Maytag MGR5875QDB Support and Manuals
Get Help and Manuals for this Maytag item
View All Support Options Below
Free Maytag MGR5875QDB manuals!
Problems with Maytag MGR5875QDB?
Ask a Question
Free Maytag MGR5875QDB manuals!
Problems with Maytag MGR5875QDB?
Ask a Question
Popular Maytag MGR5875QDB Manual Pages
Use and Care Manual - Page 1
...
Troubleshooting 24-25
Warranty & Service 27
Guide d'utilisation et d'entretien 28
Guía de Uso y Cuidado 56
©2006 Maytag Appliances Sales Co.
A/01/08
Part No. 8113P736-60
Care & Cleaning 18-21
Self-Clean Oven Cleaning Procedures
Maintenance 22-23
Oven Window & Light Removal of Contents
Important Safety Instructions 1-4
Surface Cooking 5-6
Surface Controls Sealed Gas...
Use and Care Manual - Page 2
... CAN TIP AND CAUSE INJURIES TO PERSONS
• INSTALL ANTI-TIP DEVICE PACKED WITH RANGE
• FOLLOW ALL INSTALLATION INSTRUCTIONS
WARNING: To reduce risk of tipping of the appliance from a
neighbor's phone.
Installation and service must be necessary to make changes to adjust, repair, service, or replace any part of your gas supplier from abnormal usage or by smell alone. Use...
Use and Care Manual - Page 5
... specifically recommended in this guide. Fumes released due to overheated cooking oil, fat, margarine and overheated non-stick cookware may be equally harmful. This appliance has been tested for safe performance using glass.
Care should be taken not to rub, damage, or move the gasket. Clean only parts listed in this guide. Follow manufacturer's instructions...
Use and Care Manual - Page 6
... front burner location.
5
Expect some parts of heat settings is available from
the port if a...range.
• NEVER touch cooktop until the knob is used to HI. Push in the OFF position prior to supplying gas...setting.
• A clicking (spark) sound will not cook any of the controls are set on the LO setting if the pan is possible to the knob identify which burner the knob controls...
Use and Care Manual - Page 9
..., cleaning, or to flash.
3.
Fault Codes
BAKE or LOCK may flash rapidly in the display
• LOCK flashes while the door is an error or a problem. Clock time cannot be displayed in the display...A double beep will go into Standby Mode to set the Timer:
1. It only controls a beeper. Press the Timer pad to the appliance and call an authorized servicer.
8 To "wake up to the appliance. ...
Use and Care Manual - Page 10
...models)
When convection baking, enter your normal baking temperature. The convection fan will start to rotate.
4. Press the Convect Bake pad. • BAKE and the fan icon will flash • 000 will display. • To recall the set...is reached, one long beep will sound. • The set temperature will flash in the oven. 6. The control will start after the oven has been on page 15. ...
Use and Care Manual - Page 11
...pads. • Time can be set before setting the temperature.
• If your normal roasting time and temperature. When 75% of the set Convect Roast:
1. The control will automatically prompt you to 11 ...the oven has been on and FOOD will sound. Oven Cooking
Roasting With Convection
(select models)
When convection roasting, enter your recipe requires a preheated oven, add 15 minutes to ...
Use and Care Manual - Page 12
...8226; 00:00 flashes in the display.
2. Press Bake, Convect Bake or Convect Roast pad (select models).
6. To set a Delayed Cook & Hold cycle:
1. Select the amount of time. Press the desired function pad ...Cook & Hold
When using the Cook & Hold option, the oven begins to heat immediately after the control has been set from ten minutes (00:10) to 11 hours, 59 minutes (11:59).
3.
Delay Cook ...
Use and Care Manual - Page 16
...range will return to save a currently running Cook & Hold cycle will be displayed. (If no Cook & Hold cycle has been programmed, "nonE" is pressed, the temperature changes by 5° to indicate that the control has accepted the Favorite setting... Wait five seconds and the setting will not be complete. Press the Bake, Convect Bake or Convect Roast (select models) pad.
• The ...
Use and Care Manual - Page 22
...wipe the rack and embossed rack supports with a small amount of water... amounts of vegetable oil to set a self-clean cycle. To...filled scouring pad.
Stainless Steel (select models)
• DO NOT USE ANY... cloth. Wipe with Stainless Steel Magic Spray* (Part No. 20000008)**. • Moderate/Heavy Soil --... grain. Oven Interior
• Follow instructions on a cloth
first. • ...
Use and Care Manual - Page 25
...Troubleshooting
PROBLEM
SOLUTION
For most concerns, try these first.
• Check if oven controls have been properly set. • Check to be sure ignitor...be over 400° F. Check or replace fuse. • Check power supply.
See...location. • Check to make sure range is level. • Temperatures often vary...sure oven is not set for instructions on adjusting the oven temperature.
...
Use and Care Manual - Page 26
...there is in a fault code during cleaning. If BAKE... the Clock pad for a new range and will not unlock after self-...fault code reappears, contact an authorized servicer. This is not displayed.
• The control and...error or a problem. See page 14.
See page 8.
Fault Codes
• BAKE or LOCK may hear sounds of a self-clean cycle.
Wait a few uses. Troubleshooting
PROBLEM...
Use and Care Manual - Page 28
... in the country in -home service is covered by Maytag.
5. THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE OR PROVINCE TO PROVINCE. Service calls to correct the installation of your major appliance, to instruct you need service, first see the "Troubleshooting" section of your major appliance...
Installation Manual - Page 5
... CAN RESULT IN A GAS LEAK.
Electrical Supply Connection
The range requires 120 volts, 60 cycle alternating current from this appliance. Electrical Grounding Instructions
This appliance is required, convert appliance before installation.
--5-- In Canada the range must be disconnected from the factory set for Gas Burning Appliances and Equipment and/or local codes.
2. Checking Pressure Of...
Installation Manual - Page 6
....4 cm) with a minimum BTU/HR rating of gas range has been manufactured for LPG to gas supply at meter. THE CONNECTORS MUST BE INSTALLED WITH ADAPTORS PROVIDED WITH THE CONNECTOR.
f. CAUTION: DO NOT LIFT OR MOVE RANGE BY DOOR HANDLES, OR BACKGUARD. Include gas fittings and joints in the gas connection between the supply line shut-off...
Maytag MGR5875QDB Reviews
We have not received any reviews for Maytag yet.