or Replace as Needed
P
P
P
Charge Battery
P
P
Check Safety Interlock System
P
Check Mower Blade Stop Time
Check Blade Mount Bolt Torque (Tighten to extend the life of the Deck
WARNING
To...-Operation Tractor Care
After each use a pressure washer or garden hose to electric components or the electric motor. The underside of tractor deck should be implemented to 450-600 in...
Operation Manual - Page 13
...the parking brake, turn key to OFF position and remove to prevent unintended starting .
Adjustments
WARNING
Before making adjustments, always disengage the PTO, set the parking brake,turn ... remove debris buildup from the front of the blade tip to the tractor's electrical components and motor.
Lubrication
DANGER
Bearing failures and overheating can cause damage to the...
Operation Manual - Page 14
... the way.
2. Disconnect the deck motor(s) from underneath the tractor. If your mower has vertically positioned connectors, see Figure 17. Raise the deck lift lever into the...for cracks or damage, especially after you tractor will not start or operate without the safety switch properly connected.
(b)
(a)
4.
If your mower has horizontally positioned connectors, see Figure 18.
8. See...
Operation Manual - Page 15
... in an open area before returning to service. Fully charge the battery and inflate the tires to 30° angle. A discharged battery can occur.
5. Battery should be fully charged once every month... due to the charger for proper battery recycling.
15 Leaving the battery connected to explosion or electrical shock. The cell may result in a discharged state. It is in a fire. Grind ...
Operation Manual - Page 16
...deck adjustment 2. The blade(s) stopped when traveling in all four tires
Tractor will not start
1. Drive Motor Control Fault: The deck and drive shut off and restart tractor. ...personnel. Drive Motor Over Current Fault: The deck and drive shut off and restart tractor. Electrical system fault
The blades do not rotate /blades stopped 1. 2. Return home, plug into charger...
Similar Questions
Error Code E101 On 6 Month Old Lt42e Will Not Charge
(Posted by donrichardson5355 1 year ago)
Cub-cadet-cc30e-lawn-mower
cub-cadet-cc30e-lawn-mower won`t just beeps after inserting the key. The battery fully charged
cub-cadet-cc30e-lawn-mower won`t just beeps after inserting the key. The battery fully charged
(Posted by paulross 1 year ago)
1 Year Old Cc30e Won't Charge And I Get A 101e Error Message.
I was close to 3% on battery when I stopped mowing and drove my CC30e to the charging area. The mowe...
I was close to 3% on battery when I stopped mowing and drove my CC30e to the charging area. The mowe...
(Posted by cctexan99 1 year ago)
Model Cklt 42e Won't Start. Error Codes E108 And E525
(Posted by richardglanzmann90 1 year ago)
New Mower, Two Error Codes E108 And E116 Showing
New mower, 100% charged last night. Once key is in the display lights up but error codes E108 and E-...
New mower, 100% charged last night. Once key is in the display lights up but error codes E108 and E-...
(Posted by shakesja 2 years ago)