LevelOne GEL-2460 Support and Manuals
Get Help and Manuals for this LevelOne item
View All Support Options Below
Free LevelOne GEL-2460 manuals!
Problems with LevelOne GEL-2460?
Ask a Question
Free LevelOne GEL-2460 manuals!
Problems with LevelOne GEL-2460?
Ask a Question
Popular LevelOne GEL-2460 Manual Pages
Manual - Page 1
GEL-2460
24-Port L2 Managed Gigabit Ethernet Switch, 2 Ports SFP/RJ45 Combo User Manual
V1.0
Digital Data Communications Asia Co., Ltd. http://www.level1.com
Manual - Page 8
...-negotiation for port speed and duplex mode Supports the port speed and duplex mode settings Supports Full/Half duplex transfer mode for 10 and 100Mbps and Full duplex transfer
mode for choosing the GEL-2460 24-Port Intelligent Managed Gigabit Switch from levelone technologies co. The GEL-2460 is a 24-Port, layer 2 wire-speed, intelligentmanaged gigabit...
Manual - Page 9
... through the
console port Prevents concurrent logins from different computers Supports password change Supports online firmware upgrade Supports factory default settings restore Supports configuration backup and restore
1.2 Technical Specification
Item
Specification
Dimension (L × W × H) 440mm × 230mm × 44mm
Ports
24 10/100...
Manual - Page 10
...has priority over the corresponding RJ-45 port. http://www.level1.com
Figure 1-1 Front Panel of the GEL-2460 Switch contains the LEDs, 24 10/100/1000M RJ-45 ports, 2 Gigabit SFP combo ports, a... Humidity
5% to 90% relative humidity, non-condensing
Table 1-1 Technical Specification
1.3 Physical Characteristics
1.3.1 Front Panel
As shown in Figure 1-1, the front panel of GEL-2460
Page 3
Manual - Page 14
... areas on the flat surface.
2.3 Connecting Network Devices
To connect network devices to the GEL-2460 Switch, follow these steps: Step 1 Make sure all devices you can use either a...Rack
2.2.2 Installing the Switch on a Level Surface
To install the Switch on a level surface (such as a desktop or shelf), follow these steps: Step 1 Place the Switch upside down on the Switch support auto MDI...
Manual - Page 15
...power to the Switch, follow these steps:
Step 1
Connect one end of the Switch.
The GEL-2460 Switch does not have an on the rear panel of the power cord to the power connector ...you can verify that the power cord is powered on the Switch. Chapter 2 Hardware Installation
2.4 Connecting the Power
The GEL-2460 Switch will enter the self-test phase. If not, check to a grounded three-prong...
Manual - Page 22
... the commonly used bLevelOneons in the same Network Topology
broadcast domain, which support topology discovery protocol.
Administration
Configuration Firmware Upgrade
It allows you to backup and restore the system configuration, and reset the Switch to factory default settings
It allows you to upgrade firmware. Restart
It allows you to restart the Switch.
Delete
Click to...
Manual - Page 57
...the same basic settings, speed and duplex mode can configure LACP in a LAG share the same operational key. For example, if you want to aggregate Port 2, 3, 4 and 5 on the local GEL-2460 Switch and ...://www.level1.com
Page 50 Refresh: Click to view the latest LACP status information.
7.3.3 LACP Settings
To configure a dynamic LAG, you only need to enable LACP on its aggregation capability. If the...
Manual - Page 78
...of a selected remote switch, it will automatically set that port's IP filtering mode to retrieve the configuration files of the selected remote switches.
Requirements
In this example (see Figure 8-16), there are four GEL-2460 switches in the Security > IP Filtering page... to the selected remote switches. Distribute Config: Click to distribute configuration to factory default settings.
Manual - Page 80
...Requirements
In this example (see Figure 8-17), there are four GEL-2460 switches in the Configuration File List.
Then you can view the...
8.1.4.2 Example 2 -
Step 4 Click the Rate Limiting hyperlink, set the Port 1's Egress Rate and Ingress Rate to No Limit, ...through the SW254. In the Remote Switch Discovery List, enter the password of the SW251. Step 3 Click the Port-based VLAN hyperlink...
Manual - Page 95
... table to communicate with the Switch. The switch then forwards any future frames destined for a specific amount of flooding all ports except the one which received the frame, and records the frame.../Port binding. On the GEL-2460 Switch, static MAC address is empty. The switch dynamically builds the address table by MAC Address Aging Time), it cannot be manually removed. In addition, a...
Manual - Page 103
...path and name in order for the
new firmware to factory default settings before upgrade. 3. Chapter 10 Administration
10.3 Firmware Upgrade
Figure 10-3 Firmware Upgrade
Current Firmware Version: It displays the version of levelone technologies co. http://www.level1.com
Page 96
Select a Firmware File: Click the Browse bLevelOneon to choose the firmware file you reset the Switch to take...
Manual - Page 105
Appendix A Contact Information
Appendix A Contact Information
If you have any questions regarding the operation or installation of the GEL-2460 Switch, please contact us in any of the following ways. Technical Support Phone: +886-0800-011-110 LEVELONE Forum: http://www.level1.com/ E-mail: support@level1.com
http://www.level1.com
Page 98
Manual - Page 106
... Wizard - Link Aggregation Group (Edge Switch 20 Figure 4-6 Setup Wizard - Password Settings 18 Figure 4-3 Setup Wizard - Switch Type Settings 19 Figure 4-5 Setup Wizard - Appendix B Figure Index
Appendix B Figure Index
Figure 1-1 Front Panel of GEL-2460...3 Figure 1-2 Rear Panel of the Switch ...5 Figure 2-1 Installing the Switch in a Rack 7 Figure 3-1 Entering IP address in the...
EU Declaration of Conformity - Page 2
...GTL-5260
Conforms with the essential requirements of the EMC Directive 2004/108/EC, 2006/95/EC, based on the following specifications applied:
EU harmonised standards EN 55022: 2010 EN61000-3-2:2006+A1:2009+A2:2009 ...
2014/12/18 The symbol confirms that the following apparatus
Type
Ethernet switch
Brandname LevelOne
Product GEL-2460, GEL-2461.
LevelOne GEL-2460 Reviews
We have not received any reviews for LevelOne yet.