Amana NTW4630YQ Support Question
Amana NTW4630YQ Support Question
Find answers below for this question about Amana NTW4630YQ.Need a Amana NTW4630YQ manual? We have 4 online manuals for this item!
Current Answers
Related Amana NTW4630YQ Manual Pages
Installation Instruction - Page 2
... elbow, hypro-blue steel couplings (2 pack)
Alternate parts: (Not supplied with flat washers
To order, please refer to 19⁄16" (39.5 mm)
Optional tools:
Flashlight
Bucket
Parts supplied:
... insert in a basement, laundry room, closet, or recessed area.
271/2"
27"
(648 mm) (686 mm)
42" (1067 mm)
2
Tools needed:
Parts needed: (Not supplied with washer)
Adjustable or open end ...
Installation Instruction - Page 3
...° C). Installing on all sides of laundry tub must support washer's total weight (with maximum slope of 1" (25 mm) on carpet is installed, top and bottom air openings in washer after use may be at least 39" (990 mm) above floor; n Floor must be purchased separately. Water remaining in door are minimum required. Add...
Installation Instruction - Page 4
...be provided. n Do not ground to within 4 ft (1.2 m) of its final location; Set washer upright. Remove shipping base. A time-delay fuse or circuit breaker is required. n To minimize...grounding plug. Remove shipping base
To avoid damaging floor, place cardboard supports from washer.
1. If your washer includes a sound shield, please refer to the instructions included with the sound ...
Installation Instruction - Page 5
... mm) of drain hose onto black drain port and secure with separate directions.
You may need to back of washer.
4.5" (113 mm)
Place hose into standpipe or lay on bottom of laundry tub. For a laundry tub or standpipe drain, go to remove all parts from tub. See "Tools and Parts".
6. Place drain hose...
Installation Instruction - Page 6
...
Turn on valve when attaching to washer correctly.
Check for cold water faucet. It will need additional parts with a red ring. Do not use a Y-adapter (not provided).
8. Repeat this step with cold water inlet valve. Connect inlet hoses to water faucets
Run water for a few seconds through hoses into a laundry tub, drainpipe, or bucket to check...
Installation Instruction - Page 7
... level, use a 9/16" or 14 mm open -end or adjustable wrench to prop washer with a wood block or similar object that will support weight of washer. Level Washer
IMPORTANT: Level washer properly to step 14.
12. Secure drain hose
Laundry Tub
Standpipe
Wall
14. Adjust leveling feet
Jam nut
Secure drain hose to raise the...
Installation Instruction - Page 8
q Remove protective film from back of washer. q Check that washer is an extra part, go back through steps to complete full cycle.
8...your tools. Select any tape
remaining on .
q Check that all parts are on washer. Start washer and allow to see what was skipped. q Check that water faucets are now installed. q Check that yellow shipping materials were completely
removed from ...
Use and Care - Page 3
....
Spray Rinse
Select cycles default to soak. WHAT'S NEW UNDER THE LID? When this time, a series of the cycle as the washer allows time for the lid to fill with water until the lid is closed, locked, and the sensing process is locked and cannot be opened . After a cycle is started , it...
Use and Care - Page 4
...while filling. Tightly packing can be opened . You may change at the correct time in the cycle.
RINSE
You will unlock once the washer movement has stopped.
If you may vary.
1 LOAD SIZE... that are available on the type of water for large or bulky loads. Fabric softener will be cooler than what your laundry load. NOTE: If the washer is locked and cannot be opened . ...
Use and Care - Page 6
... or water-resistant garments, load evenly.
■■ Use mesh garment bags to help avoid tangling when washing delicate or small items.
■■ Turn knits inside out to your laundry
2.....
IMPORTANT: Follow the manufacturer's instructions to use.
6 USING YOUR WASHER
1. Sort and prepare your garments.
Loose change, buttons, or any small object can pass under the agitator and ...
Use and Care - Page 7
...to ensure proper distribution at correct time in the same cycle with warm water until the washer has completed filling, press the START/Pause/Unlock Lid button to reduce tangling. ... again to YES. Select CYCLE
Turn cycle knob to reduce wrinkling and tangling.
4. Load laundry into washer. always follow manufacturer's directions for best cleaning and to choose your load size. Lift the...
Use and Care - Page 8
...help dissolve detergent.
