KitchenAid UXT4230ADS Support and Manuals
Get Help and Manuals for this KitchenAid item
View All Support Options Below
Free KitchenAid UXT4230ADS manuals!
Problems with KitchenAid UXT4230ADS?
Ask a Question
Free KitchenAid UXT4230ADS manuals!
Problems with KitchenAid UXT4230ADS?
Ask a Question
Popular KitchenAid UXT4230ADS Manual Pages
Use & Care Guide - Page 1
... matières 2
Models/Modèles: UXT4230AD/UXT4236AD
IMPORTANT: READ AND SAVE THESE INSTRUCTIONS. All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING." 30" (76.2 CM) AND 36" (91.4 CM) RANGE HOOD
Installation Instructions and Use & Care Guide
For questions about features, operation/performance, parts, accessories or service, call: 1-800-253...
Use & Care Guide - Page 2
...is needed for examination and/or repair.
■ Sufficient air is...switched on low or medium settings.
■ Always turn ...servicing or cleaning the unit, switch power off the burner. READ AND SAVE THESE INSTRUCTIONS
TABLE OF CONTENTS
RANGE HOOD SAFETY 1 INSTALLATION REQUIREMENTS 3 INSTALLATION INSTRUCTIONS 6 RANGE HOOD USE 10 RANGE HOOD CARE 10 WIRING DIAGRAM 11 ASSISTANCE OR SERVICE...
Use & Care Guide - Page 3
... that are factory set for vented installations.
Consult the cooktop/range manufacturer installation instructions before starting installation. See the "Assistance or Service" section for Manufactured Home Installation 1982 (Manufactured Home Sites, Communities and Setups) ANSI A225.1/NFPA 501A, or latest edition, or with installation clearances specified on the model/serial rating plate...
Use & Care Guide - Page 4
...be as close as part of elbows should be ...cm)
models and 36" (91.4 cm) minimum cabinet width for this model. E....installations.
■ Do not terminate the vent system in an attic or other enclosed area.
■ Do not use of makeup air systems when using ventilation systems greater than specified CFM of 50 ft (15.2 m) for specific...). Makeup Air Local building codes may require the use a...
Use & Care Guide - Page 5
...located behind the filter on the model/serial rating plate. The model/serial plate is required.
■...hood.
■ Wire sizes must conform to seal all joints in the system. Aluminum/copper connection must conform with local codes...Code, Part 1 and C22.2 No. 0-M91 (latest edition) and all local codes and ordinances.
5 If codes permit and a separate ground wire is used .
■ Do not install...
Use & Care Guide - Page 6
...the upper cabinet. With a pencil, mark the upper holes on the brackets.
■ Set the range hood on its back on your model, determine which venting method
to use: roof, wall or non-vented (recirculating).
■ It is installed. Disconnect power
3.
INSTALLATION INSTRUCTIONS
NOTES: ■ Depending on a covered surface.
■ Using a #2 Phillips screwdriver, remove the rectangular...
Use & Care Guide - Page 7
... tab. For a non-vented (recirculating) installation: Go to Step 7. For a top vented installation: Mark the 4 vent hole locations (C) on the bottom of the cabinet:
- Position the side edges of the plate with one hand and bend each mounting tab (A) upward approximately 90°. Remove the range hood and set it aside.
■ Using the...
Use & Care Guide - Page 8
... the range hood as accessories. Insert the screws approximately 2 turns into the mounting tab (F) on ordering, see the "Assistance or Service" section.
■ If installing the optional round...
8.
NOTE: An optional 7" (17.8 cm) round damper (A), Part Number W10355451, and a 7" (17.8 cm) round vent mounting plate (B), Part Number W10388168, are available as shown in the inset.
7. Go ...
Use & Care Guide - Page 9
... Hood Use" section. OPTIONAL: If you prefer, bend the rear tabs against the cabinet side walls. Use copper wire.
Power Cord Kit Installations
For optional power cord kit installations, follow the instructions supplied with vent clamps or duct tape to the National Electric Code or CSA standards and local codes and ordinances. See the "Assistance or Service...
Use & Care Guide - Page 10
... Stainless Steel Cleaner and Polish, Part Number 31462A (not included): See the "Assistance or Service" section to the right 2 positions for Low (night light). Filter retainer
■ For stainless steel models, rub in a dishwasher or hot detergent solution. Dispose of the hood. For best results, start the hood before operating hood.
Replace the grease filter before cooking...
Use & Care Guide - Page 11
... Hz
Amperage
1.2 ±10% A
Wattage Rating 73 ±10% Watts
Motor Resistance
White -
Replace the lens cover by squeezing the cover and inserting the tabs into the socket.
4. Low - Red...before calling service. High
1
2
Lamp Switch Operation
1 - 2 Off
L
3
1 - 3 Low 1 - Replacing the Incandescent Light Bulb
Turn off the range hood and allow the light bulb to cool....
Use & Care Guide - Page 12
... can write to local dealers, repair parts distributors, and service companies. ASSISTANCE OR SERVICE
If you need service Please refer to the warranty page in this manual
If you need replacement parts If you need to fulfill the product warranty and provide after -warranty service, anywhere in the United States.
■ Features and specifications on our full line of appliances...
Use & Care Guide - Page 13
... of the Use and Care Guide, scan the QR code on how to correct defects in materials and workmanship and is installed, operated and maintained according to instructions attached to or furnished with original model/serial numbers removed, altered or not easily determined. Please take a few minutes to review the Troubleshooting or Problem Solver section of God or...
Warranty Information - Page 1
... purchase including dealer or retailer name and address
IF YOU NEED SERVICE:
1. Travel or transportation expenses for Factory Specified Replacement Parts and repair labor to Whirlpool within 30 days.
9. The cost of repair or replacement under this major appliance, you . This warranty gives you specific legal rights, and you want a longer or more comprehensive warranty than the...
KitchenAid UXT4230ADS Reviews
We have not received any reviews for KitchenAid yet.