Stihl TS 350 Support and Manuals
Get Help and Manuals for this Stihl item
View All Support Options Below
Free Stihl TS 350 manuals!
Problems with Stihl TS 350?
Ask a Question
Free Stihl TS 350 manuals!
Problems with Stihl TS 350?
Ask a Question
Stihl TS 350 Videos
stihl TS 350 concrete saw cortadora de concreto semento commercial
Duration: 6:56
Total Views: 29
Duration: 6:56
Total Views: 29
Stihl TS 350 quick cut saw old 2 stroke power test
Duration: 3:36
Total Views: 3,761
Duration: 3:36
Total Views: 3,761
STIHL TS 350 S
Duration: :39
Total Views: 84
Duration: :39
Total Views: 84
Stihl TS 350 saw cutting
Duration: :58
Total Views: 1,512
Duration: :58
Total Views: 1,512
Popular Stihl TS 350 Manual Pages
Instruction Manual - Page 2
... improvements
are made from time-to reduce the
risk of personal injury. Main Parts of the TS 350 CutquikTM 2 Starting
20 This Manual contains operating and
Definitions Safety precautions
3 Checking Spark Plug 4 General Notes on Operation
22 safety instructions for your STIHL
dealer for your
Abrasive Wheel Guard
17 Federal Emission Control Systems
area if you...
Instruction Manual - Page 3
Main Parts of the TS 350 CutquikTM
2
TS 350
Instruction Manual - Page 9
... safety devices are working properly, the carburetor idle and maximum speed are deflected away from gasoline is very important to change clothes immediately. See operating instructions of fuel may remain on clothes after one hour of the neck entry diameter into the tank. The STIHL TS 350 and TS 360 CutquikTM is in well-ventilated areas...
Instruction Manual - Page 13
... times. Do not use chipped abrasive
wheels, circular saw blade may catch in the material being cut (climbing). Do not cut any nature. Never cut while standing on the wheel.
4. An understanding of...ladder.
3. If the contact is at all dangers presented by STIHL. If the contact is at the bottom of the wheel, a cut-off machine will be instantly thrown up and back towards the operator...
Instruction Manual - Page 16
... line up with the slots in the V-belt guard (5) and screw them into the bearing plate-move V-belt guard to and fro to suit cutting requirements. TS 350
15
Outboard mounting
Position the bearing plate (3) against the inside of the cast arm to ease insertion. this operation is turned counterclockwise with arbor and...
Instruction Manual - Page 17
.... Then finally tighten down slightly the bearing and adjuster remain in the set position).
head screw Bottom: Bearing mounted outboard
Tensioning the V-belt
Turning eccentric adjuster to ease insertion. The assembly sequence is correctly tensioned if it if necessary.
16
TS 350 head screw has been tightened down the hex. Then use a 13...
Instruction Manual - Page 18
...saw .
TS 350
17 Abrasive Wheels
Cutting wheels for free-hand cutting operations are subjected to direct sunlight or other sources of heat. top quality cutting blades which exactly match the engine characteristics of the cut -off-saw...service life of special abrasive wheels (3 and 6 mm / 0.12 and 0.24 in a dry place where there is limited to the cut -off -saw...STIHL. Store spare cutting ...
Instruction Manual - Page 19
...M 10 hex.
Mounting the abrasive Wheel
The engine must never be used simultaneously, for installing induction loops in road surfaces), two diamond abrasive wheels can be used side by side. ... when fitting a diamond abrasive wheel. head screw Bottom: Rear thrust washer correctly positioned
18
TS 350 head screw. for they may break and cause injuries as they wear down unevenly. Top:...
Instruction Manual - Page 21
...feel the starter engage.
Set throttle trigger (3) to half-throttle position by moving the stop switch (2) away from "Stop" Bottom: Starting-throttle position
20
TS 350 Pull starter grip (5) slowly...speed.
7. The engine is stopped by pressing in "CHOKE" position (cold start , place cut-off-saw firmly on the ground with your left hand on ground, make sure you are starting throttle ...
Instruction Manual - Page 22
... the combustion chamber by pulling starter rope several attempts, it is already flooded. TS 350
21
The choke valve is closed when the choke lever is on "Choke" and...-throttle position. Allow engine to the carburetor's choke valve. Points to observe when starting procedure. If you have to repeat the starting :
The choke lever is cold, and set the throttle trigger to the starting a...
Instruction Manual - Page 26
... or a suitable pair of the starter grip and down through the guide bush (6). Remove remaining rope from the starter post. Part No. 1122 190 2900 - through the rotor and secure it back and forth until the rewind spring's anchor loop (7) engages. TS 350
25
Thread the new rope -
Then take off the thrust washer...
Instruction Manual - Page 29
STIHL CutquikTM Cart 4201 710 1403 and Cutting Depth Limiter 42010071041 (special accessory)
Spark arresting screen in the muffler
The TS 350 can be obtained for road repairs and applying road markings as well as a special accessory and enables a constant depth of cut to be maintained when working with a diamond abrasive wheel.
28
The spark arresting screen...
Instruction Manual - Page 31
...rated spindle speed of tools
STIHL CutquikTM cart Attachment (TS 350) for CutquikTM cart Cutting depth limiter Water attachment for wet cutting Water container
* Not available in all countries STIHL single-cylinder two-stroke ...long
Composite abrasive wheels for stone and asphalt.
Carburetor: All-position diaphragm carburetor with dia. 350 mm: 9.95 kg (22 lb)
Set of your cut-off machine).
Instruction Manual - Page 32
... emission control system includes parts such as a problem exists.
The warranty repairs will be hoses, and connectors and other emission related assemblies. Environmental Protection Agency (EPA) and STIHL Incorporated are warranted for the first two years of engine use from defects in a reasonable amount of sale, to a STIHL service center as soon as the carburetor and the ignition...
Instruction Manual - Page 33
... the application of fuel and oil may be performed at any authorized STIHL servicing dealer and present the signed warranty card. repair or replacement required because of misuse, neglect or lack of the following list specifically defines the emission-related warranted parts:
Carburetor Choke (Cold start enrichment system) Intake manifold Air filter Spark plug Magneto or electronic...
Stihl TS 350 Reviews
We have not received any reviews for Stihl yet.