Amana NED4600YQ Support Question
Amana NED4600YQ Support Question
Find answers below for this question about Amana NED4600YQ.Need a Amana NED4600YQ manual? We have 3 online manuals for this item!
Question posted by amjadjabai on August 1st, 2021
Dryer
What's the length, width and depth of the NED4600YQ1 dryer?
Current Answers
Answer #1: Posted by SonuKumar on August 1st, 2021 8:30 AM
SonuKumar
Member since:
May 9th, 2021 Points: 16,638,180
Member since:
May 9th, 2021 Points: 16,638,180
Width: 29"
Depth: 28 1/2"
Height: 42 1/2"
Cycles: 11
Stackable: No
Steam Cycle: No
https://www.designerappliances.com/amana-ned4600yq.html
https://www.manualslib.com/products/Amana-Ned4600yq-134246.html
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Answer #2: Posted by rh540640 on August 1st, 2021 9:55 AM
rh540640
Member since:
July 21st, 2021 Points: 201,610
Member since:
July 21st, 2021 Points: 201,610
Overall Width:
29"
Overall Depth:28 1/2"
Overall Height:42 1/2"
Gross Weight:117 Lbs.
Kindly accept my answer, if you are satisfied with it. Contact me
Related Amana NED4600YQ Manual Pages
Use and Care - Page 2
DRYER SAFETY
2
Use and Care - Page 4
..., regardless of who installed the dryer.
■■ Use the shortest length of the vent system at least every 2 years. Good air flow
Along with your dryer for the occasional damp load that...ENERGY SAVINGS
Use the Automatic Dry cycles to efficiently dry laundry. This sensing occurs throughout the drying cycle and the dryer shuts off when the load reaches the selected dryness.
During...
Use and Care - Page 5
...
1
2
3
1
3
Not all models. Turn the knob to start the dryer.
5 If you may vary.
1 DRYER CYCLE KNOB
Use your dryer model. Gives the best drying in the load or air temperature and shuts off when... a selectable temperature knob, you are available on your laundry load. Appearance may choose a setting based on your Dryer Cycle Knob to select the desired setting (On or Off).
Use and Care - Page 6
... bonded or laminated fabrics. N/A
No heat drying.
If you are available on the fabrics in your dryer has multiple heat settings:
■■ A High temperature setting may be used for drying medium-weight...Dry Energy Preferred
Less Dry
High Medium
Low
Automatic cycles give the best drying in
the dryer too long. CYCLE GUIDE -
If loads seem drier than the higher setting.
Setting ...
Use and Care - Page 7
... PREFERRED, or Less Dry automatically adjusts the dryness level at which the dryer will shut off the screen with a damp cloth to remove dust from storing and shipping.
1. Do... not tightly pack the dryer;
Once a dry level is set, it cannot be able to remove lint. Place laundry in the shortest time. Some models have a different door than the...
Use and Care - Page 8
4. NOTE: Not all options and settings are not harmful to your fingers. Select End of the dryer.
This includes clearing piles of laundry in the dryer.
A screen blocked by turning the knob to begin the cycle. Roll lint off the
screen with all cycles.
5. Push the lint screen firmly back into ...
Use and Care - Page 9
.... 4.
Locate the light bulb cover on vacation or not using your dryer for your clothes, or cause the dryer to stop before your dryer only when you should: 1. Turn bulb counterclockwise. Plug into place. See "Venting Requirements." As needed cleaning Laundry detergent and fabric softener residue can cause overheating and damage to gas supply...
Use and Care - Page 10
...length. Door not closed completely. Wrong type of the dryer.
Supply line valve not open on the supply line. Select the right cycle for 5-10 minutes. Make sure vent is closed completely. Use 4" (102 mm) diameter vent material.
Make sure the dryer...heavy metal or flexible metal vent.
Electric dryers use it only once. Electric dryers use . PUSH to tumble freely.
Use...
Use and Care - Page 11
...Lint screen clogged. Dryer tightly packed. Level the dryer. All cycles are gone from the area, rewash and dry the clothing. Laundry items removed from the dryer before removing laundry from forming.
Lint... odor will not transfer to a partially dried load can tumble freely reduce wrinkles from dryer. Select a lower temperature, and use an automatic drying cycle. When the odors or...
Installation Instruction - Page 2
... and parts before starting installation. Always read and obey all safety messages. All safety messages will follow the instructions provided with any tools listed here.
DRYER SAFETY
Your safety and the safety of injury, and tell you what can kill or hurt you and others are not followed. All safety messages...
Installation Instruction - Page 3
.... For further information, please reference the "Assistance or Service" section of 200 lbs. (90.7 kg). Some codes limit, or do not permit, installation of the dryer in dryer drum.
The kit should also be considered.
■■ Level floor with upturned ends.
■■ A UL listed strain relief. 1/4" nut driver (recommended)
Vent...
