Whirlpool WGD5000D Support and Manuals
Get Help and Manuals for this Whirlpool item
View All Support Options Below
Free Whirlpool WGD5000D manuals!
Problems with Whirlpool WGD5000D?
Ask a Question
Free Whirlpool WGD5000D manuals!
Problems with Whirlpool WGD5000D?
Ask a Question
Popular Whirlpool WGD5000D Manual Pages
Owners Manual 1 - Page 2
... the word "DANGER" or "WARNING." All safety messages will be exposed to the weather.
� Do not tamper with controls.
� Do not repair or replace any part of the appliance or attempt any servicing unless specifically recommended in the usermaintenance instructions or in published user-repair instructions that could cause a load to cooking oils in the appliance.
Owners Manual 1 - Page 3
... and liquids in the vicinity of a specific type identified by the appliance manufacturer as suitable for use any electrical switch; do not use with clothes dryers. If flexible metal duct is installed, it must be performed by a qualified installer, service agency, or the gas supplier.
3 These conditions will obstruct clothes dryer airflow and increase the risk of fire...
Owners Manual 1 - Page 4
... be detected by UL or CSA. IMPORTANT: The gas installation must conform with local codes, or in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70, or the Canadian Electrical Code, Part 1, CSA C22.1. IMPORTANT SAFETY INSTRUCTIONS
WHEN DISCARDING OR STORING YOUR OLD CLOTHES DRYER, REMOVE THE DOOR.
WARNING: Gas leaks cannot always be listed. � A flexible...
Owners Manual 1 - Page 8
... Start Guide for contact and ordering information. Mobile home installations require metal exhaust system hardware available for service contact information. Parts Supplied (all parts are included. NOTE: Do not use leveling legs supplied with dryer if installing with dryer):
Additional parts may vary according to model)
Parts package is located in dryer drum. See "Electrical Requirements...
Owners Manual 1 - Page 9
...closets, mobile homes, or sleeping quarters.
Mobile home installations require:
� Metal exhaust system hardware, which is allowed for straight-back venting only.
Some codes limit, or do so can be kinked.
See "Venting Requirements."
� A separate 15 A or 20 A circuit for gas dryers. � A grounded electrical outlet located within 4 ft. (1.2 m) of the water fill...
Owners Manual 1 - Page 10
... Start Guide.
Securely tighten all local codes and ordinances. Examples of the gas connection to the dryer. � 1/2" IPS pipe is recommended. � 3/8" approved aluminum or copper tubing is equipped for lengths under 20 ft. (6.1 m) if local codes and gas supplier permit. � If you are using natural gas, do so can result in death, fire, or electrical...
Owners Manual 1 - Page 12
...: licensed heating personnel, authorized gas company personnel, and authorized service personnel. Open shutoff valve
A. valve is open when handle is parallel to the floor.
For ordering information, please reference the Quick Start Guide.
2. U.S.A. Bubbles will show a leak.
Mobile home installations require a Mobile Home Installation Hold-Down Kit. Install a shut-off valve...
Owners Manual 1 - Page 13
.... Failure to seal all governing codes and ordinances.
Exhaust outlet I.
Clamps:
� Use clamps to follow these instructions can be fully extended and supported in enclosed walls, ceilings, or... System
Recommended exhaust installations:
Typical installations vent the dryer from your Quick Start Guide. Other installations are possible. Dryer B. Elbow C. Clamps
F.
Owners Manual 1 - Page 17
... to the user instructions in the dryer. Complete Installation Checklist
� Check that the flexible gas line is an extra part, go away. Once dryer is level, make sure all four legs are on . � Check for leaks. � Check that all of your dryer vent may clog different parts of base trim. All Models: � Set the heat cycle...
Specification Sheet - Page 1
...-11/16"
64'
Rear Only
No
NOTE: Dimensions are for when it .
This feature also is great for planning purposes only. 7.0 cu. All rights reserved. Specifications subject to help of -Cycle Signal
Interior Drum Light
Designed, Engineered and Assembled in the U.S.A. WGD5000DSpecSheetV01. Gas Dryer
WGD5000D
White WGD5000DW
Capacity
Total
7.0 cu. ft.
Installation Instructions - Page 5
... allow the dryer door to support dryer and a total weight (dryer and load) of 3.8 cu.
capacity washer) or 1½" (38 mm) (to water and/or weather. ■■ A separate 30 amp circuit for electric dryers.
■■ A separate 15 or 20 amp circuit for the exhaust vent with elbow. Some codes limit, or do not permit, installation of dryer.
Installation Instructions - Page 7
... "Assistance or Service" section of local codes, with Natural Gas. IMPORTANT: The gas installation must be made to match height of foot is approximately 1/2" (13 mm) (to convert the dryer from the gas specified on cardboard.
2. No attempt shall be made by CSA International for electrical connection and to its legs. Gas type
Natural gas: This dryer is designcertified...
Installation Instructions - Page 8
... manual shut-off valve location should use TEFLON®† tape. Listed here are using Natural Gas, do not use copper tubing. ■■ 3/8" flare x 3/8" NPT adapter fitting between the stainless steel gas connector and the dryer gas pipe, as needed to the gas supply line with the B149.1, Natural Gas and Propane Installation Code.
rating indicated on the model...
Installation Instructions - Page 9
... properly grounded. The plug must not be fully extended and supported in accordance with the dryer: if it will reduce the risk of electric shock. Check with rigid metal or flexible metal vents.
Replace plastic or metal foil vents with a quali ed electrician or service representative or personnel if you are in enclosed walls, ceilings...
Dimension Guide - Page 1
White Available WED5000DW - Gas
Dimension Guide Whirlpool® Dryer with
Wrinkle Shield™ Plus - 7.0 cu.
Electric WGD5000DW - W11462162A ft.
Whirlpool WGD5000D Reviews
We have not received any reviews for Whirlpool yet.