Poulan PP524A Support and Manuals
Get Help and Manuals for this Poulan item
This item is in your list!
View All Support Options Below
Free Poulan PP524A manuals!
Problems with Poulan PP524A?
Ask a Question
Free Poulan PP524A manuals!
Problems with Poulan PP524A?
Ask a Question
Popular Poulan PP524A Manual Pages
User Manual - Page 1
Failure to do so can result in U.S.A. Always Wear Eye Protection During Operation
187877 Rev. 1 04.08.04 BY Printed in serious injury.
IMPORTANT MANUAL
Do Not Throw Away
OWNER'S MANUAL
MODEL NUMBER:
PP524A
SNOW THROWER
WARNING:
Read the Owner's Manual and follow all Warnings and Safety Instructions.
User Manual - Page 2
...installed...parts.
TRAINING
- Fill fuel tank outdoors with local inspection authorities.
• Read the operating and service instruction manual
• If snow thrower must be exercised while using on the ground.
WARNING: Always disconnect spark plug wire and place it where it on sloping surfaces. Replace fuel cap securely and wipe up , transporting, adjusting or making repairs...
User Manual - Page 3
..., except when starting .
• Take all times.
• This snow thrower is to service or repair this owner's manual.
3
We have stopped. Always observe the "SAFETY RULES".
Always be stored for an extended period.
• Maintain or replace safety and instruction labels, as necessary.
• Run the snow thrower, with fuel in the tank inside...
User Manual - Page 4
SAFETY RULES 2-3 PRODUCT SPECIFICATIONS 3 CUSTOMER RESPONSIBILITIES 3 WARRANTY 32 ASSEMBLY / PRE-OPERATION 5-7 OPERATION 8-13
MAINTENANCE 14-15 MAINTENANCE SCHEDULE 14 SERVICE AND ADJUSTMENTS 16-18 STORAGE 18 TROUBLESHOOTING 19 REPAIR PARTS 20-31
PARTS PACKED SEPARATELY IN CARTON
4
User Manual - Page 5
... new snow thrower has been assembled at .
3. All parts such as necessary to lower handle.
2. Cut down all packing materials except plastic tie holding speed control rod to assemble or operate your new snow thrower.
ASSEMBLY / PRE-OPERATION
Read these instructions and this manual in its entirety before you assemble must be used...
User Manual - Page 8
... their meaning.
IGNITION KEY. INSERT TO START
AND RUN, PULL OUT TO STOP.
DISENGAGED
ENGAGED
SNOW DISCHARGE
TRACTION DRIVE CONTROL
8 Save this manual for future reference. KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE. Compare the illustrations with your snow thrower or in literature supplied with the location of various controls and adjustments. These...
User Manual - Page 12
...reversed, providing additional service before storage of the housing,...problems, the fuel system should be picked up and thrown by loosening the rear 1/2" hex nut only, then moving parts... scraper bar and the ground surface.
Replace a damaged or worn scraper bar. ...manual. Use fresh, clean, regular unleaded gasoline with a minimum of snow in storage. See Storage Instructions...
User Manual - Page 13
...-up for a few minutes to help air flow and extend engine life.
• After snow-throwing is ready for current snow conditions.
At this manual.
• For extremely heavy snow, reduce the width of snow removal by overlapping previous path and moving slowly.
• Keep engine clean and clear of...
User Manual - Page 14
... as instructed in this manual). BEFORE EACH USE
1. Check controls to be made periodically to be sure they are functioning properly.
TIRES
• Maintain proper air pressure in both tires (See "PRODUCT SPECIFICATIONS" section in this manual. Tire sealant also prevents tire dry rot and corrosion.
14 Some adjustments will help your local parts dealer. A new...
User Manual - Page 15
... freely when warm.
• Catch oil in the "PRODUCT SPECIFICATIONS" section of gasoline, oil, etc.
• We do ...replace corroded muffler as it cannot come in the Service and Adjustments section of this manual.
9.
Check the crankcase oil level before next oil change. Install left wheel removed, will result in the Service and Adjustments section of this manual...
User Manual - Page 16
...shaft with spark plug.
3.
Disengage all moving parts have sheared. Disengage all moving parts to the top of this manual. Install 1/4-20 lock nut and tighten securely. Make sure... STOP position.
2.
SERVICE AND ADJUSTMENTS
WARNING: To avoid serious injury, before performing any other components. Remove belt cover.
• Replace belt cover by installing cover and screws and...
User Manual - Page 17
...manual.
With tension relieved on your snow thrower are of special construction and should be replaced. Install flat the same time. Make sure belt is important that the belt(s) be replaced by a qualified service center. See "INSTALL... wear, they should be replaced by original equipment manufacturer (OEM) belts available from your nearest dealer.Using other than OEM belts...
User Manual - Page 18
...set for damage, breakage and wear. Replace if necessary.
5. Plastic cannot breathe, which leads to 7,000 feet (2,134 meters). TO REMOVE WHEELS (See Fig. 21)
• Remove the klik pin and remove wheel from your local parts dealer... alcohol blended fuels
will cause problems.
See engine manual.
ENGINE OIL
Drain oil (with engine warm) and replace with a suitable protective cover that...
User Manual - Page 19
...replace muffler.
If vibration remains, contact a qualified service center. Drive belt is worn. 3. Drive belt is in manual unless directed to a qualified service...clean gasoline. Loose parts or damaged augers or impeller.
1. Recoil starter is flooded. 8.
TROUBLESHOOTING
See appropriate section in FULL position. 2. Prime as instructed in fuel. 5....
User Manual - Page 20
...is subject to an authorized service dealer. Transportation charges for any ... misuse, abuse, improper assembly or installation, delivery damage, or to normal wear...repair or replace, at our option, without charge for replacement under this product as defined in replacing parts...dealer from locale to locale. For a period of two (2) years from defects in accordance with the instructions...
Poulan PP524A Reviews
Do you have an experience with the Poulan PP524A that you would like to share?
Earn 750 points for your review!
We have not received any reviews for Poulan yet.
Earn 750 points for your review!