TRENDnet TE100-PCIWA Support and Manuals
Get Help and Manuals for this TRENDnet item
View All Support Options Below
Free TRENDnet TE100-PCIWA manuals!
Problems with TRENDnet TE100-PCIWA?
Ask a Question
Free TRENDnet TE100-PCIWA manuals!
Problems with TRENDnet TE100-PCIWA?
Ask a Question
Popular TRENDnet TE100-PCIWA Manual Pages
User Guide - Page 2
...installed and used in which case the user may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference, in accordance with the regulations for a Class B digital device, pursuant to Part... domestic environment, this user's guide, may be required to take adequate measures. VCCI Class B Compliance (Japan)
2
User Guide - Page 3
...3
About Auto-negotiation
Auto-negotiation is wholly compatible with ACPI, and PC99, and includes support for choosing the 32-bit PCI-Bus 10/100Mbps NWay ACPI Fast Ethernet Card, this ... is a network technology specified by Magic Packet™, LinkChg and Microsoft®wake-up and also supports auto-negotiation to automatically select the optimum speed and communication mode of an attached...
User Guide - Page 4
... elements are required:
Desktop management software that can send a "wake-up signal, the other support tasks can supply low-level auxiliary power to the motherboard. A Wake-On-LAN network card that can recognize a wake-up packet and signal the PC to a PC.
Remote LAN Wakeup
Remote LAN Wakeup capability is detected, the card signals the motherboard to...
User Guide - Page 5
..., LinkChg and Microsoft wake-up frame) • Supports 4 Wake-On-LAN (WOL) signals (active high, active low, positive pulse, and negative pulse) • Supports ACPI, PCI power management. • Half/Full duplex capability • Supports Full Duplex Flow Control (IEEE 802.3x) • Built-in FIFO buffers reduce overhead of memory transfers. • Drivers for all leading...
User Guide - Page 6
... the computer's cover.
2. Step 1, Hardware Installation
1. Replace the computer's cover and connect the network cable to the "WOL" connector on PCI 2.1 Motherboard only). Then, screw the card's bracket securely into the power outlet.
6 Attach the Wake-On-LAN cable (for installing TE100-PCIWA on the computer's motherboard. Installation
Installation the 10/100Mbps PCI bus Fast...
User Guide - Page 7
... optional Boot ROM device allows you have to install the network driver first. Perform the following steps to the installation procedure provided by networking operating system.
7
Refer to install your Boot ROM device:
1.
The driver for each networking operating system is necessary to run the CMOS Setup utility, and manually assign a non-conflicting Interrupt Number. Then it...
User Guide - Page 8
... verification/diagnostic run properly in the DOS prompt in Windows.
5. Troubleshooting
If you experience any problems with a verified adapter, reboot the computer to activate or deactivate PCI slots.
4. Check the length and rating of cable is employed for running in the slot connector.
2. The CMOS Setup utility in another PCI computer and run the...
User Guide - Page 9
Bus Master
Wake-On-Lan: Magic Packet
LinkChg
Microsoft wake-up frame
LED indicators: Link, Activity
Media
RJ...Specifications
Standards:
IEEE 802.3 10BASE-T IEEE802.3u 100BASE-TX
ANSI/IEEE 802.3 Nway
Auto-negotiation
IEEE 802.3x Full Duplex flow control
PCI Local Bus Rev.2.1, 2.2
Host interface: 32-bit PCI 2.1, 2.2. number conflict which will have to be resolved manually by a CMOS Setup...
TRENDnet TE100-PCIWA Reviews
We have not received any reviews for TRENDnet yet.