Canon Mp 160 Error 7 Blinking On Light Mac Os

This message may be resolved by resetting the unit.

1. With the printer powered on, open the cover. The ink will move to
the left hand side.

2. Push down on the end of the black cartridge. A clicking noise will
be heard.

3. Slide the cartridge out of the holder towards you.

4. Push down on the end of the color cartridge. A clicking noise will
be heard.

5. Slide the cartridge out of the holder towards you.

6. Once both cartridges are removed, unplug the power to the printer
(without turning it off).

7. Reconnect the power cord.

8. Turn on the printer.

9. Open the cover. The carriage that holds the ink will move to the
left hand side.

10. Make sure the orange cap is off of the bottom of the black
cartridge.

11. Place the black cartridge in the bottom of the printer.

12. Slide the black cartridge back until is cannot go back any further.

13. Push up on the end of the black cartridge, a clicking noise should
be heard.

14. Make sure the orange cap is off of the bottom of the color
cartridge.

15. Place the color cartridge in the bottom of the printer.

16 Slide the color cartridge back until is cannot go back any further.

17. Push up on the end of the color cartridge, a clicking noise should
be heard.

Please note that the color cartridge will stick out further than the
black cartridge.

Close the cover. The printer should make some noise for a few moments,
and then return to standby.

If the message persists, to clear the low ink warning message, press and
hold down the button for at five seconds, and then release
it. This will disable the ink detection until that cartridge has been replaced.