Poulan PPR20H42STA Support and Manuals
Get Help and Manuals for this Poulan item
View All Support Options Below
Free Poulan PPR20H42STA manuals!
Problems with Poulan PPR20H42STA?
Ask a Question
Free Poulan PPR20H42STA manuals!
Problems with Poulan PPR20H42STA?
Ask a Question
Popular Poulan PPR20H42STA Manual Pages
User Manual - Page 1
ALWAYS WEAR EYE PROTECTION DURING OPERATION
182770 2.2.02 RD Printed in serious injury. IMPORTANT MANUAL
Do Not Throw Away
OWNER'S MANUAL
MODEL:
PPR20H42STA
LAWN TRACTOR
WARNING:
Read this Owner's Manual and follow all Warnings and Safety Instructions. Failure to do so can result in U.S.A.
User Manual - Page 8
...; All assembly instructions have been completed.
✓ No remaining loose parts in the Service and Adjustments section of this manual. Be sure they are properly inflated. (For shipping purposes, the tires were overinflated at 6 amps).
✓ Seat is properly leveled side-to-side/ front-to rest on plate while in "PRODUCT
SPECIFICATIONS" section of mower deck...
User Manual - Page 11
...ENGINE - HOW TO USE YOUR TRACTOR
TO SET PARKING BRAKE (See Fig. 6)
Your tractor is running , hot engine exhaust ...tractor with the engine running , any adjustments or repairs. TO USE THROTTLE CONTROL (See Fig. 6)
Always operate engine at full throttle. • Operating engine at less than full throttle reduces the
battery charging rate. • Full throttle offers the best bagging and mower...
User Manual - Page 12
...installing gauge wheel in same adjustment hole.
3/8-16 LOCKNUT
GUAGE WHEEL MOUNTING BRACKET
3/8 WASHER
GAUGE WHEEL
SHOULDER BOLT
FIG. 7
TO OPERATE MOWER (See Fig. 8)
Your tractor...desired height of tractor. • Raise attachment lift to slowest setting. • Make...MOWER CUTTING HEIGHT" in the Operation section of this manual).
• With mower in desired height of tying hood to tractor...
User Manual - Page 14
... give the mower cutting performance as well as follows:
• Be sure the tractor is being used for five (5) seconds. Shutoff engine and set .
•...SERVICE OR REPLACEMENT, IT SHOULD BE PURGED AFTER REINSTALLATION BEFORE OPERATING THE TRACTOR. • Place tractor safely on level ground.
• Place the motion control lever in neutral. Repeat this manual. MOWING TIPS
• Mower...
User Manual - Page 16
... AS YOU COMPLETE REGULAR SERVICE
Check Brake Operation
Check Tire Pressure
Check Operator Presence and
T Interlock Systems
R Check for Loose Fasteners
A Sharpen/Replace Mower Blades
C T
Lubrication ...receive full value from the warranty, operator must maintain tractor as instructed in this manual should replace the spark plug, clean or
replace air filter, and check blades and belts for ...
User Manual - Page 17
... your local parts dealer.
Care should not start unless the clutch/brake
pedal is fully depressed and attachement clutch control is in a horizontal position. If blade is balanced. CENTER HOLE
5/8" BOLT OR PIN
BLADE
FIG. 13
17 CUSTOMER RESPONSIBILITIES
TRACTOR
Always observe safety rules when performing any attempt by the operator to mower and...
User Manual - Page 22
...
section of manual). • Work belt off both mandrel pulleys and idler pulleys. • Make sure belt is a belt installation guide decal on bottom side of all belt
guides and keepers. • Install mower (See "TO INSTALL MOWER" in highest gear on a level dry concrete or paved surface, then brake must be replaced without tools. SERVICE AND ADJUSTMENTS
TO REPLACE MOWER BLADE...
User Manual - Page 26
... it thoroughly, remove all dirt, grease, leaves, etc. CAUTION: Never store the tractor with gasoline in the Customer Responsibilities section of this manual). • Inspect and replace belts, if necessary (See belt re- placement instructions in the Service and Adjustments section of this manual). • Lubricate as shown in the tank inside a building where fumes may...
User Manual - Page 28
... worn, damaged, or broken. 3. Mower deck not level. 3. Worn, bent or loose blade. 7. Tighten blade bolt. 7. Move throttle control to "SLOW" position and allow to run 1. TROUBLESHOOTING POINTS
PROBLEM
CAUSE
Engine continues to idle for 30 seconds before stopping engine.
28
If not corrected, contact an authorized service center/ department. Replace blade mandrel. 5. Improper blades...
User Manual - Page 33
NO. CHASSIS
TRACTOR - -
inches 1 inch = 25.4 mm
33 MODEL NUMBER PPR20H42STA
KEY PART NO. DESCRIPTION
1 174619
Chassis
2 176554
Drawbar
3 17060612 Screw 3/8-16 X .75
5 155272
Bumper ... Rdhd Sht Sqnk 3/8-16 x 3/4
37 17490508 Screw Thdrol 6/16-18 x 1/2 TYT
38 175710
Bracket Asm Pivot Mower Rear
51 73800400 Nut Lock Hex W/Ins 1/4-20
52 19091416 Washer 9/32 x 7/8 x 16 Ga.
53 144697
...
User Manual - Page 39
... E/F Decal Ins Strg Whl Decal Mower Warn Keep Hand Away
KEY PART NO. NO.
inches 1 inch = 25.4 mm
39 Tube)
NOTE: All component dimensions given in U.S. DECALS
TRACTOR - -
DESCRIPTION
1 59192
Cap Valve Tire
2 65139
Stem Valve
3 170455
Tire F T 15 X 6 0 - 6 Service
4 59904
Tube Front (Service Item Only)
5 106732X421 Rim Asm 6"front Service
6 278H
Fitting Grease (Front Wheel...
User Manual - Page 43
...MODEL NUMBER PPR20H42STA
KEY NO.
1 2 3 4 5 6 8 9 10 11
13 14 15 16 18 19 20 21 23 24 25 26 27 28 29 30 31 32 33 34 36 37 40 44 45 46 48 49 50 51 52 53 54 55 56 59 67
PART... Not Included) Replacement Mower, Complete
NOTE: All component dimensions given in U.S.
PART NO.
144959 ... inches 1 inch = 25.4 mm
43 MOWER DECK
TRACTOR - -
DESCRIPTION
165892X421 72140506 138017 165460X 4939M ...
User Manual - Page 45
.../1.515 Dia. Screw 5/16-18 x 1 Washer 11/32 x 1-1/2 10 Ga. Indicator Height STLT
NOTE: All component dimensions given in U.S.
NO. inches 1 inch = 25.4 mm
45 MOWER LIFT
TRACTOR - - MODEL NUMBER PPR20H42STA
KEY PART NO.
User Manual - Page 48
... for Trimmers, Brushcutters, and Blowers). 3. Description of the nearest service dealer
(under “saws” for Chain Saws or under “lawn mowers” for parts and service should be directed to rigid quality standards. PARTS AND SERVICE
Your POULAN PRO product has been expertly engineered and carefully manufactured to your local dealer(s). For replacement parts, have available the...
Poulan PPR20H42STA Reviews
We have not received any reviews for Poulan yet.