Poulan P14530ES Support and Manuals
Get Help and Manuals for this Poulan item
View All Support Options Below
Free Poulan P14530ES manuals!
Problems with Poulan P14530ES?
Ask a Question
Free Poulan P14530ES manuals!
Problems with Poulan P14530ES?
Ask a Question
Most Recent Poulan P14530ES Questions
Popular Poulan P14530ES Manual Pages
User Manual - Page 2
... birth defects or other engine parts become extremely hot during operation or while performing an adjustment or repair to a running (except when specifically recommended by the manufacturer for... immediately for all instructions on the machine and in the manual(s) before restarting and operating the snow thrower.
4. Know how to prevent accidental starting when setting up spilled fuel...
User Manual - Page 3
...reverse.
13. TABLE OF CONTENTS
SAFETY RULES 2-3 PRODUCT SPECIFICATIONS 3 CUSTOMER RESPONSIBILITIES 3 ASSEMBLY / PRE-OPERATION 4-6 OPERATION 7-12 MAINTENANCE SCHEDULE 13
MAINTENANCE 13-14 SERVICE AND ADJUSTMENTS 15-17 STORAGE 18 TROUBLESHOOTING 19 REPAIR PARTS 20-37 WARRANTY BACK PAGE
3
Never store the machine with snow throwers. To clear the chute:
1. Maintenance and Storage...
User Manual - Page 11
...Instructions for a few seconds, remove and read oil level.
three-wire grounded system. Check engine oil with a three-wire power cord and plug and is reached.
The electric starter is equipped with snow thrower on 120 Volt A.C.
Replace... service before storage of 87 octane. Do not overfill. Purchase fuel in quantities that can damage the fuel system of this manual....
User Manual - Page 13
..., you should be sure they begin to operator abuse or negligence.
Replace belts if they are not
• Maintain proper air pressure in the Service and Adjustments section of this manual). To receive full value from the warranty, operator must maintain snow thrower as instructed in Maintenance section
Pivot points
BEFORE EACH USE
1. MAINTENANCE
GENERAL...
User Manual - Page 14
... setting are shown in the Service and Adjustments section of operation or at the beginning of each season or after each five (5) hours of this manual. Clean the outside of this manual).
7. TRACTION DRIVE SYSTEM DO NOT lubricate the drive components inside the engine. (See "TO REMOVE WHEELS" in the "PRODUCT SPECIFICATIONS" section of your snow...
User Manual - Page 17
...problems, take your local parts dealer. Overspeeding the engine above the factory high speed setting can be dangerous and will void the warranty. If you think the engine-governed high speed needs adjusting, contact a service...is factory set for pushing or transporting the snow thrower) ...installing wheel, be affected at the bottom of the rod one or two holes closer to the top of this manual...
User Manual - Page 18
...REPLACE BELTS" in the Service and Adjustments section of fuel gum deposits during storage. Add stabilizer to gasoline in minimizing the formation of this manual.
4. Remove spark plug.
2. OTHER
• Remove safety ignition key; store it from dust and dirt.
• Cover your snow...in essential fuel system parts such as on ...cause problems.
• If possible, store your snow ...
User Manual - Page 19
... Safety ignition key is not inserted.
3. Loose parts or damaged augers or impeller.
1. Tighten all fasteners.
Prime as instructed in the Operation section of this manual. See "IF RECOIL STARTER HAS FROZEN" in the Operation section of this manual. 7. Contact an authorized service center/department. Blockage in OFF position. 6.
Replace spark plug. 10. Stale fuel. 11...
User Manual - Page 20
MODEL P14530ES (96198004502)
AUGER HOUSING / IMPELLER ASSEMBLY
5
15 14
4
11 6
11
16
12
13 11
3 12
10
11 7
8
17
1...
NOTE: All component dimensions given in U.S. Failure to do so could be hazardous, damage your snow thrower and void your warranty.
20 inches. 1 inch = 25.4 mm IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. REPAIR PARTS
SNOW THROWER -
User Manual - Page 25
...AS REFERENCE FOR SERVICE PARTS ONLY. inches. 1 inch = 25.4 mm IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. MODEL P14530ES (96198004502)
CONTROL PANEL / DISCHARGE CHUTE
2
2 1
*3
*7
*6
KEY NO.
1 2 *3 *4 *5 *6 *7
PART NO.
532 42... your snow thrower and void your warranty.
25
NOTE: All component dimensions given in U.S. REPAIR PARTS
SNOW THROWER -
User Manual - Page 26
...3
2 4
3 5 5
01.05.013-D
KEY NO.
1 2 3 4 5
PART NO.
585 23 81-02 532 44 36-17 817 00 05-10 817 00 06-...SUPPORT WELDMENT SCREW 5/16−18 X .750 SCREW 3/8−16 X 1.00 SCREW 3/8-16 X .750
NOTE: All component dimensions given in U.S. inches. 1 inch = 25.4 mm IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. REPAIR PARTS HANDLES
SNOW THROWER - MODEL P14530ES...
User Manual - Page 33
inches. 1 inch = 25.4 mm IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. Failure to do so could be hazardous, damage your snow thrower and void your warranty.
33
MODEL P14530ES (96198004502)
CHASSIS / ENGINE / PULLEYS
2 3
2
3 1
1
01.00.034-A
KEY NO. - -
1 2 3
PART NO. 580 42 61-01
532 42 92-75 532 15 04-06 532 42 88-67...
User Manual - Page 35
... 44 87-15 WHEEL ASSEMBLY RH
2
01.06.016-A
NOTE: All component dimensions given in U.S. inches. 1 inch = 25.4 mm IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. Failure to do so could be hazardous, damage your snow thrower and void your warranty.
35 REPAIR PARTS WHEELS
SNOW THROWER - NO. MODEL P14530ES (96198004502)
KEY PART NO.
User Manual - Page 36
REPAIR PARTS BAG OF PARTS
SNOW THROWER - Failure to do so could be hazardous, damage your snow thrower and void your warranty.
36 DESCRIPTION
532 44 30-59 SAFETY IGNITION KEY KIT
2
1
4
2
01.14.012-B
KEY NO.
1 2 3 4
PART... only Original Equipment Manufacturer (O.E.M.) replacement parts. MODEL P14530ES (96198004502)
3 2
1
01.14.004-B
45
7 6
KEY NO.
1 2 3 4 5 6 7
PART NO.
532 19 85-63...
User Manual - Page 37
... INSTRUCTION E/F DECAL, DANGER, DEFLECTOR DECAL, DANGER DECAL, CONSOLE RT SPEED LEVER POWERSTEERING DECAL, CONSOLE LT DEFLECTOR LEVER POWERSTEERING OWNER'S MANUAL, ENGLISH OWNER'S MANUAL, FRENCH
NOTE: All component dimensions given in U.S. inches. 1 inch = 25.4 mm IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. REPAIR PARTS DECALS
1 4
SNOW THROWER - MODEL...
Poulan P14530ES Reviews
We have not received any reviews for Poulan yet.