Yamaha YST-SW200 Support and Manuals
Get Help and Manuals for this Yamaha item
View All Support Options Below
Free Yamaha YST-SW200 manuals!
Problems with Yamaha YST-SW200?
Ask a Question
Free Yamaha YST-SW200 manuals!
Problems with Yamaha YST-SW200?
Ask a Question
Yamaha YST-SW200 Videos
Yamaha YST-SW200 Sub Woofer
Duration: 2:18
Total Views: 1,045
Duration: 2:18
Total Views: 1,045
Popular Yamaha YST-SW200 Manual Pages
Owner's Manual - Page 1
... OR MOISTURE.
YST-SW200 Active Servo Processing Subwoofer System Built-in 100W Power Amplifier 2 Way Selectability for Connections High Frequency Cut-off Point (HIGH CUT) Control
PHASE Switch Remote Control Capability
Thank you for selecting this Owner's Manual in a safe place for future reference.
Active Servo Technology
OWNER'S MANUAL
CONTENTS
Safety Instructions 2 Supplied Accessories...
Owner's Manual - Page 2
...power
plug and the wires connected to service the unit
beyond those means described in power amplifier, heat will
radiate from the
wall outlet.
8 To prevent lightning damage, disconnect the AC power
plug when there is operated.
2 Retain Instructions - Should this happen, move this
unit away from the TV set...read the "TROUBLESHOOTING" section
regarding common operating errors before the unit...
Owner's Manual - Page 3
... R6, UM-3)
Speaker Cords
POWER
OUTPUT ON/OFF
HIGH-CUT UP
VOLUME
DOWN
3 FCC INFORMATION
1. Modifications not expressly approved by Yamaha may cause interference harmful to ...by Yamaha Corporation of assurance that interference will not occur in FCC Regulations, Part 15 for Class "B" digital devices.
Cable/s supplied with the requirements listed in all installation instructions....
Owner's Manual - Page 4
...subwoofer system employs YAMAHA Active Servo
Technology which YAMAHA developed for reproducing higher quality super-bass sound. (Refer to page 13 for details on Active Servo Technology.) This unit does not only enhance bass frequency response of sound output in your audio system, but, by reproducing the bass frequencies, the subwoofer... this , face the subwoofer system obliquely to break up the...
Owner's Manual - Page 5
...
If using one of the amplifier. Choose one YST-SW200
Right speaker
Left speaker
This unit
OUTPUT TO SPEAKERS...INPUT2
PHASE
NOM REV
Amplifier
To AC outlet
If using two YST-SW200s
Right speaker
Left speaker
This unit
OUTPUT TO SPEAKERS
FROM ...main speakers from this unit, be sure to first switch OFF the power to this unit and to any other components to which connections are made...
Owner's Manual - Page 6
... touch each other and do not let them touch the metal parts of this unit, your amplifier has two sets of speaker terminals
Right speaker
This unit
OUTPUT TO SPEAKERS
FROM ...speakers. If your amplifier and/or speakers.
* Banana Plug connections are also possible (except for Europe model). If the connections are faulty, no sound will lack bass. How to this unit's OUTPUT/INPUT ...
Owner's Manual - Page 7
.... With some amplifiers with only one YST-SW200
Right speaker
This unit
OUTPUT TO SPEAKERS
FROM AMPLIFIER INPUT1
INPUT2
PHASE
NOM REV
OUTPUT TO SPEAKERS
FROM AMPLIFIER INPUT1
INPUT2
PHASE
NOM REV
Left speaker
Amplifier
To AC outlet
Pin plug cords
PRE OUT
If using one set it for the correct source. If...
Owner's Manual - Page 8
Front panel
CONTROLS AND THEIR FUNCTIONS
OUTPUT
POWER
HIGH CUT
VOLUME
40 Hz
140 Hz 0
10
–
—
OUTPUT
POWER
HIGH CUT
˜
VOLUME
Rear panel
OUTPUT TO SPEAKERS
FROM AMPLIFIER INPUT1
INPUT2
PHASE
NOM REV
40 Hz
140 Hz 0
10
™
š
›
OUTPUT ...
Owner's Manual - Page 9
Select the better position by setting this switch to the STANDBY mode. (In this mode, the indicator is turned ON, the OUTPUT indicator on the front panel illuminates.
and Europe models) While the power is on, pressing the POWER key on the remote control 70
110
transmitter.
60
120
* One graduation of this unit ON...
Owner's Manual - Page 10
...SUBWOOFER OUT terminals) of the amplifier, you must adjust the volume controls of the HIGH CUT control First set it at a level where you can be obtained. Then turn up the VOLUME control gradually and set...
OUTPUT TO SPEAKERS
INPUT2
PHASE
FROM AMPLIFIER INPUT1
NOM REV
6
1 Set the VOLUME control to minimum.
2 Turn on the power supply to all the components.
3 Play the source and adjust the...
Owner's Manual - Page 11
...12" acoustic
suspension, 3 way system
HIGH CUT
VOLUME
40 Hz
140 Hz 0
10
PHASE-Set to the main speakers, listening condition, the source, etc.
The following figures show the optimum...combined with a 4" or 5"
acoustic suspension, 2 way system
HIGH CUT
VOLUME
40 Hz
140 Hz 0
10
PHASE-Set to the reverse (REV) position.
• When combined with an 8" or 10"
acoustic suspension, 2 way ...
Owner's Manual - Page 12
...power cord and contact your authorized YAMAHA dealer or service center for help. q If the remote control sensor is not proper. SYMPTOM Power is not supplied even though the POWER switch is set... panel illuminates. Replace the batteries with new ones. Replace both batteries with new ones. Clean the battery compartment thoroughly before installing new batteries. TROUBLESHOOTING
If the unit...
Owner's Manual - Page 13
SPECIFICATIONS
Speaker Unit 18 cm (7-1/16") cone woofer (JA1815) magnetic-shield type x 2
Amplifier Output 100W/5 ohms (THD 0.1%, 100 Hz) High-Cut Filter 40 Hz-140 Hz (-24 dB/oct.) Frequency Response 20 Hz-160 Hz (-10 dB) Power Supply
U.S.A. models AC 240V, 50 Hz Europe model AC 230V, 50 Hz General model... problem that is resolved through an "air woofer", which the amplifier ...
Yamaha YST-SW200 Reviews
We have not received any reviews for Yamaha yet.