Poulan PP927ESC Support and Manuals
Get Help and Manuals for this Poulan item
View All Support Options Below
Free Poulan PP927ESC manuals!
Problems with Poulan PP927ESC?
Ask a Question
Free Poulan PP927ESC manuals!
Problems with Poulan PP927ESC?
Ask a Question
Popular Poulan PP927ESC Manual Pages
User Manual - Page 1
Failure to do so can result in U.S.A. Always Wear Eye Protection During Operation
192044 07.27.04 BY Printed in serious injury. IMPORTANT MANUAL
Do Not Throw Away
OWNER'S MANUAL
MODEL NUMBER:
PP927ESC
SNOW THROWER
WARNING:
Read the Owner's Manual and follow all Warnings and Safety Instructions.
User Manual - Page 2
...snow. Replace fuel cap securely and wipe up , transporting, adjusting or making repairs...parts become extremely hot during op-
• Exercise caution to avoid slipping or falling especially
eration or while performing an adjustment or repair to
when operating in accordance with local inspection authorities.
• Read the operating and service instruction manual
• If snow... installed ...
User Manual - Page 3
... your purchase of your snow thrower. • Follow the instructions under rotating parts. Do not attempt to assemble and maintain your nearest authorized service center. Keep proper footing and balance at all times.
• This snow thrower is generally a warning of the snow discharge angle.
Vibration is for the cause. Walk; PRODUCT SPECIFICATIONS
Gasoline Capacity 4.0 Quarts...
User Manual - Page 5
... you attempt to lower handle.
4.
HANDLE KNOB
LOWER HANDLE
UNFOLD UPPER HANDLE
1.
INSTALL SPEED CONTROL ROD (See Figs. 1 and 2)
1. ASSEMBLY / PRE-OPERATION
Read these instructions and this manual in the parts bag. All parts such as necessary to the skid plates. Remove snow thrower from carton.
2. Insert rod into speed control bracket and secure with the...
User Manual - Page 8
... yourself with the product. KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE. DISENGAGED
ENGAGED
SNOW DISCHARGE
TRACTION DRIVE CONTROL
8 IGNITION KEY. INSERT TO START
AND RUN, PULL OUT TO STOP. Save this manual for future reference. OPERATION
KNOW YOUR SNOW THROWER
READ THIS OWNER'S MANUAL AND ALL SAFETY RULES BEFORE OPERATING YOUR SNOW THROWER. Compare the illustrations with...
User Manual - Page 10
... on the engine.
Move lever back to throw snow a short distance;
ENGINE 1. Remove (do not turn knob clockwise. Use the choke control whenever you are starting a cold engine. set the deflector higher to "STOP" position. 2. OPERATION
The operation of any adjustments or repairs. Slowly turn knob counterclockwise to stop the forward...
User Manual - Page 12
... 120 Volt A.C. To avoid engine problems, the fuel system should be sure... fresh fuel next season. See Storage Instructions for current surface conditions.
TO START ...snow thrower has been shipped, from the factory, already filled with gasoline. For removal of this manual...your parts bag may be reversed, providing additional service before storage of 30 days or longer.
Replace ...
User Manual - Page 13
... not turn the engine, proceed as follows:
13
WARNING: Do not operate snow thrower if weather conditions impair visibility. SNOW THROWING TIPS
• Always operate the snow thrower with the electric starter.
6. At this manual.
• For extremely heavy snow, reduce the width of snow removal by overlapping previous path and moving slowly.
• Keep engine...
User Manual - Page 14
..., operator must maintain snow thrower as instructed in
Maintenance section
➀ Pivot points
➁ Engine oil
LUBRICATION
Keep your snow thrower. Check for wear. NOTE: To seal tire punctures and prevent flat least once each season.
• Once a year, you should be checked at tires due to service this manual should replace the spark plug...
User Manual - Page 15
...Install drain plug and tighten securely.
5. Be sure to the drive system of your snow thrower are not adjustable. Refill engine with API service classification SG-SL. SPARK PLUG
Replace... Catch oil in the "PRODUCT SPECIFICATIONS" section of this manual).
7.
The bearings and bushings are shown in a suitable container. Check your snow thrower unless the electrical system, ...
User Manual - Page 16
... bolt and hex nut. SNOW THROWER
TO ADJUST SNOW THROWER HEIGHT
See "TO ADJUST SKID PLATES" and "SCRAPER BAR" in STOP position.
2.
Disengage all moving parts to STOP position. Align hole in auger hub with plug.
1. Install 1/4-20 lock nut and tighten securely. Remove belt cover. • Replace belt cover by installing cover and screws and...
User Manual - Page 17
...the operating position and hold the snow thrower handles. INSTALL DISCHARGE CHUTE - See "TO REMOVE BELT COVER" in the Assembly / Pre-Operation section of this manual.
4. REMOVE ENGINE PULLEY - REMOVE... BELT COVER - SERVICE AND ADJUSTMENTS
TO REPLACE BELTS (See Fig. 23)
The auger and traction drive belts are of special construction and should be replaced by original equipment ...
User Manual - Page 18
... oil. (See "ENGINE" in the Maintenance section of
IMPORTANT: Never cover snow thrower while engine/ exhaust area is an acceptable alternative in the Service and Adjustments section of fuel gum deposits during storage.Also, alcohol blended fuels
will cause problems.
See engine manual. Allow the engine to protect it thoroughly, remove all rusted or...
User Manual - Page 19
... or runs roughly
1. Move choke to FAST position. 5. Replace damaged parts. If vibration remains, contact a qualified service centre.
drive / slowing 2.
PROBLEM
CAUSE
CORRECTION
Does not start
1. Fuel shut-off valve to OPEN position.
2. Safety ignition key is flooded. 8. Out of this manual. Choke in fuel.
1. Primer not depressed. 7. Spark plug...
User Manual - Page 20
...misuse, abuse, improper assembly or installation, delivery damage, or to you...repair or replace, at our option, without charge for parts or labor incurred in replacing parts, any part...replacement under this Warranty, you have been properly assembled, adjusted, operated, and maintained in accordance with the instructions... items.
2. Outdoor Products Customer Service Dept. 250 Bobby Jones Expressway ...
Poulan PP927ESC Reviews
We have not received any reviews for Poulan yet.