Delay in soil removal and to the appropriate setting based on your previous washer provided. 7. Select options, if desired
Select the Load Size setting most amount of the... delayed for load unbalance. You will unlock once the washer movement has stopped. Wash Temperature
Hot
Some cold water is normal operation.
8 Suggested Fabrics
Whites and pastels Durable garments ...
Use and Care - Page 9
.... If your model has a dispenser drawer, however, remove the drawer and clean it will not freeze. Use only mild soaps or cleaners when cleaning external washer surfaces. If storing or moving , or not using your washer. WASHER MAINTENANCE
WATER INLET HOSES
Replace inlet hoses after you are home.
c. Do not place an affresh®...
Use and Care - Page 10
... load.
10 If you do not have packing tray, place heavy blankets or towels into washer basket.
7. Keep lid taped until washer is placed in washer or reconnect power.
3. Turn on both water faucets. Plug in new location. Run washer through the following
recommended procedure: To use , vacation, winter storage, or moving .
3. Refer to "Installation...
Use and Care - Page 11
... loaded as coins could fall between basket and tub or may block pump.
Both hot and cold water faucets must be turned on . Check for proper water supply. to drainpipe or laundry tub. See "Level the Washer" in washer drain system. Wash smaller loads to hear the pump making a continuous humming sound with the floor...
Use and Care - Page 12
... problems continue, contact an electrician. Add only 1 or 2 additional garments after washer has started.
Do not tape over drain opening.
Washer not draining/ spinning, loads are still wet or spin light remains on (indicating that the washer was unable to pump out water within 10 minutes)
Empty pockets and use an extension cord. Lower...
Use and Care - Page 13
... on . Check that inlet valve screens are not clogged.
Heavy sand, pet hair, lint, and detergent or bleach residues may be clogged.
This washer uses cooler wash and rinse water temperatures than those using a higher speed spin. Load not rinsed
Check for the fabrics being washed.
13 Sand, pet hair, lint, etc...
Use and Care - Page 15
... or workmanship and is reported to Whirlpool within 30 days from unauthorized modifications made to the appliance.
8.
WHIRLPOOL CORPORATION LAUNDRY WARRANTY
LIMITED WARRANTY
For one year from the date of purchase, when this major appliance is installed, operated, and...Factory Specified Replacement Parts and repair labor to repair or replace appliance light bulbs, air filters, or water filters.
Warranty - Page 1
...be easily determined. You can be found by checking the "Assistance or Service" section or by Whirlpool.
5. WHIRLPOOL CORPORATION LAUNDRY WARRANTY
LIMITED WARRANTY
For one year from the date of purchase, when this major appliance is installed, operated, and maintained ... Inglis, or Roper brands is inconsistent to repair or replace appliance light bulbs, air filters, or water filters.
Energy Guide - Page 1
U.S. Clothes Washer Capacity: Standard
Maytag Models: NTW4610Y*, NTW4630Y*,
NTW4650Y* Cat. V0Xq8EUA(3B)
Estimated Yearly Operating Cost
(when used with an electric water heater)
$50 ▼
$10
$71
Cost Range of Similar Models
470kWh
Estimated Yearly Electricity Use
$29
Estimated Yearly Operating Cost
(when used with a natural gas water heater)
Your cost will depend on...
Similar Questions
Fabric Softener Dispenser Not Working
My washing machine doesn't dispense fabric softener anymore. At the end of the wash cycle the dispen...
My washing machine doesn't dispense fabric softener anymore. At the end of the wash cycle the dispen...
(Posted by Tkessaram 2 years ago)
Ntw4630yq Fill Sensing Problem?
When starting cycle washing machine briefly starts filling with fill sensing light on then it tries ...
When starting cycle washing machine briefly starts filling with fill sensing light on then it tries ...
(Posted by abom311 7 years ago)
I Think I Need To Change The Belt On My Washer But Dont Know Where It Is
(Posted by kristibrook37 10 years ago)
New Amana Ntw4630yq Normal Cycle Sound Agitating Very Slow
New amana ntw4650yq. The lid locks so I can not see what is going on, but when cycle isWASH sounds e...
New amana ntw4650yq. The lid locks so I can not see what is going on, but when cycle isWASH sounds e...
(Posted by Anonymous-115342 10 years ago)
Filter Or Lint Trap?
Where is the filter or lint trap? How do I get to it.
Where is the filter or lint trap? How do I get to it.
(Posted by jlamf 12 years ago)