Kenwood TK-3407 Support and Manuals
Get Help and Manuals for this Kenwood item
View All Support Options Below
Free Kenwood TK-3407 manuals!
Problems with Kenwood TK-3407?
Ask a Question
Free Kenwood TK-3407 manuals!
Problems with Kenwood TK-3407?
Ask a Question
Kenwood TK-3407 Videos
B? ?àm kenwood tk 3407
Duration: :36
Total Views: 29
Duration: :36
Total Views: 29
Máy b? ?àm kenwood tk 3407
Duration: 1:03
Total Views: 84
Duration: 1:03
Total Views: 84
TK-3407 Kenwood - ????? ???????????????? ??????????? ???????????? | ??????????
Duration: 6:06
Total Views: 23
Duration: 6:06
Total Views: 23
Popular Kenwood TK-3407 Manual Pages
Operation Manual - Page 1
INSTRUCTION MANUAL
VHF FM TRANSCEIVER
TK-2407
UHF FM TRANSCEIVER
TK-3407
© B62-2480-10 (M)
Operation Manual - Page 2
... within the territories under government control.
◆ Illegal operation is punishable by KENWOOD. • If the die-cast chassis or other transceiver part is damaged, do not
touch the damaged parts. • If a headset or headphone is used for transmission for firmware embedded in water. • Always switch the transceiver power off . • Do...
Operation Manual - Page 3
... an abnormal odor or smoke is possible for any metallic parts are exposed from the transceiver, and contact your ear. Transmitting at gasoline service stations. • Near explosives or blasting sites. • In aircrafts. (Any use of the transceiver must follow the instructions
and regulations provided by the airline crew.) • Where restrictions...
Operation Manual - Page 6
... or high pressure container! If the battery pack is deformed, or seems abnormal for longer than the specified time!
iv The battery may cause eye-problems.
• Do not charge the battery for any other reason, remove it from fire! • Do not touch a ruptured and leaking battery! Electrolyte leaking from...
Operation Manual - Page 7
.... Supplied Accessories
• Speaker/ microphone jack cover 1 • Speaker/ microphone locking bracket 1 • Belt clip (KBH-10 1 • Screw (M3 x 8 mm 1 • Channnel stopper 1 • Instruction manual 1 Note: Refer to "PREPARATION" for accessory installation instructions.
If any of the items listed below are missing or damaged, file a claim with the carrier immediately.
Operation Manual - Page 8
... by holding the antenna at channel 1, the Channel selector knob may not install correctly and the channel may damage the antenna and degrade your transceiver's performance.
PREPARATION
INSTALLING THE CHANNEL STOPPER
For transceivers with less than 16 channels, insert a Channel stopper.
1 Set the Channel selector to channel 1, then pull the Channel selector knob...
Operation Manual - Page 12
INSTALLING THE OPTIONAL SPEAKER/ MICROPHONE (OR HEADSET)
Note: The transceiver is not fully water resistant when using a speaker/ microphone or headset.
1 Insert the speaker/ microphone (or ...
Operation Manual - Page 14
...then hold this key to enter Emergency mode.
■ Key Lock Press this key to transmit a 2-tone code.
■ Autodial DTMF Autodial allows you to make a private call to another party.
■ Calling ...Alert A calling alert tone allows you are making a call . Your dealer may have set some keys to activate a function is turned OFF and then ON again, the Key Lock function will...
Operation Manual - Page 15
... to change the transmit power to low power (you cannot change low transmit power channels to use high power).
■ Monitor Press this key to set the current channel as Key Lock except that when the transceiver power is turned OFF and then ON again, the keys remains locked.
■ Lone...
Operation Manual - Page 16
... be unable to switch between the external speaker (earpiece speaker) or internal speaker (transceiver speaker). Contact KENWOOD dealer for further information.
■ Send the GPS data Press this key when the GPS unit has been installed to send your positioning data to the base station.
■ Speaker Switch Use this key.
■...
Operation Manual - Page 17
... the speaker.
4 To make a call (FleetSync signaling, etc.)
Blinks red/orange
The selected channel has not been programmed and cannot be used.
* Your dealer can set the LED to receive.
Operation Manual - Page 18
...9670; The transceiver will automatically return to normal operation if no action is performed for specific channels by your dealer. This feature must first be activated by your dealer, and ... power OFF and the ON again to transmit hands-free. This function can change this setting for each channel by selecting a channel with the Channel selector). When turned ON, a... a supported headset.
Operation Manual - Page 19
... indicator blinks red when the battery needs recharged or replaced.
Battery Saver
When activated by your transceiver. Note: While the Battery Saver is operating, the LED may flash green when receiving a QT/DQT signal which does not match the QT/DQT tone/code set up in use.
Release the PTT switch to sound...
Operation Manual - Page 20
...STUN When a transceiver is lost or stolen (for example), your dispatcher can transmit a stun code to that transceiver to disable transmission or transmission/reception. Signaling
■ QT/ DQT The Encoder/...ID, Transpond with a stun reset code. Stun can be cancelled with ID, and "Wild Card" Group Calling.
■ FleetSync Utilizing JVC KENWOOD's FleetSync digital signaling protocol, this ...
Operation Manual - Page 40
ڦ
■ QT/ DQT QT/ DQT
■ DTMF 隨帶的 DTMF PTT ID DTMF ID、帶 ID Wild Card
■ FleetSync JVC KENWOOD 的 FleetSync PTT ID 1 或ਉ၌ 2
■ MDC-1200 MDC 信號：PTT ID
PTT ID PTT ID 信號。
14
Kenwood TK-3407 Reviews
We have not received any reviews for Kenwood yet.