Yamaha YM-41 Support and Manuals
Get Help and Manuals for this Yamaha item
This item is in your list!
View All Support Options Below
Free Yamaha YM-41 manuals!
Problems with Yamaha YM-41?
Ask a Question
Free Yamaha YM-41 manuals!
Problems with Yamaha YM-41?
Ask a Question
Popular Yamaha YM-41 Manual Pages
Owner's Manual - Page 1
CONCERT
MARIMBAS
YM-460/460F/410D/410/410F YM-46/41
OWNER'S MANUAL
Make sure to read "PRECAUTIONS FOR HANDLING GAS SPRING" and "PRECAUTIONS".
Owner's Manual - Page 2
... earthquakes. YM-41 41 kg (90 lbs 6 oz) YM-46 44 kg (97 lbs)
YM-410 YM-410F YM-410D
49 kg (108 lbs) 55 kg (121 lbs 4 oz) 55 kg (121 lbs 4 oz)
YM-460 55 kg (121 lbs 4 oz) YM-460F 61 kg (134 lbs 8 oz)
Moving the instrument up or down stairs should provide proper instruction on how...
Owner's Manual - Page 3
... storage in the following instructions carefully before using a small amount of ethyl alcohol. Caution
Injury or handicaps to persons caused by the disregard of warnings with this may cause damage to the tone bars and frame parts or topple the instrument, which may result in an injury, impair the performance functionality of the...
Owner's Manual - Page 4
...assembly and disassembly to 97cm at its highest. This manual describes proper use Yamaha's FRP Acoustalon tone bars that your content. Height Adjustment (YM-460, 460F, 410, 410F) Height adjustable models offer smooth height adjustment. Large Casters Large 100mm-diameter casters offer smoother transport. (YM-46 and 41 utilize 75mm-diameter casters).
6. 3-Step Height Adjustment for a long...
Owner's Manual - Page 5
NOMENCLATURE
■ YM-460/460F/410/410F/46/41
* The illustration shows model YM-460. Accidental tone bars Rail
Natural tone bars Suspension cord
Frame end
Leg (Small end)
Slant shaft
Resonators (Accidental tone side)
■ YM-410D
Rail
Reinforcement stay (Small end)
Reinforcement stay (Large end)
Caster
Accidental tone bars
Natural tone bars Suspension cord
Leg...
Owner's Manual - Page 6
... wing bolts x2 YM-41: One-piece type
Threaded hole i Rail (3)
YM-460/460F, 46: Two-section folding type YM-410/410F, 41: One-piece type
Clamp on both sides
o Rail (4) YM-460/460F, 46: Two-section folding type YM-410/410F, 41: One-piece type
YAMAHA logo
!0 Leg (Large end) YM-460/460F, 410/410F: With height adjustment YM-46/41: Without height adjustment...
Owner's Manual - Page 7
...below after assembly. z Connect the large and the small end legs using the reinforcement stays.
* YM-460/460F/410/410F: Before proceeding to assemble the instrument on a soft rug or carpet. Leg (Small end...slide leg fixing bolt must be tightly seated in a location with sufficient space. YM-460/460F/410/410F/46/41
ASSEMBLY
For safety, the instrument should be assembled by at least two persons in...
Owner's Manual - Page 8
...Insert the support using the reference hole close to the small end leg. (There is printed on the small end joint.)
28 YM-460/460F/410/410F/46/41
ASSEMBLY
1-2. In the same way, install the reinforcement...
Fixing bolt
&
Leg Notch
& Reinforcement stay
Notch
Reinforcement stay
1-4.
YM-460/460F/46: Connect the reinforcement stays at the center. Align the end of the large end leg...
Owner's Manual - Page 9
... the rail (2). When leg height is set low, use the hole closer to n on page 32.)
Rail (4): With YAMAHA logo. Engage the short rail clamp located at this point. (Refer to the center of the stay to the hole for attaching the stay. YM-460/460F/410/410F/46/41
ASSEMBLY
x Insert the rails (2) and...
Owner's Manual - Page 10
...
Resonator holder
Higher
Around 23°C Lower
Short groove ("A" in the same way as the rails. YM-460/460F/410/410F/46/41 ASSEMBLY
c Attach the resonators.
3-1. All pipes on the frame ends in the figure below)
Center ...Take care not to the temperature lower or higher than 23°C, adjust setting of the YM-460, 460F, 410, 410F, and 46. Place the bass side of the resonators into shorter ...
Owner's Manual - Page 11
...CPUIIBOET HFOUMZQMBDFUIFUPOFCBSTPOUIFSBJMT Align each other.
* When setting the tone bars, use care not to cause any damage to every tone bar post, fix...Small end
Large end
Suspension cord
Suspension cord
Springs
31 A mark "A" is secured to them. YM-460/460F/410/410F/46/41
ASSEMBLY
v Insert the rails (1) and (4) into each tone bar individually and hook itsDPSE onto the corresponding...
Owner's Manual - Page 12
... the height.
32
YM-460/460F/410/410F/46/41
ASSEMBLY
YM-460/460F/410/410F Only
n Adjust the height of the slide leg slipping. It is a danger of the tone bars. Slide leg
Do not touch the notched part during height adjustment to the rail section (2) so that each bolt is performed by at least two...
Owner's Manual - Page 17
... pipes into the center grooves on the natural tone side have bottoms attached.
3-1. Next set between the frame sections, and into shorter grooves when the temperature is obtained at 23°C. Set the bass side of the resonators. YM-410D
ASSEMBLY
c Attach the resonators.
3-1.
If desirable resonance is not available due to bump...
Owner's Manual - Page 18
...confirm that the DPSEis printed on rail (2) and rail (3) with rail (1) and rail (4),
respectively. Set the natural tone bars first. 8JUIPOFQFSTPOIPMEJOHUIFTVTQFOTJPODPSEPOUIFCBTTTJEFBOEUIFPUIFS... large end side and hooking the two springs into the frame ends of the large end leg. YM-410D
ASSEMBLY
v Insert the rail (1) into each tone bar individually and hook its DPSEonto the...
Owner's Manual - Page 19
... 78 80 81 83 85 87 88
Middle C
YM-410D/410/410F/41
YM-460/460F/46
* Specifications subject to change without notice. 39 C76 (4 octave)
● Bars: African Padauk, Open Pore Finish
● Bar sizes: YM-46: 58 - 38 mm (2.2 - 1.5") wide 24 - 22.5 mm (0.95 - 0.89") thick YM-41: 53 - 38 mm (2.2 - 1.5") wide 24 - 22.5 mm (0.95...
Yamaha YM-41 Reviews
Do you have an experience with the Yamaha YM-41 that you would like to share?
Earn 750 points for your review!
We have not received any reviews for Yamaha yet.
Earn 750 points for your review!