Milwaukee Tool 2466-20 Support and Manuals
Get Help and Manuals for this Milwaukee Tool item
View All Support Options Below
Free Milwaukee Tool 2466-20 manuals!
Problems with Milwaukee Tool 2466-20?
Ask a Question
Free Milwaukee Tool 2466-20 manuals!
Problems with Milwaukee Tool 2466-20?
Ask a Question
Popular Milwaukee Tool 2466-20 Manual Pages
Operators Manual - Page 2
...changing accessories, or storing power tools.
Properly maintained cutting tools with specifically designated battery packs. A charger that cannot be controlled
ELECTRICAL SAFETY
•Power tool plugs must be ejected from moving parts. ing a power tool. Use of any other condition that have the power tool repaired before turning the power tool on invites accidents. •...
Operators Manual - Page 3
...
capacity has been overloaded or dropped. This could damage the tool and will make exposed metal parts
7
8
9
1
of battery packs should only be damaged when submerged in fire, explosion or operating instructions or you do not charge a MILWAUKEE service facility for more information.
•Store tool in anyway will cause
damage to filter out microscopic particles...
Operators Manual - Page 4
... ft-lbs Square Drive Anvil 3/8" Cat. No 2466-20 Torque Range 12.5-150 ft-lbs Square Drive Anvil 1/2"
Sound & Change ON/OFF options to hand tighten for full torque. (See "Adjusting rundown torque")
About
General information for this tool. be hazardous.
cific charging instructions, read the operator's
manual supplied with the drive anvil and push...
Operators Manual - Page 5
... shut off automatically when the set maximum rundown torque is close to the selected preset percentage and then stop driving the tool.
White: First light indicates 40% of the target achieved with ANSI Z87.1.
Check the direc- Press to save an event, to meet the desired torque specifications. Release torque. The torque reading...
Operators Manual - Page 6
..., misalignment or binding of moving parts, breakage of specification. center to be calibrated. Clear the data in liquid or
allow a liquid to a MILWAUKEE service facility for certification, tool is pressed. Remove the old battery, keep it properly. Troubleshooting
Problem Wrench does not turn on the replacement battery prior to installing. 4. tered the body, seek immediate...
Operators Manual - Page 7
... YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE. Subject to certain exceptions, MILWAUKEE will be replaced without cost for the Drain Cleaning Cables and AIRSNAKE™ Drain Cleaning Air Gun Accessories is three (3) years from the end-user guide or instruction manual. This warranty does not cover repair...
Service Parts List - Page 1
...04-9105 72 42-55-2466
DESCRIPTION OF PART
NO. SERVICE PARTS
BULLETIN NO. 54-47-0480
SPECIFY CATALOG NO. REQ. Taptite T-20 Screw (9)
Housing Cover-Right
(1)
Housing Support-Left
(1)
Spring Pin
...
Motor Plate Assembly
(1)
'U' Joint Assembly
(1)
Blow Molded Carrying Case (Tool Only) (1)
MILWAUKEE TOOL l www.milwaukeetool.com 13135 W. PART NO. 42 44 42-70-0058 45 34-40-0180 48 05-...
Service Parts List - Page 2
tub) NOTE: When servicing, remove 90-95% of grease, being sure all yoke teeth are coated. Regarding parts to installing Type 'E'. BE SURE THAT ALL COMPONENTS OF THE ELECTRONICS KIT ARE SEATED FIRMLY AND SQUARELY IN THE HANDLE RECESSES.
INSTALL BATTERY AND DEPRESS SWITCH TRIGGER TO ASSURE TOOL IS OPERATING PROPERLY.
AVOID PINCHED WIRES, BE SURE...
Milwaukee Tool 2466-20 Reviews
We have not received any reviews for Milwaukee Tool yet.