Pioneer PRS-D1200SPL - Premier Amplifier Support and Manuals
Get Help and Manuals for this Pioneer item
View All Support Options Below
Free Pioneer PRS-D1200SPL manuals!
Problems with Pioneer PRS-D1200SPL?
Ask a Question
Free Pioneer PRS-D1200SPL manuals!
Problems with Pioneer PRS-D1200SPL?
Ask a Question
Pioneer PRS-D1200SPL Videos
Pioneer PRS-D1200SPL & TS-W3001D4x2
Duration: 3:52
Total Views: 12,772
Duration: 3:52
Total Views: 12,772
AMP GUTZ! 4 nice Amps ! PRS-D1200SPL , BX-1605D , AP2000 , PCX2.700 !
Duration: 6:31
Total Views: 2,966
Duration: 6:31
Total Views: 2,966
Sony Xplod 6 10'' Build playing low ! Powered by a Pioneer Premier PRS-D1200SPL amplifier
Duration: 1:43
Total Views: 4,231
Duration: 1:43
Total Views: 4,231
15'' DC Audio Lvl 5 Sub in my Mazda on my Pioneer Premier PRS-D1200SPL Amplifier
Duration: 3:06
Total Views: 3,777
Duration: 3:06
Total Views: 3,777
Popular Pioneer PRS-D1200SPL Manual Pages
Owner's Manual - Page 2
... contact.
7 U.S.A. After-sales service for Pioneer products
Please contact the dealer or distributor from where you have any other information. Please read all instructions and WARNINGS in this PIONEER product. Keep the card handy for purchasing this manual before attempting operation. It is written on the enclosed warranty card. PIONEER SUGGESTS USING A PROFESSIONAL INSTALLER DUE TO...
Owner's Manual - Page 3
...technologies.
3 Download owner's manuals, order product catalogues, research new products, and much more. Detect the cause and solve the problem.
• Contact the ...amplifier when it is installed. Detect the cause and solve the problem, then replace the fuse with liquids due to, for the subwoofer. Electrical shock could cause damage to the product and injury including burns.
• Use...
Owner's Manual - Page 5
... an RCA equipped Pioneer car stereo with your car stereo, change the BFC switch using with the amplifier.
BFC (Beat Frequency Control) Switch
If you hear a beat while listening to match the car stereo output level. • For synced amplifier's gain control, see the "Setting the Gain for details. See the "Troubleshooting" section on .
ENGLISH
ESPA...
Owner's Manual - Page 6
...power increases only slightly. When you raise the gain of the amplifier to time, contact the nearest authorized PIONEER Service Station.
5
Setting the Unit
Setting the Gain properly
• This unit is equipped with a ...to decrease the volume of the head unit and too much output, improper use or improper connection.
• When outputting sound at increased volume of the head unit...
Owner's Manual - Page 7
...parts.
• Do not route wires where they have the same function.
6 Amplifier damage, smoke, and overheating could cause damage to the product and injury including burns. Install...amplifier will always be different colors even if they will be exceeded, causing overheating.
• Never replace...to the supplied manuals of both products ... Cords for this amplifier. Use of an improper ...
Owner's Manual - Page 11
... Do not
mix these amplifiers.
Advanced Setup of the Gain
Set each synced amplifier's gain control. These settings except for the gain control are inactive on an amplifier which has been set to the master's output using the gain control on the amplifier that has been set to measure the master amplifier's output voltage level. 3.
This setting will balance output volumes sufficiently...
Owner's Manual - Page 12
... Speaker
2 Ω Bridged Mode
Amplifier
1 Ω Bridged Mode
Amplifier
DO NOT install or use a single 2 Ω speaker. In addition, refer to achieve a 1 Ω (or lower) bridged mode (Diagram B).
Connecting the Unit
CAUTION Diagram A - Proper
Amplifier
Diagram B - Single Amplifier
MODE SELECT switch must be in parallel to the speaker instruction manual for information on the...
Owner's Manual - Page 13
... "Connection Diagram".
Two Amplifier
MODE SELECT switch must be in MASTER position. Before setting to the position, remove SYNC the screw and the stop-
MODE SELECT switch
SYNC OUTPUT
must be in MASTER position. Connecting wire with RCA pin plugs (sold separately).
1 Ω to 8 Ω 1 200 W (1 Ω)
• Use speakers having an impedance...
Owner's Manual - Page 14
... wire (sold separately). Before setting to 16 Ω.
In ....
SYNC INPUT
• Only use speakers having an impedance of connecting multiple speakers with RCA pin plugs (sold separately). Before setting to the position, remove the screw... stopper. MODE SELECT switch must be in SYNC INV position. Before setting to the position, remove the SYNC screw and the stopper. Connect to...
Owner's Manual - Page 15
...".
SYNC INPUT • Use speakers having an impedance from 1 Ω to 8 Ω.
1 Ω to 8 Ω 1 200 W (1 Ω)
1 Ω to 8 Ω 1 200 W (1 Ω)
1 Ω to 8 Ω 1 200 W (1 Ω)
1 Ω to the position, remove the screw and the stopper. MODE SELECT switch must be in MASTER
SYNC OUTPUT
position. Before setting to 8 Ω 1 200...
Owner's Manual - Page 16
... result.
• Do not install the amplifier on the floor in front of the driver's seat.
• Make sure that wires are used, they may damage internal parts of the amplifier, or they may interfere with the driver, such as on unstable places such as under the dashboard. This is installed.
In addition, the amplifier surface and the surface...
Owner's Manual - Page 17
...of installation on the floor mat or on the carpet or directly to be installed. Push on the screws with a screwdriver so they make marks where the installation holes ...2.5 mm (1/8 in .) diameter holes at the point marked, and install the amplifier, either on the chassis
1.
Replacing the terminal cover
1. Place the amplifier where it is to be located.
2. Insert the supplied tapping screws...
Owner's Manual - Page 18
... or lights up in the amplifier. When this happens, immediately discontinue use of problem has occurred in yellow when the temperature within the amplifier rises. When this happens, immediately discontinue use of the amplifier and check the location where the amplifier is still not corrected.
17 Contact your dealer if the problem is installed (see the "WARNING" section on...
Owner's Manual - Page 19
Use this unit
when an audio signal is nearly the maximum current drawn by this value when working out total current drawn by multiple power amplifiers.
18 Bass boost ...Frequency: 40 Hz to 120 Hz
... and 1% THD+N) S/N ratio 54 dBA (reference: 1 W into 4 Ω)
Note: • Specifications and the design are subject to possible modification without notice
due to 240 Hz Cut off frequency: 40 Hz...
Owner's Manual - Page 56
.... de C.V.
Tous droits de reproduction et de traduction réservés. Box 1540, Long Beach, California 90801-1540, U.S.A. TEL: (800) 421-1404
PIONEER EUROPE NV Haven 1087, Keetberglaan 1, B-9120 Melsele, Belgium TEL: (0) 3/570.05.11
PIONEER ELECTRONICS ASIACENTRE PTE. LTD. 178-184 Boundary Road, Braeside, Victoria 3195, Australia TEL: (03) 9586-6300...
Pioneer PRS-D1200SPL Reviews
We have not received any reviews for Pioneer yet.