Amana NGD7300WW Support Question
Amana NGD7300WW Support Question
Find answers below for this question about Amana NGD7300WW.Need a Amana NGD7300WW manual? We have 4 online manuals for this item!
Question posted by debijoan on February 19th, 2012
Converting Dryer
I have an Amana dryer that is set up for propane can it be converted to natural gas.
Current Answers
Related Amana NGD7300WW Manual Pages
Use and Care - Page 2
DRYER SAFETY
Your safety and the safety of injury, and tell you what the potential hazard is the safety alert symbol. This symbol alerts you to ...
Use and Care - Page 3
....
- For more information, contact your gas supplier from a neighbor's phone. If a gas leak is detected, follow the "What...GAS:
• Do not try to prevent property damage, personal injury, or death.
- WARNING: Gas leaks cannot always be electrically grounded in accordance with local codes, or in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70. The dryer...
Use and Care - Page 4
... ever had any type of oil on it shall be a T-handle type. ■ A flexible gas connector, when used, must not exceed 3 feet. Do not dry anything flammable on it (including ...licensed by using a ball valve, it (even after washing). For a summary of how to use your dryer following installation instructions apply:
■ Installations and repairs must be dried on the next page.
4
Fire...
Use and Care - Page 5
... door or press START/PAUSE once. USING AUTO DRY CYCLES
Auto Dry Cycles automatically match the cycle setting to the type of fire electric shock, or injury to set a drying time and temperature.
Place laundry in the dryer. USING TIMED DRY CYCLES
Use Timed Dry cycles to persons, read the IMPORTANT SAFETY INSTRUCTIONS before...
Use and Care - Page 6
... not be dried using the Air Only setting. Changing Cycles after starting dryer 1. Changing Drying Temperature You can be accepted. See the following AUTO DRY Preset Cycle Settings chart. NOTE: AUTO DRY Cycles are available on the dryer. 3. This ends the current cycle and
turns the dryer OFF. 2. The dryer starts at any time before or...
Use and Care - Page 7
... dry lint screen with hot water and liquid detergent. Make a paste with a damp cloth. 4. Wipe drum thoroughly with powdered laundry detergent and very
warm water. 2. Removing Accumulated Lint
From Inside the Dryer Cabinet Lint should be removed every 2 years, or more frequently, if it becomes clogged due to remove residue buildup. Unplug...
Use and Care - Page 8
...Replace the bulb with the screw.
4. For additional recommendations, refer to vibrate. Dryer Operation
Dryer will bounce, causing the dryer to your Installation Instructions. See the Installation Instructions.
■ Is the clothing ... balled up? When balled up, the load will not run
■ Is the dryer door firmly closed?
■ Was the START/PAUSE button firmly pressed? Large loads ...
Use and Care - Page 9
... length.
■ Is the exhaust vent diameter the correct size? Use 4" (102 mm) diameter vent material.
■ Is the dryer located in a room with heavy metal or flexible metal vent.
The drying setting you recently been painting, staining, or varnishing in clothing (usually blue jeans). Long venting will be displayed. 2. Level the...
Dimension Guide - Page 1
... pipe is used . gas must be used it should be converted to the chart. Louvered hood B.
Gas Dryer
PRODUCT MODEL NUMBERS NGD7300W
Gas supply: This dryer is equipped for planning purposes... are recommended. Use the fewest 90° turns possible. Do not use with Natural gas. Water (Steam models only): The dryer must be connected to the coupling can be used. Number of 90o turns or ...
Installation Instruction - Page 2
... of others .
This is , tell you how to potential hazards that can happen if the instructions are very important.
All safety messages will follow instructions. DRYER SAFETY
Your safety and the safety of injury, and tell you what the potential hazard is the safety alert symbol.
This symbol alerts you don...
Installation Instruction - Page 3
... local codes, or in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1/NFPA 54 or the Canadian Natural Gas and Propane Installation Code, CSA B149.1.
Gas suppliers recommend that you use a gas detector approved by smell.
The dryer must be electrically grounded in accordance with local codes, or in the absence of...
Installation Instruction - Page 4
.... Some codes limit, or do not use leveling legs. Parts needed: (Not supplied with dryer) Refer to 1" (25 mm) or hex-head socket wrench
4
Caulking gun and compound ... REQUIREMENTS
TOOLS AND PARTS
Tools needed for gas connections)
Wire stripper (direct wire installations)
Tin snips (new vent installations)
Pipe-joint compound resistant to LP gas
Parts supplied (all models):
1/4" nut...
