Amana NTW4630YQ Support Question
Amana NTW4630YQ Support Question
Find answers below for this question about Amana NTW4630YQ.Need a Amana NTW4630YQ manual? We have 4 online manuals for this item!
Question posted by Anonymous-115342 on July 3rd, 2013
New Amana Ntw4630yq Normal Cycle Sound Agitating Very Slow
New amana ntw4650yq. The lid locks so I can not see what is going on, but when cycle is WASH sounds extremely slow the agitation.. when it goes to RINSE.. seems that spin and rinse in portions.. never hear a lot of water for rinsing. unlocked lid a couple of time in RINSE and never saw enough water.. IS this normal?
PLEASE appreciate any comments , do not know if I need to return or exchange.. Thanks , VK
Current Answers
Related Amana NTW4630YQ Manual Pages
Installation Instruction - Page 2
... Kit Part Number 285835
LOCATION REQUIREMENTS
Select proper location for installation are in cardboard insert in the top of your washer to toll-free numbers on back page of your washer in a basement, laundry room, closet, or recessed area.
271/2"
27"
(648 mm) (686 mm)
42" (1067 mm)
2 To order, please refer to...
Installation Instruction - Page 3
...servicing, and spacing for companion appliances and clearances for ease of laundry tub must support washer's total weight (with spacing of washer. IMPORTANT: To avoid siphoning, no more space for walls, ...least 39" (990 mm) above floor; Add spacing of 1" (25 mm) on washer, and water pressure of wash tub. To order, please see toll-free phone numbers in your responsibility. install no...
Installation Instruction - Page 4
... location;
Remove shipping base
To avoid damaging floor, place cardboard supports from washer.
1. Tip washer back and place on floor behind washer. Set washer upright. n Check with the sound shield to avoid excessive noise from shipping carton on cardboard supports.
it and make sure lid is adequate. IMPORTANT: Removing shipping base is recommended. It is recommended...
Installation Instruction - Page 5
3. Remove packing tray from tray. For a laundry tub or standpipe drain, go to drain port
Remove tape from washer lid, open lid and remove cardboard packing tray from rear panel. See "Tools and Parts".
6. Place drain hose in case you need additional parts with pliers and slide ...
Installation Instruction - Page 6
...through hoses into a laundry tub, drainpipe, or bucket to hot water faucet. Do not use old hoses. Screw on water faucets to hot water inlet valve marked with flat washers (not provided).
n ... use tape or sealants on washer.
Connect Inlet Hoses
Washer must be connected to water faucets with new inlet hoses with a red ring. Connect inlet hoses to washer
Attach hose to prevent clogs....
Installation Instruction - Page 8
...into washer basket or detergent dispenser (on washer.
Close lid. Start washer and allow to see what was skipped. Plug into a grounded 3 prong outlet. q Check that you have all of washer.... test and clean your washer, measure 1/2 of normal
recommended amount of /recycle all parts are on.
q Check that washer is an extra part, go back through steps to complete full cycle.
8 16. q ...
Use and Care - Page 3
... that are different from those of the cycle as the agitator tests for the lid to penetrate clothes. There will hear water enter the washer as the washer allows time for higher spin speeds, the lid will lock and the Lid Locked light will perform a series of the wash cycle, you must be opened . Spray Rinse
Select cycles default to check for details.
IMPORTANT: ■...
Use and Care - Page 4
... your previous washer provided.
■■ Even in the cycle.
You may change at increasing speeds for higher spin speeds, the lid will lock and the Lid Locked light will hear the agitator moving the load. When this light is paused. When this light will continue to most cycles and must be opened .
Select a wash temperature based on your laundry load. Turn...
Use and Care - Page 5
... Light
Handwash
Rinse/ Spin
Drain/ Spin
Wash Temperature*:
Hot Warm Cool Cold
Hot Warm Cool Cold
Hot Warm Cool Cold
Spin Speed:
Low
Cycle Details:
Use this cycle for heavy
fabrics or special-care items washed by hand. This cycle features a spray rinse. High Use this cycle to wash loads of the washer.
This cycle features a spray rinse. See Washer Care. This cycle features a spray...
Use and Care - Page 6
... color-safe bleach laundry boost product, add to avoid pilling.
Synthetics, knits, and corduroy fabrics will pick up lint from sturdy fabrics.
■■ Do not dry garments if stains remain after washing, because heat can pass under the agitator and become trapped, causing unexpected sounds.
■■ Sort garments by recommended cycle, water temperature...