Installation Instruction - Page 4
...B. Connect to the neutral wire, see "Optional 3-wire connection" section.
■■ This dryer is adequate. Electrical Connection
To properly install your responsibility:
■■ To contact a qualified ...with vents
*Additional spacing recommended
3"* (76 mm)
Electrical Requirements
It is your dryer, you will be obtained from the external ground connector screw (green screw), ...
Installation Instruction - Page 5
... must match power supply (4-wire or 3-wire) and be at least 4 ft. (1.22 m) long.
Prepare dryer for leveling legs
To avoid damaging floor, use aluminum).
■■ At least 5 ft. (1.52 m) ... looks like this :
3-wire receptacle (10-30R)
Then choose a 3-wire power supply cord with clothes dryers. The 4-wire power supply cord, at least 4 ft. (1.22 m) long, must end in leveling legs...
Installation Instruction - Page 7
... screws at this page. For 3-wire Power Supply Cord Connection, see page 8.
Power Supply Cord Connection
Power supply cord strain relief
1. Spade terminals with the dryer cabinet and be in place. Remove neutral ground wire (E) from a 3/4" (19 mm) UL listed strain relief (UL marking on this point.
Put the tabs of...
Installation Instruction - Page 8
... cord to external ground conductor screw (A). Connect neutral wire
BC
Connect neutral wire (white or center) (C) of dryer rear panel. Tighten screws. Now, go to Venting Requirements.
8 B
D
E
A
C
GF
A. 3-wire... 5. Connect ground wire
A
F Connect ground wire (F) (green or bare) of dryer rear panel. Connect remaining wires
3-wire Power Supply Cord Connection
Use where local codes ...
Installation Instruction - Page 9
... threaded section of extra length so dryer may be in a horizontal position. Attach direct wire cable
to terminal block, place hooked end of wires into hooks.
4. Strip insulation back 1" (25 mm).
To connect wires to strain relief
(127
5" mm)
Direct wire cable must have a tight fit with the dryer cabinet and be moved...
Installation Instruction - Page 10
...together and tighten screw.
5. Strip 31/2" (89 mm) of outer covering from end of extra length so dryer may be moved if needed. Prepare your 3-wire cable for
direct connection
(251"mm)
E
...wire (E) and place hooked end (hook facing right) of neutral wire (white or center wire) (C) of dryer rear panel. Strip insulation back 1" (25 mm). Finally, reinsert tab of wire under terminal block screw, ...
Installation Instruction - Page 12
...Requirements
WARNING
VENTING
Exhaust hoods:
■■ Must be at least 12" (305 mm) from entire length of a building. Failure to avoid
crushing and kinking.
Angled hood
Elbows: ■■ 45°... Only rigid or flexible metal vent shall be connected into interior of fire, this dryer MUST BE
EXHAUSTED OUTDOORS. Improper venting can result in death or fire.
Replace plastic ...
Installation Instruction - Page 13
... venting clamps - 2 pack
8212662
Flush mounting louvered vent hood 4"
13
Plan Vent System
Recommended exhaust installations Typical installations vent the dryer from the rear of the dryer. Wall D. Vent length necessary to the manufacturer's instructions. Part Number Descriptions
8171587RP 0-5" Metal vent periscope
4396037RP 0"-18" Metal vent periscope
4396011RP 18" - 29" Metal vent...
Installation Instruction - Page 14
...° turns. NOTE: Do not use .
Secure vent to seal all joints. Run vent to dryer location using elbows or making turns, allow as much room
as possible. ■■ Bend vent ...to avoid kinking. ■■ Use as few 90° turns as possible. Determine vent length and elbows needed for mobile home installations:
The exhaust vent must be securely fastened to a noncombustible ...
Similar Questions
Amana Dryer Model Ned4600yq1 Heat Problem
My Amana gas dryer model NED4600YQ1 overheats during drying. The cabinet becomes too hot to touch co...
My Amana gas dryer model NED4600YQ1 overheats during drying. The cabinet becomes too hot to touch co...
(Posted by Rlfitzgibbon 8 years ago)
Why Is My Amana Ned4600yq1 Dryer Getting Too Hot?
After a few minutes drying the dryer starts smelling hot and it is really hot and is even getting th...
After a few minutes drying the dryer starts smelling hot and it is really hot and is even getting th...
(Posted by jsmh9198 8 years ago)
Dryer Is Not Working
My Amana Dryer wont shut off it runs constantantly and wont heat either. What do I need to check and...
My Amana Dryer wont shut off it runs constantantly and wont heat either. What do I need to check and...
(Posted by kmlvsuper 11 years ago)
Converting Dryer
I have an Amana dryer that is set up for propane can it be converted to natural gas.
I have an Amana dryer that is set up for propane can it be converted to natural gas.
(Posted by debijoan 12 years ago)