Tripp Lite APS1012SW Support and Manuals
Get Help and Manuals for this Tripp Lite item
View All Support Options Below
Free Tripp Lite APS1012SW manuals!
Problems with Tripp Lite APS1012SW?
Ask a Question
Free Tripp Lite APS1012SW manuals!
Problems with Tripp Lite APS1012SW?
Ask a Question
Popular Tripp Lite APS1012SW Manual Pages
Owner's Manual for 120V APS Pure Sine Wave Inverter/Chargers 933053 - Page 1
... Safety Instructions
2
1. Service and
Warranty Registration
12
Español
13
1111 W. 35th Street, Chicago, IL 60609 USA www.tripplite.com/support
Copyright © 2011 Tripp Lite. Inverter/Charger
Installation and Operation
10
4.1 Installation
10
4.2 Installation Diagrams and Charts 10
4.3 Installation and Start-Up
11
5. Troubleshooting
12
7. Technical Specifications...
Owner's Manual for 120V APS Pure Sine Wave Inverter/Chargers 933053 - Page 2
... is connected. Location Warnings
• Install your Inverter/Charger in life support applications where failure of this equipment in a location or compartment that contains the Inverter/Charger must be expected to contact the DC input terminals. This manual contains important instructions and warnings that should therefore be comprised of batteries of all Tripp Lite Inverter/Chargers.
Owner's Manual for 120V APS Pure Sine Wave Inverter/Chargers 933053 - Page 3
...generating a pure sine wave from heaters, air conditioners, refrigerators and vacuum cleaners to a wide range of the Inverter/Charger.
1
2
3
4
5
6
7
8
9
1 Power ON/OFF Button 2 LED 1 - Overview and Features
1.1 Overview
• Tripp Lite's Sine Wave Inverter-Charger is powered by the AC input.
1.2 Indicators, Controls and Settings
1.2.1 Controls and LED Indicators Shown below are...
Owner's Manual for 120V APS Pure Sine Wave Inverter/Chargers 933053 - Page 4
...cutoff voltage (LBCO), then the inverter will shut down automatically. Note: Unit is in inverter mode (supplying power from battery).
1.2.4 AC Mode Charger...inverter status as power is full charged.
1.2.5 Inverter Condition (LED 3)
When the inverter temperature exceeds the default setting, this LED will flash and the inverter will start up even if not connected to batteries, the Inverter...
Owner's Manual for 120V APS Pure Sine Wave Inverter/Chargers 933053 - Page 5
... the system is located farthest from the battery temperature port. If the inverter is always on if load > 100W
Inverter is supporting loads that must be powered, turn off switch 4 to -DC voltage point. On
1.2.8 Voltage Setting (Switch 1-3)*
Switch
ON
OFF
DC-to Floating voltage.
5 Please see the table for up to 12 hours, then...
Owner's Manual for 120V APS Pure Sine Wave Inverter/Chargers 933053 - Page 6
... amp-hour capacity) or the operational lifetimes of extreme heat or cold. See instructions packed with the remote control module for the maximum allowed charge rate (usually 0.3...AC power (e.g., shore power or generator) must be adjusted by setting these switches as a charger, AC loads are connected to operate as a battery charger. Auxiliary batteries must be supplied to the inverter's...
Owner's Manual for 120V APS Pure Sine Wave Inverter/Chargers 933053 - Page 7
...have to recharge your Inverter/Charger with utility- If your application. or generator-supplied AC power.
Actual amp-hour ... total amp-hour capacity of connected batteries and the support of utility power, you use at their amp-hour ratings.
45 ...amp- For Tripp Lite Inverter/Chargers over 1000 watts used in equipment manuals or on the Switch 6, 7 and 8 ON/OFF settings). Battery amp...
Owner's Manual for 120V APS Pure Sine Wave Inverter/Chargers 933053 - Page 8
...allows for brief periods of delivering peak wattage at this manual and the battery supplier's precautions before installing the inverter and batteries.
3.3.1 Battery Location
Batteries should be rainproof ...below). Review both the important safety instructions at the beginning of current. Do not locate the inverter in an accessible location with an acid resistant finish to the inverter. ...
Owner's Manual for 120V APS Pure Sine Wave Inverter/Chargers 933053 - Page 9
...main battery.
3
7
1
2
12 Volts
12 Volts
5 12 Volt Main Battery Connection
12 Volt Inverter/Charger
62 1
4
7
12 Volts
12 Volts
2
35
12 Volts
12 Volt Main and Auxiliary... within 18 inches of your Inverter/Charger's positive DC Terminals directly to Fit Terminals
12 Volt Inverter/Charger
9 Battery
• Connect Fuse: NEC (National Electrical Code) article 551 requires that are...
Owner's Manual for 120V APS Pure Sine Wave Inverter/Chargers 933053 - Page 10
.... For specific requirements pertaining to operate at high power for sustained periods. This will restrict air flow and cause the inverter's protection circuitry will activate, reducing maximum available power. 4.1.2 System Grounding Proper grounding is isolated from connection of the Inverter/Charger. 4. Installation and Operation
4.1 Installation
4.1.1 Environment The Inverter/Charger...
Owner's Manual for 120V APS Pure Sine Wave Inverter/Chargers 933053 - Page 11
... few seconds. Installation and Operation
4.3 Installation and Start-Up
4.3.1 Connect the unit to the AC source. Then, connect to the batteries per Section 3. Technical Specifications
Specification
Model
Continuous Power
Peak Inverter Efficiency
Output Waveform
DC Current at Rated Power
Recommended Battery Fuse
Nominal Input Voltage
DC Input Voltage Range
Low Battery Protection (Heavy...
Owner's Manual for 120V APS Pure Sine Wave Inverter/Chargers 933053 - Page 12
... of the instructions. 2. 6. Troubleshooting
• Your Inverter/Charger requires no maintenance and contains no user-serviceable or user-replaceable parts, but should not be found on service, visit www.tripplite.com/support. Service
Your Tripp Lite product is within its warranty period, enclose a copy of the product. Review the installation and operation procedures in this manual to...
Tripp Lite APS1012SW Reviews
We have not received any reviews for Tripp Lite yet.