Maytag MED5630MBK Support and Manuals
Get Help and Manuals for this Maytag item
View All Support Options Below
Free Maytag MED5630MBK manuals!
Problems with Maytag MED5630MBK?
Ask a Question
Free Maytag MED5630MBK manuals!
Problems with Maytag MED5630MBK?
Ask a Question
Popular Maytag MED5630MBK Manual Pages
Installation Instructions - Page 3
..., building, or area of Massachusetts, the following installation instructions apply: I Acceptable Shut-off Devices: Gas Cocks and Ball Valves installed for use shall be electrically grounded in accordance with local codes, or in the vicinity of local codes, with the National Electrical Code, ANSI/NFPA 70, or the Canadian Electrical Code, Part 1, CSA C22.1. do not use gasoline...
Installation Instructions - Page 4
...■■ Vent clamps ■■ Vent elbows and vent work Parts needed (steam models):
"Y" connector
2' (0.6 m) inlet hose
Caulking gun and compound (new vent installations)
Adjustable wrench that all models):
Tape measure
Pliers
Utility knife
Tin snips (new vent installations)
Leveling legs (4) Parts needed (not supplied with a pedestal or a stack kit. Tools needed for...
Installation Instructions - Page 5
...parts. The cord should contain:
■■ A UL Listed 30 A power supply cord, rated 120/240 V minimum. Some codes limit, or do not permit, installing dryer in longer drying times.
*Approx. Maytag® Models
IMPORTANT: Do not operate, install... Front view:
Side view: Whirlpool® Models
You will be exposed to the dryer must support dryer weight of dryer.
■■ ...
Installation Instructions - Page 6
.... Some codes limit, or do not permit, installation of installation and servicing, spacing for companion appliances, and clearances for exhaust vent with equivalent ventilation openings are acceptable.
■■ Companion appliance spacing should be large enough to allow door to the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280 (formerly the Federal...
Installation Instructions - Page 9
...authorized gas company personnel, and authorized service personnel. Propane Gas Conversion: IMPORTANT...gas with the B149.1, Natural Gas and Propane Installation Code. If connected to flare adapter fitting C. ...Guide. Examples of the gas connection to use larger pipe. NOTE: Pipe-joint compounds that an individual manual...model/serial rating plate for
lengths under 20 ft. (6.1 m) if local codes...
Installation Instructions - Page 10
...above 2,000 ft. (610 m):
■■ When installed above 2,000 ft. (610 m) a 4% reduction of the burner Btu rating shown on the model/serial number plate is close to its final location. ... Leave enough room to avoid kinking.
■■ Use only pipe-joint compound.
For a garage installation, the gas pipe height must be an additional 18" (460 mm) from dryer packaging under entire...
Installation Instructions - Page 17
... include: licensed heating personnel, authorized gas company personnel, and authorized service personnel. If connected to supply line type, size, and location....A. Closed valve B. MAKE GAS CONNECTION
(Gas models only)
WARNING
2. Plan pipe fitting connection (Option 1)
Explosion Hazard
Use a new CSA International approved gas supply line. Install a shut-off valve.
A. 3/8" flexible gas ...
Installation Instructions - Page 19
...9632; Use as few 90° turns as possible. A.
Failure to follow these instructions can be securely fastened to a noncombustible portion of mobile home and must be converted to exhaust... side, left side (all models except long vent), or through the bottom. If you prefer, you may contact your local dealer.
Standard rear offset exhaust installation B.
Standard Vent System Chart
...
Installation Instructions - Page 20
Secure vent to the type code located on the serial number plate in the inner door well. Install Vent System
1. Long Vent System Chart
Number of 90° elbows... mm) clamp. A gas model would be DJAV - NAT - Run vent to seal all joints. Do not use caulking compound to seal exterior wall opening around exhaust hood.
20
Install exhaust hood
Install exhaust hood and use duct ...
Installation Instructions - Page 21
... of the 5 ft. (1.5 m) inlet hose ends to other side of hose failure. Record hose installation or replacement dates on connector.
21 Attach washer cold inlet hose to the "Y" connector. CONNECT INLET HOSE (STEAM MODEL ONLY)
For non-steam models, skip to reduce the risk of "Y" connector. Do not use to "Connect Vent."
Turn cold...
Installation Instructions - Page 23
...is level, make sure all four legs are on. ‰‰Check for certain part replacement or repair. Gas Models: ‰‰Plug into a grounded outlet.
This odor is common when heating ... Temperature setting. If dryer will not start, check the following:
• Controls are now installed. COMPLETE INSTALLATION CHECKLIST
‰‰Check that you live in your Use and Care Guide. &#...
Installation Instructions - Page 24
... surface. Replace all parts and panels before servicing.
Failure to the door frame of the dryer. Tuck wiring into opening.
†®TORX, T20, and T25 are for models with the...to do so can result in hinge. Disconnect wiring. DOOR REVERSAL (OPTIONAL)
The following instructions are registered trademarks of dryer door frame with round and square-shaped doors. Tools needed:
...
Installation Instructions - Page 28
...screws securing the latch plate and the five screws holding the hinge assembly in place.
28 Retain or set aside.
Place the door on each side of the door. Move the door strike
Position the door...of dryer door frame, as shown. Remove the four screws above and below the door strike and set aside for later use. Using a Phillips screwdriver, remove the 13 screws securing the inner door to...
Dimension Guide - Page 2
... DIMENSIONS
WARNING: To reduce the risk of fire, electric shock, or injury to persons, read the IMPORTANT SAFETY INSTRUCTIONS and INSTALLATION INSTRUCTIONS, located in (maximum) mm (maximum)
A
Height (With feet)
381∕8
968
39
989
B
Width
27...F 90º
Product Dimensions
in (minimum) mm (minimum) in your appliance's Owner's Manual, before installing and operating this appliance.
Dimension Guide - Page 4
DETAILED PLANNING DIMENSIONS
Spacing for recessed area or closet installation
The dimensions shown are for the recommended spacing allowed.
Ƀ ...top and bottom of the door are acceptable. Ƀ Companion appliance spacing should be considered for ease of installation and servicing. Ƀ Additional clearances might be required for wall, door, and floor moldings. Ƀ Additional spacing...
Maytag MED5630MBK Reviews
We have not received any reviews for Maytag yet.