Panasonic 26PET1U6 Support and Manuals
Get Help and Manuals for this Panasonic item
View All Support Options Below
Free Panasonic 26PET1U6 manuals!
Problems with Panasonic 26PET1U6?
Ask a Question
Free Panasonic 26PET1U6 manuals!
Problems with Panasonic 26PET1U6?
Ask a Question
Popular Panasonic 26PET1U6 Manual Pages
26PEU1U6 Owner's Manual - Page 2
... shown. Follow each installation or repair step exactly as it is rigid and strong enough to support or hold the unit, and select a location for easy maintenance.
...In a Room Properly insulate any tubing run .
Sharp edges or
For safe installation and trouble-free operation, you need for specifled refrigerant (R410A) in this manual. Pay close attention...
26PEU1U6 Owner's Manual - Page 115
... to the instruction manual that a problem has occurred in the unit, so make an inspection. (Refer to servicing information in the service manual, etc.) Also, if wired remote controller and dedicated service check lines (CV6380230938: service use) are available, then detailed error information can be obtained by connecting to the service connector as shown in the drawing. Specifications
ALL•...
26PEU1U6 Owner's Manual - Page 119
... table. (Refer to
1
"NORM." (Item 7-21-3)
7-20.
After changing the settings, press the RESET hole. Verify that model. SKN
Wireless remote controller transmitter
Set sliding switch 2 to the correct setting for that sliding switch 1 is in order to charge the crankcase heater. (2) Fully open the service valves on the gas-tube and liquid-tube sides...
26PEU1U6 Owner's Manual - Page 171
... for 3 minutes or
PCB. H01
Overcurrent
Inverter stops after alarm is connected to an independent-control indoor
Outdoor unit capacity not set. Service procedures
Remote controller alarm display
Alarm contents
F31
EEPROM trouble
Judgment condition Reading/writing failure
Clear condition Judgment and correction
Recovery at power 1. Check inter-unit control wiring. Check outdoor...
26PEU1U6 Owner's Manual - Page 184
... Outdoor MV value Frequency
* Depending on the model, some items may not be displayed.
5
5-6 During temperature monitoring, "Service Monitor" is started from the unit remote controller.)
(2) Press
the button and select the indoor unit to monitor.
(4)
(3) Use the temperature setting and buttons to select the item code of the temperature to monitor. Indoor unit...
26PEU1U6 Owner's Manual - Page 190
... following:
(1) All loose matter is removed from the cabinet especially steel filings, bits of the instruction manual, then have the customer actually operate the system.
(8) Be sure to give the instruction manual and warranty certificate to the customer.
(9) When replacing the control PCB, be hot to the new control PCB.
6. 6. Preparing for the indoor fan...
Tech Data - Service Manual - Page 1
TECHNICAL DATA &
SERVICE MANUAL
Indoor Unit
Outdoor Unit
Shows S-26PU1U6
Model No. SM830203-01 Outdoor Units
Type Outdoor Units
U Single
26 U-26PE1U6 U-26PS1U6
36 U-36PE1U6 U-36PS1U6
Shows U-26PE1U6
42 U-42PE1U6
Remarks Cooling/Heating
U-42PS1U6 Cooling
Indoor ...
Tech Data - Service Manual - Page 2
IMPORTANT!
As the installer or service person, it is rigid and strong enough to support or hold the unit, and select a location for most installation sites and maintenance conditions.
If Necessary, Get Help
These instructions are used in this system. Select an installation location which is an important part of the flare and union tubes before connecting them...
Tech Data - Service Manual - Page 3
... instructions, may be installed in a small room, select a suitable model and installation...unit to check or repair electrical parts and wiring.
•...installation instructions. For additional guidance and precautions related to refrigerant safety, please refer to check that no guarantee that interference will not exceed a set limit. WARNING
• Do not clean inside the unit being serviced...
Tech Data - Service Manual - Page 115
.... Mis-setting of signal receiving unit. Sensor button 16. Outdoor unit protector is activated. Transmitter
9. Specifications
ALL• RCU : SUB PCB CHK. Fan speed button 4. S.C. For information on how to connect to the signal receiving unit, refer to the instruction manual that a problem has occurred in the unit, so make an inspection. (Refer to servicing information...
Tech Data - Service Manual - Page 119
Specifications
Is operation
NO
possible?
Test Run Procedure
Wall mounted Type (K1 Type)
Check the "Check Items Before the Test Run."
(Item 7-20)
Verify the combination (wiring) of the wireless remote controller cover to charge the crankcase heater. (2) Fully open the service valves on the gas-tube and liquid-tube sides. (3) Set the sliding...
Operating Instructions - Page 2
... PRECAUTIONS...2 INSTALLATION LOCATION...3 ELECTRICAL REQUIREMENTS 3 SAFETY INSTRUCTIONS...3 OPERATION CONDITION ...4 NAMES OF PARTS ...5 ADJUSTING AIRFLOW DIRECTION 6 CARE AND CLEANING ...8 SPECIAL REMARKS ...10 TROUBLESHOOTING (BEFORE CALLING FOR SERVICE 11 TIPS FOR ENERGY SAVING ...11 WIRELESS REMOTE CONTROLLER 12 SPECIFICATIONS ...25
PRODUCT INFORMATION
If you have problems or questions...
Installation Instructions - Page 2
... re-installation, and while repairing refrigeration parts. Sharp edges or
For safe installation and trouble-free operation, you need for easy maintenance.
...In a Room Properly insulate any tubing run . CAUTION
This symbol refers to a hazard or unsafe practice which can cut your job to reduce strain on your certified dealer for additional instructions. This prevents water...
Installation Instructions - Page 49
...lter shows that a problem has occurred in the unit, so make an inspection. (Refer to servicing information in the service manual, etc.) Also, if wired remote controller and dedicated service check lines (CV6380230938: service use) are available, then detailed error information can be obtained by connecting to the instruction manual that came with the dedicated service check lines. For information...
Installation Instructions - Page 53
... run in the "S" position.
Verify that model. SKN
Wireless remote controller transmitter
Set sliding switch 2 to the correct settings for these models. 5-19.
Set the indoor unit controller to 5-24)
Note...the correct setting for that sliding switch 1 is in order to charge the crankcase heater. (2) Fully open the service valves on the gas-tube and liquid-tube sides. (3) Set the ...
Panasonic 26PET1U6 Reviews
We have not received any reviews for Panasonic yet.