Tripp Lite APS2012SW Support and Manuals
Get Help and Manuals for this Tripp Lite item
View All Support Options Below
Free Tripp Lite APS2012SW manuals!
Problems with Tripp Lite APS2012SW?
Ask a Question
Free Tripp Lite APS2012SW manuals!
Problems with Tripp Lite APS2012SW?
Ask a Question
Popular Tripp Lite APS2012SW Manual Pages
Owner's Manual for 120V APS Pure Sine Wave Inverter/Chargers 933053 - Page 1
... Installation
8
3.4 Battery Connection
8
4. Service and
Warranty Registration
12
Español
13
1111 W. 35th Street, Chicago, IL 60609 USA www.tripplite.com/support
Copyright © 2011 Tripp Lite. RcWpheRragoaeindsrcgutreeciartst!onotwntrwlwyaininwte.iattoroiFpndRpaElyitEefo.Tcrriopamp/Lwitaerranty
Owner's Manual
Sine Wave DC-to-AC Inverter/Chargers
Models: APS1012SW, APS2012SW...
Owner's Manual for 120V APS Pure Sine Wave Inverter/Chargers 933053 - Page 2
... a surge suppressor, line conditioner or UPS system to significantly affect its front or rear panel facing down (at front and back of the vehicle or earth ground. Always observe proper polarity as the battery supply is operating from the battery supply.
Location Warnings
• Install your Inverter/Charger in unit panels. During any angle). Important Safety Instructions
SAVE THESE...
Owner's Manual for 120V APS Pure Sine Wave Inverter/Chargers 933053 - Page 3
... sine wave from heaters, air conditioners, refrigerators and vacuum cleaners to a wide range of the Inverter/Charger.
1
2
3
4
5
6
7
8
9
1 Power ON/OFF Button 2 LED 1 - Inverter Condition
10
5 LED 4 - Overview and Features
1.1 Overview
• Tripp Lite's Sine Wave Inverter-Charger is powered by the AC input.
1.2 Indicators, Controls and Settings
1.2.1 Controls and LED Indicators...
Owner's Manual for 120V APS Pure Sine Wave Inverter/Chargers 933053 - Page 4
...batteries, the Inverter/Charger will beep when the shutdown process is full charged.
1.2.5 Inverter Condition (LED 3)
When the inverter temperature exceeds the default setting, this LED will flash and the inverter...5V 12.5 ~ 13.5V >13.5V
Off
1.2.2 Power ON/OFF Button
The Power ON/OFF button is located in inverter mode (supplying power from battery).
1.2.4 AC Mode Charger (LED 2) The LED ...
Owner's Manual for 120V APS Pure Sine Wave Inverter/Chargers 933053 - Page 5
... Delay (Switch 1)
30 sec (Default)
5 sec
Low Battery Alarm (Switch 2) AC Transfer Voltage (Switch 3)
11.2V 95V
10.9V (Default) 85V (Default)
*Note:
1.
On On On
LED 7 - - On On
LED 8 - - - All switches must be set before the system is supporting loads that must constantly be powered, turn off switch 4 to Acceptance voltage, continue for...
Owner's Manual for 120V APS Pure Sine Wave Inverter/Chargers 933053 - Page 6
... setting.
1.3 Features
1.3.1 Battery Temperature Port This port allows connection of either a battery charger or an inverter. See instructions packed with the APSRMSW Remote Control (sold separately). When the unit is used , the Inverter/Charger will require a battery bank with a larger amp-hour capacity) or the operational lifetimes of the batteries may be supplied to the inverter...
Owner's Manual for 120V APS Pure Sine Wave Inverter/Chargers 933053 - Page 7
... by the total amp-hour capacity of connected batteries and the support of utility power, you will connect to recharge your Inverter/Charger. For Tripp Lite Inverter/Chargers over 1000 watts used in equipment manuals or on the Switch 6, 7 and 8 ON/OFF settings). Even though Tripp Lite Inverter/Chargers are usually listed in mobile applications, Tripp Lite recommends you have to your...
Owner's Manual for 120V APS Pure Sine Wave Inverter/Chargers 933053 - Page 8
...It should be made of acid resistant material or coated with a thin layer of time. DO NOT ALLOW THE SOLUTION TO ENTER THE BATTERY. Review both the important safety instructions at this manual and the battery supplier's precautions before installing the inverter and batteries.
3.3.1 Battery Location
Batteries should be used when continuously operating heavy draw equipment under these...
Owner's Manual for 120V APS Pure Sine Wave Inverter/Chargers 933053 - Page 9
... within 18 inches of the battery) 6 Battery Isolator 7 Large Diameter Cabling, Maximum 2/0 Gauge to the main battery within 18 inches of the battery. Battery
• Connect Fuse: NEC (National Electrical Code) article 551 requires that are isolated from an
alternator rather than a battery or battery bank. • Observe proper polarity with all of your Inverter/Charger to Fit Terminals...
Owner's Manual for 120V APS Pure Sine Wave Inverter/Chargers 933053 - Page 10
... and application, consult local codes and the NEC.
4.2 Installation Diagrams and Charts
4.2.1 Terminal Block (AC Side)
4.2.2 Terminal (DC Side)4. To promote peak performance, battery cables should be ignited by switching a relay. For specific requirements pertaining to operate at high power for sustained periods. Do not mount the inverter in a protected location that is essential to...
Owner's Manual for 120V APS Pure Sine Wave Inverter/Chargers 933053 - Page 11
...
Inductive Load
Motor Load
Rectifier Load
Wall-Mounting
APS1012SW
APS2012SW
1000 Watts
2000 Watts
>79%
Sine Wave
120 Amps
250 Amps
200 Amps
400 Amps
12 VDC
10.0 ~ 16 VDC
10.9/11.2 VDC
+/- 10%
0.8 to AC Mode and will power the load while charging the battery.
5. 4. Installation and Operation
4.3 Installation and Start-Up
4.3.1 Connect the unit to the...
Owner's Manual for 120V APS Pure Sine Wave Inverter/Chargers 933053 - Page 12
Troubleshooting
• Your Inverter/Charger requires no maintenance and contains no user-serviceable or user-replaceable parts, but should not be confused with the marking name or model number of the product. Service
Your Tripp Lite product is not covered under warranty. Review the installation and operation procedures in this manual to register the warranty for your new Tripp Lite ...
Tripp Lite APS2012SW Reviews
We have not received any reviews for Tripp Lite yet.