Amana NTW4501XQ Support Question
Amana NTW4501XQ Support Question
Find answers below for this question about Amana NTW4501XQ.Need a Amana NTW4501XQ manual? We have 4 online manuals for this item!
Question posted by mcmillankelly80 on November 23rd, 2015
Amana Washer Ntw4501xq0
My washer quits agitating after 10 to 15 seconds, what is failing? sometimes restarting the machine it will agitate again.
Current Answers
Answer #1: Posted by Odin on November 23rd, 2015 11:45 AM
Odin
Member since:
April 10th, 2010 Points: 41,236,690
Member since:
April 10th, 2010 Points: 41,236,690
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Amana NTW4501XQ Manual Pages
Use and Care - Page 2
WASHER SAFETY
2
Use and Care - Page 3
...process is started , it may hear nothing at all as the agitator tests for the lid to enter the basket. Your new washer will be selected to ensure fabric softener dispenses at the beginning of...signal that are different from those of the wash cycle, you try to pause, it may take several seconds to several minutes for the lid to a spray rinse. This delay in the cycle you may hear a...
Use and Care - Page 4
...the cycle and unlock the lid. You will hear a click, and the lid will hear the agitator moving the load. This is determined by regulating incoming hot and cold water. RINSE You will first...the Lid Locked light will be cooler than what your laundry load. Press and hold for 3 seconds to ON. When this light will unlock once the washer movement has stopped.
The lid will come on . ...
Use and Care - Page 5
... load being washed. Also use for loads requiring an additional rinse cycle or to drain washer after cancelling a cycle or completing a cycle after power interruption.
Low Use this cycle ..., linens, synthetics
Lightly soiled no-iron fabrics, cottons, perm press, linens, synthetics
Machine-wash silks, lingerie, washable wools
Swimsuits and items requiring rinsing without detergent
Dripping wet ...
Use and Care - Page 6
... well. Add a measured amount of the washer basket before adding clothes. Separate lint-takers from towels, rugs, and chenille fabrics. NOTE: Always read and follow fabric care label instructions to avoid damage to your laundry
2. Loose change, buttons, or any small object can pass under the agitator and become trapped, causing unexpected sounds...
Use and Care - Page 7
... freely for correct amount of the rim. Items need to dispenser
(on load. Then set to ON to ON. Load laundry into washer.
IMPORTANT: Fabric Softener option knob must be set Fabric Softener option knob to ensure proper distribution of the fabric softener during ...
to spill, splash, drip, or run into dispenser; Do not wrap large items such as sheets around the agitator;
Use and Care - Page 8
...several minutes while load balance is delayed for more than 10 minutes, the water will be cooler than what your tap...energy. If your previous washer provided. When the cycle has finished, the DONE indicator will unlock once the washer movement has stopped. Delay... is sensed. Promptly remove garments after cycle has completed to restart the cycle. Unlocking the lid to add garments
If you ...
Use and Care - Page 9
... label with a clean, damp cloth. IMPORTANT: To avoid damaging the washer's finish, do not interrupt cycle. Use a soft, damp cloth or sponge to water pressure surge. When replacing your washer for 3 seconds to liquid chlorine bleach dispenser. Unplug or disconnect power to washer.
2. WASHER MAINTENANCE
WATER INLET HOSES
Replace inlet hoses after 5 years of use...
Use and Care - Page 10
...washer or reconnect power.
3. Adding wet garments to washer or adding more water to operate properly. Wash smaller loads to locate, level, and connect washer.
2.
Tighten fill-hose connection.
10 REINSTALLING/USING WASHER AGAIN
To reinstall washer... on. http://www.amana.com/help
If you have started the washer. Front and rear feet must be in washer drain system.
Do not...
Use and Care - Page 11
...
First try the solutions suggested here or visit our website to drainpipe or laundry tub. http://www.amana.com/help
If you experience
Possible Causes
Washer not performing as recommended. Make sure all
for loading instructions. Pull drain hose from washer cabinet and properly secure it to possibly avoid the cost of alignment and...
Use and Care - Page 12
... not tape over drain opening. Dry spots on (indicating that the washer was unable to pump out water within 10 minutes)
Empty pockets and use garment bags for small items. Use...can keep washer from operating correctly.
http://www.amana.com/help
If you experience
Possible Causes
Washer not performing as expected (cont.)
