Zanussi ZGNN640W Support and Manuals
Get Help and Manuals for this Zanussi item
View All Support Options Below
Free Zanussi ZGNN640W manuals!
Problems with Zanussi ZGNN640W?
Ask a Question
Free Zanussi ZGNN640W manuals!
Problems with Zanussi ZGNN640W?
Ask a Question
Popular Zanussi ZGNN640W Manual Pages
User Manual - Page 1
EASY. ZGNN640W ZGNN640X ZGNT640X
EN User Manual Hob
GB IE
User Manual
GETTING STARTED?
User Manual - Page 3
...the installation instructions supplied with a contact gap is required. A short term cooking process has to clean the appliance. • If the supply cord is damaged, it must be replaced by...an authorized Service or similarly qualified persons in the instructions for the following markets: GB IE
INSTALLATION WARNING!
WARNING!
Complete disconnection in compliance with parts that is...
User Manual - Page 4
... must be fastened in use. Contact our Authorised Service Centre or an electrician to change the specification of live and insulated parts must be accessible after each use.
4 Make ...• Do not let the appliance stay unattended during
operation. • Set the cooking zone to "off" after installation. The isolation device must be removable for adequate ventilation. • Keep ...
User Manual - Page 5
...it.
• Flat the external gas pipes.
5 SERVICE • To repair the appliance contact the Authorised Service Centre. • Use original spare parts only. The surface can cause damage to the worktop ... clean the appliance. • Clean the appliance with the appliance. • Do not install a flame diffuser on
the appliance. Do not remove the buttons, knobs or gaskets from the...
User Manual - Page 6
... should be careful when the hob is on the hob and installation. Make sure that a thorough leak test is easily accessible for ventilation Detailed recommendations are other safety instructions incorporated in the same room, B.S. 5440 Part 2 Current Edition, should not be with mobile parts or they agree to the outside no air vent is...
User Manual - Page 7
...adjuster on the gas supply pipe. CAUTION! Failure to damage the gasket. Remove the pan supports. 2. Remove the caps and crowns of the burners: 1. Remove the knob and the ... the parts, follow the same procedure backwards. 5. Pay attention not to ensure the correct assembly will cause leakage of a turn.
6. INJECTORS REPLACEMENT 1.
If the supply gas pressure is important to install the ...
User Manual - Page 8
...C D E
A. The cable should be guided by . your own safety the installation must be approximately 2 cm longer than 90... amp socket is marked as follows:
Green and yellow
- To replace the connection cable use a 3 amp ASTA-approved (BS 1362)...WARNING!
Electrical Requirements Permanent electrical installation must not be carried out exclusively by the service force centre or by a qualified...
User Manual - Page 10
... door or drawer
8. min 6 mm
A min 30 mm
B
min 5 mm
(max 150 mm)
60 mm
A. Supplied seal B. POSSIBILITIES FOR INSERTION
The panel installed below the hob must be installed separately for connections
Kitchen unit with oven The electrical connection of the hob and the oven must be easy to let easy remove...
User Manual - Page 12
... burner does not light after 15 seconds, release the control knob, turn the flame down or switch it counterclockwise to light the burner again after installation or a power cut. HINTS AND TIPS
CAUTION!
WARNING!
Make sure that pot handles are in correct positions. Keep the control knob pushed for equal or...
User Manual - Page 13
...the hob dry with a soft cloth. • To clean the enamelled parts, caps and crowns, wash them back on how the hob operates. ...replace the pan supports to the hob.
Remove the pan supports to avoid burns. • Remove when the hob is obtained through a ceramic ignition candle with warm soapy water and dry them carefully before cleaning. • Use cleaning products designed specifically...
User Manual - Page 14
... try to activate the spark generator. The instructions about the Service Centre and conditions of charge, also during the warranty period. TROUBLESHOOTING
WARNING! Make sure that the injector is ... it is the cause of the malfunction. Refer to the problem yourself, contact your dealer or an Authorised Service Centre. Problem
Possible cause
Remedy
There is blown.
IF YOU CANNOT FIND...
User Manual - Page 15
Stick it on Guarantee Card and keep this part (if applicable).
TYPE
PROD.NO. Stick it on instruction booklet. TECHNICAL DATA
HOB DIMENSIONS Width Depth
BYPASS DIAMETERS
BURNER
Rapid Semi-rapid Auxiliary
594 mm 510 mm
Ø BYPASS 1/100 mm 42 32 28
...
User Manual - Page 16
OTHER TECHNICAL DATA
TOTAL POWER:
Gas original: Gas replacement:
G20 (2H) 20 mbar G30 (3+) 28-30 mbar G31 (3+) 37 mbar
8 kW 567 g/h 557 g/h
Electric supply:
220-240 V...-rapid
2,0
0,45
71
145
Auxiliary
1,0
0,33
50
73
ENERGY EFFICIENCY
PRODUCT INFORMATION ACCORDING TO EU 66/2014 Model identification
Type of hob Number of gas burners
200 143 71
ZGNN640X, ZGNT640X Built-in hob 4
16
User Manual - Page 17
...Model... • Before use, make sure that the burners and pan supports are assembled correctly. • Use cookware with diameters applicable to ...municipal office.
17
* Return the product to its user manual. Semi-rapid Left front - ENVIRONMENTAL CONCERNS
Recycle materials with...• When you heat up water, use a pressure cooker. Part 2-1 : Rational use of burners. • Center the pot on...
Product information sheet - Page 1
Right Rear - Symbol
Value
ZGNN640W 949640829 Built-In Hob
EEgas burner EEgas burner EEgas burner EEgas burner EEgas burner EEgas burner EEgas hob
61.2 59.4,0
56.3 59,0
Unit Attribute Name Model Denomination Type of hob Number of gas burners Energy efficiency per gas burner
Energy efficiency for the gas hob
Position
Left Front Left Rear -
Zanussi ZGNN640W Reviews
We have not received any reviews for Zanussi yet.