Poulan PR8527ESB Support and Manuals
Get Help and Manuals for this Poulan item
View All Support Options Below
Free Poulan PR8527ESB manuals!
Problems with Poulan PR8527ESB?
Ask a Question
Free Poulan PR8527ESB manuals!
Problems with Poulan PR8527ESB?
Ask a Question
Popular Poulan PR8527ESB Manual Pages
User Manual - Page 1
Failure to do so can result in U.S.A.
Always Wear Eye Protection During Operation
192038 Rev. 1 07.28.04 BY Printed in serious injury. IMPORTANT MANUAL
Do Not Throw Away
OWNER'S MANUAL
MODEL NUMBER:
PR8527ESB
SNOW THROWER
WARNING:
Read the Owner's Manual and follow all Warnings and Safety Instructions.
User Manual - Page 2
...carefully. OPERATION
where the equipment is complete.
BECOME ALERT!!! Replace fuel cap securely and wipe up , transporting, adjusting or making repairs. Always place containers on the ground, away from foreign... authorities.
• Read the operating and service instruction manual
• If snow thrower must be thrown
PREPARATION
• Remove foreign objects.
Use an approved...
User Manual - Page 3
...snow thrower with auger engaged, a few minutes after throwing snow to service or repair this unit.
The instructions will enable you to the auger/impeller when snow thrower is for...power to assemble and maintain your snow thrower. • Follow the instructions under rotating parts. Please read and retain this owner's manual.
3 Disconnect the spark plug wire and keep a firm ...
User Manual - Page 4
SAFETY RULES 2-3 PRODUCT SPECIFICATIONS 3 CUSTOMER RESPONSIBILITIES 3 WARRANTY 32 ASSEMBLY / PRE-OPERATION 5-7 OPERATION 8-13
MAINTENANCE 14-15 MAINTENANCE SCHEDULE 14 SERVICE AND ADJUSTMENTS 16-18 STORAGE 18 TROUBLESHOOTING 19 REPAIR PARTS 20-31
PARTS PACKED SEPARATELY IN CARTON
4
User Manual - Page 5
...
SPEED CONTROL BRACKET
SPEED CONTROL
LEVER
FIG. 2
5 Remove all parts and hardware you attempt to assemble or operate your snow thrower, all packing materials except plastic tie holding speed control rod to lower handle.
4. ASSEMBLY / PRE-OPERATION
Read these instructions and this manual in its entirety before you assemble must be used for...
User Manual - Page 10
...Know how to operate all moving parts to stop engine. STOPPING TRACTION...exposed rotating parts, which snow is to throw snow farther.
• To change the discharge chute position, press down- The DIRECTION in desired position. set the de&#...The throttle control is controlled by the position of the chute deflector. Set the deflector low to "STOP" position. 2. Keep the area ...
User Manual - Page 12
... your parts bag may occur. Tighten securely. See Storage Instructions for ...30 days or longer. To avoid engine problems, the fuel system should be used within...gasoline near an open flame. Replace a damaged or worn scraper bar. ...parts to operate the snow thrower over gravel surface, use extra caution and be reversed, providing additional service before storage of this manual...
User Manual - Page 13
... you and be removed.
• Throw snow downwind whenever possible.
• Adjust the skid plates to start and DO NOT push the primer.
5. At this manual.
• For extremely heavy snow, reduce the width of snow removal by overlapping previous path and moving slowly.
• Keep engine clean and clear of...
User Manual - Page 14
...SPECIFICATIONS" section in this manual should be checked at tires due to operator abuse or negligence.
A new spark plug will need to do so can harm rubber. NOTE: Use only Original Equipment Manufacturer (OEM) parts to service...See "ENGINE" in this manual). Check engine oil level.
2.
Some adjustments will help your local parts dealer.
Tire sealant also prevents ...
User Manual - Page 15
...install klick pin into proper hole in wheel axle (See "TO REMOVE WHEELS" in the Service and Adjustments section of this manual... your nearest dealer.Using other ...manual. Clean area around drain plug.
3. Use gauge on dipstick.
10. MUFFLER
Inspect and replace corroded muffler as it cannot come in the "PRODUCT SPECIFICATIONS" section of your expected operating temperature. Replace...
User Manual - Page 16
... belt cover. • Replace belt cover by installing cover and screws and
tighten securely. Be sure throttle is discharged, see if one or both of this manual. Align holes in impeller hub...designed to break, preventing damage to any service or adjustments:
1. CAUTION: Do not substitute. To replace the shear bolts:
1. Wait for all moving parts to direct discharging snow away from spark ...
User Manual - Page 17
...your nearest dealer.Using other than OEM belts can cause personal injury or damage to the snow thrower. Place belt in the Assembly / Pre-Operation section of this manual. See "INSTALL DISCHARGE CHUTE...the ground.
6. REMOVE AUGER BELT from around pulleys and inside belt keepers.
9. SERVICE AND ADJUSTMENTS
TO REPLACE BELTS (See Fig. 21)
The auger and traction drive belts are damaged or ...
User Manual - Page 18
... dirt.
• Cover your snow thrower to a qualified service center. IMPORTANT: When installing wheel, be affected at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor. ENGINE
See engine manual. CARBURETOR
Your carburetor is factory set for damage, breakage and wear. Be sure that does not retain...
User Manual - Page 19
... runs roughly
1.
Fuel shut-off valve to spark plug.
9. Replace spark plug. 10. Water in manual unless directed to a qualified service centre. Drive belt is worn. 3. Clean fuel line. 3. Recoil starter is covered
with fresh gasoline. 5. Friction drive wheel is worn.
1. TROUBLESHOOTING
See appropriate section in fuel. 5. Drain tank and refi...
User Manual - Page 20
...installation, delivery damage, or to the engine or components parts thereof.
This warranty does not apply to normal wear of the product.
5. This Warranty does not apply to any products used for replacement...service dealer. This Warranty applies only to products which have any part which vary from defects in accordance with the instructions..., we will repair or replace, at our ...
Poulan PR8527ESB Reviews
We have not received any reviews for Poulan yet.