Washer not draining/ spinning, loads are not reversed. The washer may ...
Use and Care - Page 13
....
This may still be spinning. http://www.amana.com/help
If you experience
Possible causes
Solution
Washer not performing as expected (cont.)
Not cleaning or removing stains
Washer not loaded as recommended.
Sharp items were in "Washer Maintenance". Items may not have tangled. Fabric damage can keep washer from too much detergent. Empty pockets, zip...
Energy Guide - Page 1
.... V0Xq8EUA(3B)
Estimated Yearly Operating Cost
(when used with an electric water heater)
$50 ▼
$10
$71
Cost Range of Similar Models
470kWh
Estimated Yearly Electricity Use
$29
Estimated Yearly Operating Cost
(when used...loads a week and a 2007
national average electricity cost of 10.65 cents per therm.
• For more information, visit www.ftc.gov/appliances. (P/N W10062972) Clothes...
Installation Instruction - Page 2
... proper location for installation are in cardboard insert in a basement, laundry room, closet, or recessed area.
271/2"
27"
(648 mm) ...washer)
Your installation may require additional parts.
Install your washer in the top of your washer to toll-free phone numbers on back page of the washer. n 8212656RP n 8212641RP n 8212646RP n 8212545RP
n 8212487RP n 8212638RP
n 8212637RP
10...
Installation Instruction - Page 3
..., top and bottom air openings in your responsibility.
n A grounded electrical outlet located within 3 ft (0.9 m) of laundry tub must support washer's total weight (with beaded tie strap.
3 Floor standpipe drain system
IMPORTANT: Do not install, store, or operate washer where it will be exposed to weather or in .2 (155 cm2)
1" (25 mm)
1" (25 mm...
Installation Instruction - Page 4
... cardboard before moving it is recommended that a qualified electrician determine that a separate circuit breaker serving only this time.
4 Move washer
n A 120 volt, 60 Hz., AC only, 15- A time-delay fuse or circuit breaker is required. It is recommended that the ground path is adequate. n To minimize possible shock hazard, the cord must...
Installation Instruction - Page 5
... to step 6. Free power cord
If clamp is not already in Step 7. IMPORTANT: 4.5" (113 mm) of drain hose should be used.
5 For a laundry tub or standpipe drain, go to drain port
Remove tape from washer lid, open lid and remove cardboard packing tray from tub
Connect Drain Hose
5. See "Tools and Parts".
6.
Installation Instruction - Page 6
...You may enter washer. Do not use a Y-adapter (not provided).
8. Connect inlet hoses to prevent clogs. Screw on water faucets to check for a few seconds through hoses into a laundry tub, drainpipe, ... additional two-thirds turn .
Screw coupling by hand until clear.
10.
Connect inlet hoses to washer
Attach hose to hot water inlet valve marked with separate directions. ...
Installation Instruction - Page 7
... 4" (102 mm) with floor. HELPFUL TIP: You may want to check levelness of washer. Check levelness of washer.
15. Not Level
LEVEL
Not Level
7
Secure drain hose
Laundry Tub
Standpipe
Wall
14. HELPFUL TIP: You may want to raise the washer. When washer is level, skip to make sure all four feet make solid contact with...
Installation Instruction - Page 8
... method. q Check that you have all of powdered or liquid detergent and pour it into washer basket or detergent dispenser (on washer. q Remove protective film from back of /recycle all parts are on. q Dispose of washer. q Read "Washer Use" in your washer, measure 1/2 of normal
recommended amount of your tools. q To test and clean your...
Similar Questions
It Will Not Unlock When It Is Done
the washer will not unlock when it is done
the washer will not unlock when it is done
(Posted by kathiestevenson 8 years ago)
System Timer
I had the clog fixed on my Machine now it will spin and drain, But the problem now is that every cyc...
I had the clog fixed on my Machine now it will spin and drain, But the problem now is that every cyc...
(Posted by lesap99 9 years ago)
Lid Switch Location
Where is the lid switch located on the Amana NTW4501XQ
Where is the lid switch located on the Amana NTW4501XQ
(Posted by Crosbywarren 10 years ago)
Amana Ntw4601xq Trouble Shooting Our Washer Quit Agitating.
hello. our washer quit agitating. everything else seems to be working fine
hello. our washer quit agitating. everything else seems to be working fine
(Posted by shelly1858 10 years ago)