Use and Care - Page 7
.... Load laundry into the basket or on some models)
Load garments in the same cycle with warm water until the washer has completed filling, press the START/Pause/Unlock Lid button to dispenser
(on load. Do not use color-safe bleach or Oxi products in loose heaps evenly around the agitator; Lift the lid and add...
Use and Care - Page 8
... Filling is normal operation.
8
When the cycle has finished, the CYCLE COMPLETE indicator will be sure to set the Fabric Softener option knob to the appropriate setting based on your garments.
You will pump out automatically. Select WASH TEMPERATURE
If you are cold. All rinses are using fabric softener, be cooler than your previous washer provided...
Use and Care - Page 9
... or liquid chlorine bleach as described below .
Close the washer lid. After the cycle has stopped, run
washer on the label with a damp cloth and towel dry. NON-USE AND VACATION CARE
Operate your washer for cleaning the inside of replacement on RINSE/SPIN cycle for cleaning the inside of odor-causing residue. Shut off water supply to...
Use and Care - Page 10
... from original shipping materials back inside washer basket.
6. Disconnect drain hose from back of detergent for a medium-size load.
10 Reconnect water inlet hoses. Plug in new location. REINSTALLING/USING WASHER AGAIN
To reinstall washer after non-use washer again: 1. Drape power cord over lid and down front of washer. TRANSPORTING YOUR WASHER
1. Disconnect and drain water inlet...
Use and Care - Page 11
... or poly-filled jackets.
Sensing spins will reduce sound. Washer may block pump. Humming
Fill light is normal. TROUBLESHOOTING
First try the solutions suggested here or visit our website at www.amana.com/help for assistance and to the washer. Loose items such as expected
Washer won't run or fill, washer stops working or wash light remains on . Water...
Use and Care - Page 12
... to determine if load is power to slow or extra suds, select Rinse/Spin. The washer may hear the hum of cycle. Cycles with lower spin speeds remove less water than normal. Tightly packed or unbalanced loads may be tightly packed or unbalanced.
Do not interrupt cycle.
Washer not draining/ spinning, loads are still wet or spin light remains on (indicating that the...
Use and Care - Page 13
... .
Washer is less efficient at rinsing when load is normal.
Make sure hot and cold inlet hoses are not reversed.
Load with a slower wash action and spin speed; Load garments in loose heaps evenly around the basket wall.
Load not rinsed
Check for the fabrics being washed.
Choose a Load Size that matches the load being washed.
Select the Rinse/Spin cycle...
Use and Care - Page 14
... directly onto load.
Lid Locked light is flashing
The lid is complete to match your load with the best cycle. This may still be spinning. If you experience
Possible Causes
Washer not performing as expected (cont.)
Solution
Not cleaning or removing stains (cont.)
Using too much detergent.
Use Normal Heavy cycle for the fabrics being washed.
Incorrect dispenser operation...
Use and Care - Page 15
...durability, or need it is located in your authorized Whirlpool, Amana, Admiral, Estate, Inglis, or Roper dealer to determine ...to correct defects in a manner that have other than normal, single-family household use your major appliance if it...
This limited warranty does not cover:
1.
WHIRLPOOL CORPORATION LAUNDRY WARRANTY
LIMITED WARRANTY
For one year from unauthorized modifications made...
Warranty - Page 1
... by Whirlpool to service Amana, Admiral, Estate, Inglis, or Roper brands is required to obtain service under these limitations and exclusions may have other than normal, single-family household use...should ask Whirlpool or your major appliance is located in -warranty service. WHIRLPOOL CORPORATION LAUNDRY WARRANTY
LIMITED WARRANTY
For one year from the date of purchase, when this major ...
Similar Questions
Ntw4630yq Fill Sensing Problem?
When starting cycle washing machine briefly starts filling with fill sensing light on then it tries ...
When starting cycle washing machine briefly starts filling with fill sensing light on then it tries ...
(Posted by abom311 7 years ago)
Slow Agitation, Clothes Not Clean
new washer purchased in october does not seem to be washing clothes clean
new washer purchased in october does not seem to be washing clothes clean
(Posted by farmershardware 10 years ago)
Rough Noise
During the wash cycle, when agitating it sounds real rough, kinda gravely. Is this normal?
During the wash cycle, when agitating it sounds real rough, kinda gravely. Is this normal?
(Posted by sandymm57 11 years ago)
Clicking Noise/spin Cycle
I noticed a clicking noise coming from my Amana NFW7300WW front load washer today. I stopped it and ...
I noticed a clicking noise coming from my Amana NFW7300WW front load washer today. I stopped it and ...
(Posted by jcsurfer81 12 years ago)