Pyle HUFSP98 Support and Manuals
Get Help and Manuals for this Pyle item
View All Support Options Below
Free Pyle HUFSP98 manuals!
Problems with Pyle HUFSP98?
Ask a Question
Free Pyle HUFSP98 manuals!
Problems with Pyle HUFSP98?
Ask a Question
Popular Pyle HUFSP98 Manual Pages
Instruction Manual - Page 2
... parts while unassembled. • The toy needs to be supervised. • Brake can become hot. • Maximum permissible weight: 60 kg.
2 www.PyleUSA.com They include these instructions ... to avoid falls or
collisions causing injury to use the scooter after -sales service. Important Instructions and Warnings IMPORTANT: Before you convince yourself of helmets protective equipment for elbows...
Instruction Manual - Page 3
... observe tra c rules and regulations.
• Load capacity is up .
• Some metal parts may corrode after a certain time, especially when used on public roads. Avoid skin contact.
•...is not designed
to decelerate from high downhill speeds. www.PyleUSA.com 3
OPERATING SAFETY INSTRUCTIONS
• Child should always be adjusted to the personal skill of the rider.
•...
Instruction Manual - Page 4
...the risks of falling.
Enjoy your scooter carefully that both feet are using the other leg. ASSEMBLY INSTRUCTIONS Free assembly. Be careful however: if you push the brake too hard and slow down too ... now-ready for reduction of speed on the board and push yourself o using the scooter. PLAY INSTRUCTIONS Hold on to the ends of travel ) on at 45° angle to accelerate. If you...
Instruction Manual - Page 7
...Use the Allen key to A
www.PyleUSA.com 7 Finish as shown in Figure B
If installing T-bar and collar clamp, go back from E to x rmly with Allen key, as shown in Figure... B.
Done as image shown
Seat and drawer installation (Method 2-1) Remove and install collar clamp and T-Bar
A
B
C
Open the lever of the collar clamp and use the ...
Instruction Manual - Page 8
... shown
Put the sliding sleeve into Steering rod.
Put the drawer into the seat
Sliding Sleeve Installation
Put T-bar into Steering Rod. Tighten the screws with the Allen key
PutT-bar into seat... to x rmly with the screw. Finish as image shown.
8 www.PyleUSA.com
Seat and drawer installation (Method 2-2)
Insert the front covering into the Steering Rod and Fix the collar clamp. Put the...
Instruction Manual - Page 9
A
2. MAINTENANCE INSTRUCTIONS
Change Deck
1. Loosen the 6 screws (A) as shown in Figure F. Check for tight t after you have traveled
about 5km with the new board.
Seat and drawer installation (Method 1) RECOMMENDED A
B
C Unfold: Pull sliding sleeve upward to fold the scooter, as shown in Figure D and E, complete folding scooter as shown in Figure C. D
E
F
Fold: Pull...
Instruction Manual - Page 10
... the screws (E) and (F). Loosen the 2 screws (G)as image
shown (arrows). 2.
Pull the sliding sleeve upwards and remove
or replace it . 2. Change Brake 1. Remove or Change Sliding Sleeve 1. Firstly Loosen the 6 screws(A) , please refer
to 1. Replace the brake and work back from 2 to the changing deck. 2. Loosen the 4 screws (C) as image shown
C
(arrows...
Instruction Manual - Page 11
... protect hand joints, elbows and knees from the date of purchase.
Improper attempts at repair or modi cations the scooter. 3.
To ensure you wear shoes with an identical or...excluded and we will inspect and decide that you need repair or replace, please directly contact your safety. During the warranty period, we recommend that the problem has been caused by : 1. The warranty shall ...
Instruction Manual - Page 12
... • Indoor/Outdoor Use • Suitable for Ages Up to 12 Years • Fun for Kids: Small Children & Young Toddlers
Technical Specs:
• Handlebar Height Setting: 24.8'' - 32.3'' -inches • Wheel Size Diameter: 120mm Front, 80mm Rear • Construction Material: Aluminum Metal, Engineered ABS • Wheel Type / Wheel Material: Engineered Polyurethane...
Instruction Manual - Page 13
...: Small Children & Young Toddlers
What's in the Box:
• Kids Scooter • Removable Storage Seat • Safety Push-Bar Handle
Technical Specs:
• Handlebar Height Setting: 20.9'' - 24.8'' -inches • Wheel Size Diameter: 120mm Front, 80mm Rear • Construction Material: Aluminum Metal, Engineered ABS • Wheel Type / Wheel Material: Engineered Polyurethane...
Instruction Manual - Page 14
Phone: (1) 718-535-1800 Email: support@pyleusa.com We are here to help! Questions? Issues?
Pyle HUFSP98 Reviews
We have not received any reviews for Pyle yet.