Whirlpool CAM2752TQ - COMMCL WSHR 2SP 3CYC WH DIG D Support and Manuals
Get Help and Manuals for this Whirlpool item
View All Support Options Below
Free Whirlpool CAM2752TQ manuals!
Problems with Whirlpool CAM2752TQ?
Ask a Question
Free Whirlpool CAM2752TQ manuals!
Problems with Whirlpool CAM2752TQ?
Ask a Question
Most Recent Whirlpool CAM2752TQ Questions
Where Can I Get A Uers Guide?
(Posted by Carol2721 11 years ago)
Agitator Removal
i am trying to replace the transmission, but i cant figure out to get the secondary cap off the agit...
i am trying to replace the transmission, but i cant figure out to get the secondary cap off the agit...
(Posted by foaks 11 years ago)
I Have A Cabrio Washer Less Than 2 Yrs Old And Keep Getting A Flashing Code F51
(Posted by fastbrnr 12 years ago)
The Clicking Noise.
There is a strange clicking noise at the back of my Whirlpool Cabrio model #WED7300XW it drys great,...
There is a strange clicking noise at the back of my Whirlpool Cabrio model #WED7300XW it drys great,...
(Posted by tarifaggion 12 years ago)
I Just Hook This Machine Up And Nothing. It Will Not Even Start. Please Help.
I just hooked this machine up and nothing. It will not even start. Please Help.
I just hooked this machine up and nothing. It will not even start. Please Help.
(Posted by rmcfadden 12 years ago)
Popular Whirlpool CAM2752TQ Manual Pages
Installation Instructions - Page 1
www.whirlpool.com
COMMERCIAL WASHER
Paff No, 8315954 Rev, A
120-volt, 60-Hz Models
COMMERCIAL
LAUNDRY PRODUCTS
IMPORTANT: Read and save these instructions
IM PORTANT: Installer: Leave Installation Instructions
with the owner. Save Installation Instructions for
future reference. Owner: Keep Installation Instructions for local
electrical inspector's use.
Installation Instructions - Page 2
...installation,
Do Not store or operate washer below 320F (0oC) (some water may remain in this manual and on your appliance.
Check location where washer will be killed or seriously
injured if you don't follow instructions...: Set to
deliver 120°F (49°C) water to the washer,
Level floor: Maximum slope under washer- ...Must be sturdy enough to support loaded washer weight of 315 pounds (...
Installation Instructions - Page 3
...installation:
level
Ji i
utility knife
fslcart-ebwladdrievel scissors
Parts supplied for ease of installation and servicing, If closet door is installed, the minimum air openings in accordance with local codes... spacing should be considered,
l_inim_ml installation spacing
/ V clo_l door
VNN N 48 sq. The installation dimensions shown are notsurethe washer ispropedygrounded. in.
(/.6 cm)
...
Installation Instructions - Page 4
...,
Inlets are
found, When replacing your Whirlpool washer. PAGE 4
B Move washer close to final
position, Put "hook" end of drain hose into each other, Tilt washer backwards and
insert corner posts 3 inches (7,6 cm) in from one side of washer as shown,
Repeat with other... people to make final two-thirds turn , hand; then use pliers to move and install washer. Do Not stdp or crossthroad.
Installation Instructions - Page 5
...and remove, Install money accepting device (refer to manufacturers instructions for proper installation), For machines using coin slides, use adapter kit (provided with level,
When washer is level,...washer is not removed, washer may vibrate. F
bose
112" (1.3 cm)
L
nut
JB
1 U • Use legs and nuts from parts package, Screw nut down , Make final check with unit), Replace meter case service...
Installation Instructions - Page 6
... using the washer,
• Do not wash articles that have the skills to carry out,
• See Installation Instructions for grounding requirements,
SAVE THESE INSTRUCTIONS ForWARM RINSEwhere applicable: • Remove screws from each for several minutes, This will release any servicing unless specifically recommended in the Owner's Manual or in published user-repair instructions that you...
Installation Instructions - Page 7
... (including cooking oils).
Do not dry anything that has ever had any residue away that are washed in the washer, run the washer through a complete cycle to a new location... Typical full load sizes. operated washers, If these items are dampened with gasoline or other flammable fluids. Wedge blanket between the tub ring and the...
Installation Instructions - Page 8
)
/iI
power
supply
,cord
1 I12"
(4 cm)
43.
(109 cm) 38-I/8" (97 cm)
3_.
(89 cm)
27-3/4"
(70.5 cm)
/
water inlets
I"
(2.5 cm)
Water level shaft
drain hose connector
7.
(18 cm)
27" cm)
Part No. 8315954 Rev. A (D2001Whirlpool Corporation
Prepared by Whirlpool Corporation Benton Harbor, Michigan 49022
Printed in U.S.A.
Whirlpool CAM2752TQ Reviews
We have not received any reviews for Whirlpool yet.