KitchenAid KUIC18PNXS Support and Manuals
Get Help and Manuals for this KitchenAid item
View All Support Options Below
Free KitchenAid KUIC18PNXS manuals!
Problems with KitchenAid KUIC18PNXS?
Ask a Question
Free KitchenAid KUIC18PNXS manuals!
Problems with KitchenAid KUIC18PNXS?
Ask a Question
Most Recent KitchenAid KUIC18PNXS Questions
My Model Kuic18pnts Kitchen Aide Stand Alone Ice Maker Occasionally Turns Off. I
(Posted by Billat201 8 years ago)
Kitchenaid Ice Machine Kuic18pnxs
Looking for a second opinion. The unit turns off by itself. We turn it on and it makes a batch of ic...
Looking for a second opinion. The unit turns off by itself. We turn it on and it makes a batch of ic...
(Posted by sharronwhite7 8 years ago)
My Under The Counter Ice Maker Is Leaking From The Inlet Valve
(Posted by Anonymous-36406 12 years ago)
My Under The Counter Ice Maker Inlet Valve Is Leaking
(Posted by Anonymous-36406 12 years ago)
Popular KitchenAid KUIC18PNXS Manual Pages
Use & Care Guide - Page 2
...7 How Your Ice Maker Works 7 Using the Controls 7
ICE MAKER CARE 8 Cleaning ...8 Vacation and Moving Care 10
TROUBLESHOOTING 11 Ice Maker Operation 11 Ice Production 11 Ice Quality 12 Plumbing Problems 12
ASSISTANCE OR SERVICE 12 In the U.S.A 12 In Canada 12
WARRANTY 13
TABLE DES MATIÈRES
SÉCURITÉ DE LA MACHINE À GLAÇONS 14
INSTRUCTIONS D'INSTALLATION 14...
Use & Care Guide - Page 3
... (on some models) is important for electrical and plumbing fixtures
B. It is not pinched between 70°F (21°C) and 90°F (32°C).
18" (45.7 cm)
A. If needed, you remove all parts and panels before operating. ■ Use two or more people to move and install ice maker.
SAVE THESE INSTRUCTIONS
INSTALLATION INSTRUCTIONS
Unpack the Ice Maker
WARNING
Excessive...
Use & Care Guide - Page 4
... cord having a 3 prong grounding plug. Replace the filter if necessary.
■ Allow the storage tank on the bottom front of the ice maker.
Faucet capacity reverse osmosis systems are on top of the legs.
7. Use shims to add stability when needed : Gather the required tools and parts before starting installation. ■ 9" level
■ Adjustable wrench...
Use & Care Guide - Page 5
... water pipe. Then tighten it will remain above freezing.
4. NOTE: To avoid rattling, be installed in areas where temperatures will go. Insert end of water.
2. Ferrule (purchased) D. Vent hose (drain pump models only) C. Be sure both ends of the ice maker cabinet as shown. Bend the copper tubing to connect the copper tubing. A B
D
A. Tighten...
Use & Care Guide - Page 6
... these guidelines when installing drain lines. Items stored on top of the refrigerant or the water line. This will help keep water from flowing back into the ice maker storage bin and ...,
your local sanitation code, seal the cabinet to properly place the ice maker:
WARNING
Electrical Shock Hazard Plug into a grounded 3 prong outlet. An Insulation Sleeve kit, Part Number W10365792, is available...
Use & Care Guide - Page 7
...ice
maker. ■ Allow 24 hours to make ice.
3.
The
indicator light will monitor the ice levels. If the service light turns on again, call for the next ice making cycle.
5. It is not refrigerated... minerals is designed to be sure to set
the ice maker control to OFF. ■ The ice maker is drained after each cycle ends, you first start ice production, press ON. 2. The grid ...
Use & Care Guide - Page 8
... the steps below. Look for Part Number 4396808. Replace all handling information on the water pan.
Ice Maker System
Minerals that the cleaning cycle is . Cleaning the system regularly helps remove the mineral scale buildup. With hard water of a good household appliance cleaner and wax will have either thin ice or no ice.
WARNING
Electrical Shock Hazard...
Use & Care Guide - Page 9
...145°F (63°C).
11. Check the following instructions.
■ Replace the ice scoop holder by pushing back on the bottom with a...set properly and that hold the cutter grid cover in place. Replace the drain cap securely on the top.
NOTE: Make sure the plastic spacer from the left -hand screws. A. Ice scoop holder
10. Rinse in ice maker or reconnect power.
17. Replace...
Use & Care Guide - Page 10
...Drain water from the drain line. Unplug ice maker or disconnect power.
2. Base grille screws
10 To shut down the ice maker: 1.
Remove the two screws in the lower access panel and the two screws from storage bin.
3.
For ice makers with a drain pump installed:
Electrical Shock Hazard Disconnect power before operating. Remove all parts and panels before servicing. A A
B B
A.
Use & Care Guide - Page 11
... plate and the cutting grid? Water is securely attached to follow these instructions can result in the drain tube? If the ice maker is normal. Be sure that the drain cap is tight and the water drain pan pump is added once per ice-making process.
■ Is there a "whooshing" sound? Replace all parts and panels before servicing.
Use & Care Guide - Page 12
...; Accessory and repair parts sales.
■ Referrals to align the drain. Failure to be filtered or treated.
■ Is there mineral scale buildup? NOTE: Service technicians cannot repair plumbing problems outside of a service call us to better respond to build every new KITCHENAID® appliance. It may need further assistance, you can write to move and install ice maker. If you...
Use & Care Guide - Page 13
... to know your major appliance, to replace or repair house fuses, or to use or when it . Dealer name Address Phone number Model number Serial number Purchase date
13 KITCHENAID® ICE MAKER WARRANTY
LIMITED WARRANTY
For one year from the date of purchase, when this major appliance is operated and maintained according to instructions attached to or furnished with...
Dimension Guide - Page 1
... carry water to accommodate drainage from either a gravitydrain system or condensate pump to carry the water to be closed-in accordance with product.
Ice Maker
PRODUCT MODEL NUMBER
CABINET OPENING DIMENSIONS
KUIC18NNX KUIC18PNX
KUIS18NNX
KUIS18PNX
Electrical: A 115 Volt, 60 Hz., AC only, 15- s The floor drains must maintain a 1" (2.54 cm) air gap between 70°F (21...
KitchenAid KUIC18PNXS Reviews
We have not received any reviews for KitchenAid yet.