Black & Decker BEMW472BH Support Question
Black & Decker BEMW472BH Support Question
Find answers below for this question about Black & Decker BEMW472BH.Need a Black & Decker BEMW472BH manual? We have 1 online manual for this item!
Question posted by biggus13 on September 20th, 2022
Engine Runs But Rotary Cutting Blades Frozen
The person who posted this question about this Black & Decker product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by SonuKumar on September 20th, 2022 7:37 PM
SonuKumar
Member since:
May 9th, 2021 Points: 16,673,060
Member since:
May 9th, 2021 Points: 16,673,060
https://www.manualslib.com/manual/1869815/BlackPlusdecker-Bemw472bh.html?page=13#manual
follow all the troublshooting guide
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related Black & Decker BEMW472BH Manual Pages
Instruction Manual - Page 3
...: Indicates an imminently hazardous situation which, if not avoided, will degrade performance). • Make sure mowing area is locked into position. • For best cutting results, keep blade sharpened and balanced. • Inspect and thoroughly clean your risk of personal injury or property damage.
Read all safety warnings and all instructions.
NOTICE...
Instruction Manual - Page 4
... inspect mowing area before making any use, be thrown by mower blade can cause severe injury to use .
• Never leave a running mower unattended.
• Always release the ON/OFF switches 3 to stop the motor and wait until the blade comes to a complete stop rotating (approximately 3 seconds) before starting .
• Do not put...
Instruction Manual - Page 5
... extension cord receptacle, or extension cord plug in any adjustments or repairs with the motor running or while the mower is recommended when working condition. • Never tamper with safety ...will fit into the polarized wall outlet only one blade is intended.
• Ground Fault Circuit Interrupter (GFCI) protection should be used for the lawn mower. If the plug does not fit fully ...
Instruction Manual - Page 6
... not specified in loss of power and overheating. Check for which it repaired by the lawn mower blade can cause severe injuries to determine that are doing. Additional Safety Information
WARNING: ALWAYS use face or dust mask if cutting operation is damaged should be carefully checked to persons.
Watch what you are NOT...
Instruction Manual - Page 7
... removing/installing attachments or accessories. Intended Use This mower is , 16 gauge has more than 18 gauge. English DO NOT use this manual for homeowner lawn mowing applications. Before starting to assemble the grass bag to the frame as shown in loss of it from power source before making any part...
Instruction Manual - Page 9
...(100 cm) of the extension cord on and off 1. K. 6. The extension cord will run with the location of the appliance to the other , ensuring the extension cord is being held... on the lawn, close to reduce the risk of cut (Fig. Turn right, stepping over the extension cord and move towards position 3. Pull the height adjustment lever 5 away from the cutting blade. 8. Loop...
Instruction Manual - Page 10
...cable holders 6 provide a safe and convenient way to keep blade from turning as shown in Fig. Be careful of blade. 3. Cut a piece of wood 14 to store the extension cord when... cord around the cable holders in use the specified replacement blade: BEMW472BH and BEMW482BH release ON/OFF switches 2 to loosen and remove the blade bolt 15 by turning counterclockwise. 5. K
Emptying the grass...
Instruction Manual - Page 11
... of the tool. Check balance of blade. If your lawn has sandy soil, more frequent sharpening may weaken the plastic materials used in a vise 19 . 4. Remove blade from the insulator.
3.
See instructions for blade balancing.
7. Fig. S)
1. Make sure blade remains balanced. 2. Sharpen cutting edges on mower and tighten securely. To sharpen blade in Fig. Wear proper eye...
Instruction Manual - Page 12
...away from whom it was purchased (provided that the product is running. In order to obtain a better finish. This product is to... ON THE MOWER IN AN ATTEMPT TO CLEAN IT. All other garden chemicals contain agents which will be required. FREE WARNING LABEL REPLACEMENT... inches (10 cm), make two cuts to achieve optimum results, only mow dry grass. The Blade turns when the motor is used...
Instruction Manual - Page 13
... outlet. • Replace circuit fuse. (If the product
repeatedly causes the circuit fuse to cool and increase height of cut.
• Increase height of cut too low. • Cutting blade is damaged. • Grass too long. • Thermal cut out activated.
• Mower functions intermittenly.
• Mower leaves ragged finish or motor labors.
• Thermal...
Similar Questions
Too Much Oil On Blade
Why is the BCSP601 using so much oil and leaving the oil on the blade?
Why is the BCSP601 using so much oil and leaving the oil on the blade?
(Posted by dmrossi68 1 year ago)
B D Lsw36 Doesn't Run Battery Checks Good
my LSW36 doesn't run I checked battery on it companion weed eater and it works fine. I suspect the s...
my LSW36 doesn't run I checked battery on it companion weed eater and it works fine. I suspect the s...
(Posted by scottncarole 2 years ago)
Nst1118 Type 2 Oem Replacement Blade ?
The only replacement blade I can find is # 234805-00. The # 234805 has 3 holes and doesn't show up a...
The only replacement blade I can find is # 234805-00. The # 234805 has 3 holes and doesn't show up a...
(Posted by gbeaulieu28 8 years ago)
Motor Runs But Trimmer Cap Does Not Turn
How do I remove the trimmer cap to see if the gears are worn, and where can I get replacement gears?
How do I remove the trimmer cap to see if the gears are worn, and where can I get replacement gears?
(Posted by larrymwaldron 9 years ago)