Black & Decker LSTE525 Support Question
Black & Decker LSTE525 Support Question
Find answers below for this question about Black & Decker LSTE525.Need a Black & Decker LSTE525 manual? We have 1 online manual for this item!
Question posted by Lhardy52 on August 7th, 2022
Adjustable Handle
I still have not received a reply to my question: How do I remove the adjustable handle on my Black & Decker weed whip model number: LSTE52
Current Answers
Answer #1: Posted by SonuKumar on August 7th, 2022 10:17 PM
SonuKumar
Member since:
May 9th, 2021 Points: 16,653,150
Member since:
May 9th, 2021 Points: 16,653,150
https://www.youtube.com/watch?v=3ZxCocYRqKc
https://www.manualslib.com/products/Black-And-Decker-Lste525-4358290.html
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related Black & Decker LSTE525 Manual Pages
Instruction Manual - Page 1
... mechanism. • For use only .065 inch diameter ROUND line
(B+D Model #AF-100 is 20 volts. EST Mon. - Fri.
To register your Black+Decker purchase, go to http://www.blackanddecker.com/instantanswers If you can't find the answer or do not have a question or experience a problem with an agent. Please read before trimming or...
Instruction Manual - Page 2
... atmospheres. plantings. speed by hand. However, - Keep handles dry, clean and
taken: MAKE SURE that is damaged ... When using electric
• USE THE RIGHT appliance - gardening appliances, basic safety
• DON'T OVERREACH - It will do trimming... further operation
• GUARD - at
stop appliance immediately, remove
all times. Do not use this information. DANGER: Indicates an...
Instruction Manual - Page 3
Auxiliary handle
7. Height-adjust collar
8. Actual charge time may include
the following symbols. If ... hertz
9 10
7
5
W watts min minutes
11
or AC......alternating current or DC....direct current
12
no no load speed
BLACK+DECKER Battery and Charger Systems
Chargers/Charge Time** (Hours) (0% to filter out microscopic particles. Lock-off . DO NOT allow to ...
Instruction Manual - Page 4
... Do not disassemble charger; received a sharp blow, been...can explode in this manual. The smaller the gauge number of the wire, the greater the capacity of the...removing the battery from the power supply when there is 16 gauge has more than one extension to , steel wool, aluminum foil, or any buildup of metallic particles should be shorted by plug rather than charging designated Black+Decker...
Instruction Manual - Page 5
... received a sharp blow, been dropped, run over or damaged in locations where the temperature may be flammable if exposed to spark or flame. • Charge the battery packs only in
Black+Decker ...seek medical attention. This may be used at this happens, the charger automatically switches to charge Black+Decker battery packs. 1. The completion of charge is between 65°F and 75°F (...
Instruction Manual - Page 6
... normal condition, and does not indicate a problem. B
13
C
14
SAVE THESE INSTRUCTIONS assembly and adjustment
WARNING: Before assembly,
make sure that you hear it "snap" into position. To remove battery pack: Depress the battery release button (14) as in a lamp or other liquid. This...(17) on the guard engage the ribs (18) on the appliance to attach the guard, edge guide or handle.
Instruction Manual - Page 7
... when you release them with the Black+Decker logo facing upward). Partially push the handle on so it "snaps" into place.
• To adjust the handle up or down, press in on the button (22) and raise or lower the handle (figure H).
• The handle should be
adjusted by loosening the height-adjust collar (7) by rotating it in the...
Instruction Manual - Page 8
...proper
eye protection that conforms to trim overhanging grass along lawn edges and flower beds.
J
J1
5O-10O
K
4... maximum line length, press the button multiple times until the handle snaps back into the path of the trimmer.
8 Operation...in figure J3.
The trimmer can be
trimmed and remove any assembly, adjustments, or changing accessories.
off button (2), and squeeze the...
Instruction Manual - Page 9
...length of line whenever it's required. CLEARING JAMS AND TANGLED LINE (figures O, P, Q)
WARNING: Remove the battery from the right to operate at the operator. • Avoid trees and shrubs.
The...over the sidewalk or abrasive surface.
However, MAKE SURE that other abrasive surfaces or heavier weeds are designed to feed line or for best practices. • Wire and picket fences ...
Instruction Manual - Page 10
...065" AFS compatible accessories. Use BLACK+DECKER Model No. This line is fully
...remove the cap by depressing lugs and
pressing into spool housing.
10 In a few degrees left and right freely).
• Take care to time, especially when cutting thick or stalky
weeds... slack line
replacement accessories
through BLACK+DECKER service centers. adjustments or changing accessories. Such preventive...
Instruction Manual - Page 11
... in a plastic, sealable bag with a tablespoon of water. 3. REPLACING THE SPOOL • Remove battery from appliance. • Depress the tabs (21) and remove the
spool cap (22) from the spool housing (12) (figure O). • For best results, replace spool with BLACK+DECKER model # AF-100. • Grasp empty spool with one of the line anchoring...
Instruction Manual - Page 12
...and RELIABILITY, repairs, maintenance and adjustment should be replaced or repaired at ...Black+Decker Service Centers are missing, call 1-800-8-BATTERY. LATIN AMERICA: This warranty does not apply to recycle the battery (or battery pack) at the end of its useful life have any questions... relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
•...
Instruction Manual - Page 13
...8226; Remove the spool and check if the lever in Figure J1. If insufficient cutting line is , unwind the cutting line, then wind it just reaches the blade. Imported by Black & Decker (U.S.) ... a 10° angle as detailed in holding slots (figure S) before removing. Joppa Rd.
Solution
• Remove battery from the spool. If the automatic line feed still does not work...
Similar Questions
Handle Removal
I cannot figure how to remove the adjustable handle on a Black & decker cordless weed whip...mod...
I cannot figure how to remove the adjustable handle on a Black & decker cordless weed whip...mod...
(Posted by Lhardy52 1 year ago)
Do Have A Motor Housing For Black And Decker
Do you have a motor housing for a Black and Decker model no: LSTE252 part no: black and decker model...
Do you have a motor housing for a Black and Decker model no: LSTE252 part no: black and decker model...
(Posted by dlove002 1 year ago)
Motor O.e.m. #
Please give me the Black and decker O.E.M. part number on a motor for the LSTE525 LINE TRIMMER
Please give me the Black and decker O.E.M. part number on a motor for the LSTE525 LINE TRIMMER
(Posted by bluewing1947 1 year ago)
Se Puede Conseguir La Tarjeta Electrónica De Esta Lth34
(Posted by alvarezsonny100 2 years ago)
Can't Release The Collar To Adjust Height Or Convert To Edging Mode. (too Tight)
When first received, I was able to adjust the height by turning the collar. Worked fine; however, I ...
When first received, I was able to adjust the height by turning the collar. Worked fine; however, I ...
(Posted by jsnivley 9 years ago)