Installation Instruction - Page 5
... . If a closet door or louvered door is greater than 1" (25 mm), install Extended Dryer Feet Kit, Part Number 279810. spacing for companion appliances and clearances for ease of installation and...provided.
■■ 20-100 psi (138-690 kPa) for proper exhaust installation. LOCATION REQUIREMENTS
DRYER DIMENSIONS Front view:
27" (686 mm)
35 3/8"
(899 mm)
You will need :
■...
Installation Instruction - Page 6
...with a door, minimum ventilation openings in the top and bottom of 5" (127 mm) clearance behind dryer for wall, door, and floor moldings.
■■ Additional spacing should also be considered.
4" (...)
1" (25 mm)
18" (460 mm)
1" (25 mm)
6 Back view:
61/4"
(159 mm)
Closet installation (dryer only):
Electric
281/8"
(715 mm)
31/2"
(89 mm)
34" recommended (864 mm)
18" min. (457 mm)
...
Installation Instruction - Page 7
... electrical supply on a separate 30-amp circuit, fused on both sides of the line. Additional installation requirements: This dryer is available to do so can result in your "Use and Care Guide".
For gas dryers mobile home installations:
■■ Mobile Home Installation Hold-down Kit Part Number 346764 is suitable for undercounter...
Installation Instruction - Page 8
...propane or butane) gases with appropriate conversion.
■■ Your dryer must be plugged into a grounded 3 prong outlet.
SAVE THESE INSTRUCTIONS
GAS DRYER POWER HOOKUP
ELECTRICAL REQUIREMENTS
WARNING
GAS...; For a grounded, cord-connected dryer: This dryer must be grounded. Do not remove ground prong. GAS TYPE Natural Gas:
This dryer is properly installed and grounded in ...
Installation Instruction - Page 9
... height must be made by a qualified technician. DRYER GAS PIPE ■■ The gas pipe that resist the action of the dryer in accordance with the B149.1, Natural Gas and Propane Installation Code. The location should use larger tubing and a different size adapter fitting.
■■ If your dryer has been converted to use TEFLON®† tape.
■...
Installation Instruction - Page 10
...and Care Guide".
NOTE: If using an existing vent system, clean lint from ground or any gas vent, chimney, wall, ceiling, attic, crawlspace, or a concealed space of the system and ...a 4" (102 mm) heavy metal exhaust vent and clamps may be connected into interior of fire, this dryer MUST BE
EXHAUSTED OUTDOORS. Do not use plastic or metal foil vent.
Recommended Styles:
Fire Hazard Use a...
Installation Instruction - Page 11
... -clearance installations are possible. Plan Vent System
Recommended exhaust installations Typical installations vent the dryer from the rear of mobile home and must contact your installation. Do not use ...or through bottom. Select the type best for mobile homes:
Exhaust vent must be converted to have dryer converted. You must not terminate beneath the mobile home. Do not use a metal ...
Installation Instruction - Page 12
...1. The Vent System Chart provides venting requirements that will :
■■ Shorten life of dryer.
■■ Reduce performance, resulting in longer drying times and increased energy usage. Use clamps... 64 ft. (20 m) 58 ft. (17.7 m)
2. Secure vent to move and install dryer. Avoid 90° turns.
Install Leveling Legs
WARNING
Excessive Weight Hazard Use two or more people to...
Similar Questions
Why Is My Amana Ned4600yq1 Dryer Getting Too Hot?
After a few minutes drying the dryer starts smelling hot and it is really hot and is even getting th...
After a few minutes drying the dryer starts smelling hot and it is really hot and is even getting th...
(Posted by jsmh9198 8 years ago)
We Have An Amana Natural Gas Clothes Drier. It Is Not Heating.
Have an Amana Natural Gas Dryer, Model LG8319W2 Tring to figure out why it is not heating.
Have an Amana Natural Gas Dryer, Model LG8319W2 Tring to figure out why it is not heating.
(Posted by pbshank 10 years ago)
How Do I Check The Wiring Plugs On My Ngd4500vqo Gas Dryer?
the pilot lights, the gas works, but no flame
the pilot lights, the gas works, but no flame
(Posted by jeffgaul 11 years ago)
Lp Conversion Kit
If I need to convert this gas dryer to a LP, what is the piece number for this LP conversion kit?
If I need to convert this gas dryer to a LP, what is the piece number for this LP conversion kit?
(Posted by casper2z 11 years ago)
