Amana NED7300WW Support Question
Amana NED7300WW Support Question
Find answers below for this question about Amana NED7300WW.Need a Amana NED7300WW manual? We have 4 online manuals for this item!
Question posted by pbshank on March 11th, 2014
We Have An Amana Natural Gas Clothes Drier. It Is Not Heating.
Have an Amana Natural Gas Dryer, Model LG8319W2 Tring to figure out why it is not heating.
Current Answers
Related Amana NED7300WW Manual Pages
Use and Care - Page 2
DRYER SAFETY
Your safety and the safety of injury, and tell you what the potential hazard is the safety alert symbol.
This symbol alerts you to ...
Use and Care - Page 3
... any phone in your building. • Clear the room, building, or area of all occupants. • Immediately call the fire department.
- Gas suppliers recommend that you smell gas" instructions.
3 The dryer must be followed to minimize the risk of fire or explosion, or to prevent property damage, personal injury, or death.
- Installation and...
Use and Care - Page 4
...vapors, such as gasoline, away from dryer.
Failure to follow these instructions can result in death or fire.
Failure to use your dryer following installation instructions apply:
■ ...
Items containing foam, rubber, or plastic must be a T-handle type. ■ A flexible gas connector, when used, must be performed by a qualified or licensed contractor, plumber, or gasfitter ...
Use and Care - Page 5
...injury to begin . Press the TEMP button until dryer starts.
5
This Use and Care Guide covers several different models. Shut the door. Your dryer may select or deselect the CYCLE SIGNAL feature at ... more detail on each cycle. Open the door or press START/PAUSE once. Place laundry in the dryer. Press POWER or press the cycle selector button.
Press POWER. Close the door and...
Use and Care - Page 6
...dryer starts at any time before pressing START/PAUSE. ■ Three short tones sound if an unavailable combination is High. The default drying temperature is
selected.
Changing Drying Temperature You can be accepted. Cycle Time (Minutes)
HEAVY DUTY
High
45
Heavyweight items, towels, jeans
NORMAL
Medium
35
Corduroys, work clothes... heat such as rubber, plastic, and heat-...
Use and Care - Page 7
.... Clean lint screen.
To clean 1. Do not rinse or wash screen to avoid transfer of clothes. See "Venting Requirements." Roll lint off the screen with powdered laundry detergent and very
warm water. 2.
Make a paste with your dryer only when you will not stain future loads of dye. Apply paste to stop before your...
Use and Care - Page 8
... has detected a problem that both circuit breakers have heat. Dryer Results
Clothes are not drying satisfactorily, drying times are intact and tight, or that requires service. For direct-wired dryers:
WARNING
Changing the Drum Light
The dryer light automatically turns on inside the dryer drum when you may not have not tripped. Electrical Shock Hazard Disconnect...
Use and Care - Page 9
... exhaust hood clogged with lint, restricting air movement? Run the dryer for 5-10 minutes. Hold your garments. See Changing the AUTO DRY Default Settings.
■ Is the exhaust vent the correct length? Check that can tumble freely.
WET indicator lit.
2. (slightly drier clothes, 15% more drying time) - WET, DAMP, and COOL DOWN indicators...
Use and Care - Page 10
... the installation of your complete model number and serial number. This limited warranty is valid only in the United States or Canada and applies only when the major appliance is used in a manner that is inconsistent to published user or operator instructions and/or installation instructions.
2. AMANA® LAUNDRY WARRANTY
LIMITED WARRANTY
For...
Warranty - Page 1
... product service if your complete model number and serial number. Proof of original purchase date is used in a manner that vary from state to state or province to or furnished with Amana's published installation instructions.
10.
Some states and provinces do not allow limitations on the product. AMANA® LAUNDRY WARRANTY
LIMITED WARRANTY
For...
Dimension Guide - Page 1
... Most installations require a minimum 5" (127 mm) clearance behind the dryer for planning purposes only. For complete details, see Installation Instructions packed ...equivalent air ventilation openings are recommended.
Hood styles: A & B are acceptable.
Electric Dryer
PRODUCT MODEL NUMBERS NED7033W
Electrical: This dryer requires a 3 or 4 wire, single phase, 120/240 volt, 60 Hz,...
Installation Instruction - Page 2
... important.
