2002 Chrysler Town & Country Support Question
Find answers below for this question about 2002 Chrysler Town & Country.Question posted by velvettw32 on October 7th, 2012
How Do You Program The Remote
Current Answers
Answer #1: Posted by quaff on October 8th, 2012 11:57 AM
1 - Press the lock button on your remote five consecutive times at brief two second intervals.
2 - Place your key in the car's ignition and turn it to the "right" two clicks to the "Run" position
3 - Hold the unlock button. Then press and hold the panic button simultaneously. Release both buttons at the same time and you will hear a small beep to indicate that the programming is in effect.
4 - Press and release both the lock and unlock buttons at the same time.
5 - Turn the key to the off position and remove it from the ignition. Test your remote to see if the programming was successful.
You may need to try these steps 3 or 4 times for the programming to take. If it is still not working, please re-submitt you question with more information. Thanks!
Similar Questions
Both of my keys no longer remotely open my doors and power lift gate. I am sure that the receiver is...
I have recently purchased a 2002 Chrysler town & counrty limited with no owners manual available...