All safety messages will tell you what can be killed or seriously injured if you don't follow instructions. All safety messages will follow instructions. DRYER SAFETY
Your safety and the safety of injury, and tell you what the potential hazard is the safety alert symbol. Always read and obey all...
Installation Instruction - Page 3
..., mobile homes, or sleeping quarters. Optional Equipment: (Not supplied with dryer) Check local codes.
Check existing electrical supply and venting. Parts needed :
Parts supplied (all models):
Flat-blade screwdriver
#2 Phillips screwdriver
Leveling legs (4) Parts supplied (steam models):
Wire stripper (direct wire installations)
Tin snips (new vent installations)
"Y" connector...
Installation Instruction - Page 4
Also consider weight of companion appliance.
■■ Cold water faucets located within 2 ft. (610 mm) of either side of dryer. If not level, clothes may not tumble properly and automatic sensor cycles may use the water supply for your washer using power supply cord, a grounded electrical outlet located within 4 ...
Installation Instruction - Page 5
... in.2 (310 cm2)
Back view: Electric
61/4"
(159 mm)
4" (102 mm)
3" (76 mm)
24 in longer drying times. IMPORTANT: Do not operate, install, or store dryer where it will be exposed to water, weather, or at end of automatic sensor cycles, resulting in .2 (155 cm2)
1" (25 mm)
1" (25 mm)
Cabinet installation...
Installation Instruction - Page 6
...dryer. The neutral ground conductor is manufactured ready to install with clothes dryers. Grounding through the neutral is adequate and in mobile homes to the dryer...Custom under counter installation (dryer only):
39" min. (990 mm)
1" (25 mm)
1" (25 mm)
NOTE: Some models not recommended for mobile home installations.
Additional installation requirements: This dryer is isolated from : ...
Installation Instruction - Page 7
... supply cord with ring or spade terminals and UL listed strain relief.
Prepare dryer for leveling legs
If connecting by hand, use a large flat piece of ... proper outlet installed by a qualified electrician. GROUNDING INSTRUCTIONS
� For a grounded, cord-connected dryer: This dryer must be :
■■ Flexible armored cable or nonmetallic sheathed copper cable (with ground wire...
Installation Instruction - Page 9
... use of power supply cord under center terminal block screw (B).
Connect ground wire
4-wire receptacle (NEMA type 14-30R)
4-prong plug
Spade terminals with the dryer cabinet and be in a horizontal position.
Installation Instruction - Page 14
... and kinking that
may result in reduced airflow and poor performance.
■■ Do not install in final dryer location.
■■ Remove excess to achieve best drying performance.
Venting
Venting Requirements
Exhaust hoods: ■■...existing vent system, clean lint from ground or any gas vent, chimney, wall, ceiling, attic, crawlspace, or a concealed space of fire, this...
Installation Instruction - Page 19
...Assistance or Service" section in your "Use and Care Guide". See "Level Dryer".
q Select a Time Dry heated cycle, and start of /recycle all of the water system, which will ...your "Use and Care Guide". 2. q Check dryer's final location. q Remove film on console and any dust. q Wipe dryer drum interior thoroughly with a damp cloth to the need for leaks around "Y" connector, faucet...
Similar Questions
Amana Dryer Model Ned4600yq1 Heat Problem
My Amana gas dryer model NED4600YQ1 overheats during drying. The cabinet becomes too hot to touch co...
My Amana gas dryer model NED4600YQ1 overheats during drying. The cabinet becomes too hot to touch co...
(Posted by Rlfitzgibbon 8 years ago)
Model:yned7300ww2
HELLO MY AMANA DRYER IS NOT HEATING. I checked the elements and fuse. There is continuty in both ite...
HELLO MY AMANA DRYER IS NOT HEATING. I checked the elements and fuse. There is continuty in both ite...
(Posted by FLORENCEJLM777 9 years ago)
Tandem 7300 Blows Its Thermal Resistor...why? Has Done It Three Times.
dryer blowes its thermal resistor and shuts dryer down. had it replaced three times, after being rep...
dryer blowes its thermal resistor and shuts dryer down. had it replaced three times, after being rep...
(Posted by wmeleach 10 years ago)
Converting Dryer
I have an Amana dryer that is set up for propane can it be converted to natural gas.
I have an Amana dryer that is set up for propane can it be converted to natural gas.
(Posted by debijoan 12 years ago)