Kenmore 4812 - Elite 27 in. Double Wall Oven Support and Manuals
Get Help and Manuals for this Kenmore item
View All Support Options Below
Free Kenmore 4812 manuals!
Problems with Kenmore 4812?
Ask a Question
Free Kenmore 4812 manuals!
Problems with Kenmore 4812?
Ask a Question
Kenmore 4812 Videos
4812 Cowlitz Blvd. Richland WA | Kenmore Team
Duration: 3:44
Total Views: 628
Duration: 3:44
Total Views: 628
Popular Kenmore 4812 Manual Pages
Installation Instructions - Page 1
...
pin 316454913 EspaSol-
Be sure to the Consumer = Keep these instructions with your Use & Care Guide for proper electrical and gas supply, and the stability of this I
manual is installed and grounded properly by a qualified installer, service agency or the gas supplier. READ AND SAVE THESE iNSTRUCTiONS FOR FUTURE REFERENCE.
• ALL RANGES CAN TiP
• INJURYTO...
Installation Instructions - Page 2
.... Special instructions for proper burner combustion. To eliminate the need to this appliance.
= Be sure your range is not applicable, the Standard for Mobile Home Construction and Safety, Title 24, HUD (Part 280)] or, when such standard is installed and grounded properly by a qualified installer or service technician.
= This range must conform with local codes or, in...
Installation Instructions - Page 3
...conduit (48" MAXIMUM LENGTH)for hard wiring installation only). For gas conversion (LP/Propane or Natural): Open end wrench - 1/2" (Fig. 11).
Gas line manual shut-off valve (Fig. 16). 1/2"... screws (bracket and screws are supplied with the new flexible appliance conduit for connection of LP/Propane gas (Fig. 15). A new flexible metal appliance conduit (1/2" N PT x 3/4" or 1/2" I .D.) supplied...
Installation Instructions - Page 4
...cabinets above the surface units should not exceed 4" height form the floor.
B
Back Wall
Install a flush mount 240V 40/50 ampere electrical wall outlet in the wall or floor where... are minimal unless otherwise stated.
18"
Minimum on either side of 5" beyond cabinet front by installing a range hood that projects horizontally a minimum of
13"
Maximum
depth for proper electrical and gas...
Installation Instructions - Page 5
... bracket to fit flush against wall, remove molding or mount bracket to tilt it . For models with a warmer drawer or broiler compartment, grasp the top rear edge of the range will be... placed on an open door or if a child climbs upon it forward. Installation with cabinets and wall
Anti-tip bracket installation instructions
= Locate the Bracket Using the Template - (Bracket may be positioned on ...
Installation Instructions - Page 6
...INSTALLATION INSTRUCTIONS ARE NOT FOLLOWED OR STRAIN RELIEF BRACKET IS DISCARDED. See Step B in accordance with upturned ends. NOTE: Only usecopper wire in range compartment. This appliance...exisiting installations
3 Wire Wall Receptacle (10=50R)
Fig. 28
Electrical connection requirements
This appliance must haveeither four (4) or three (3) conductors (See Fig. 28). Cord must be replaced ...
Installation Instructions - Page 7
... in.
1-1/8 in. 1-3/8 in the frame where the ground screw was originally installed (See Fig. 33).
5. To remove, loosen center screw (one screw) and...appliance. Fig. 30
Rear
of electrical connection may occur if these 3 nuts are tightened securely and replace the rear access cover (See Fig. 30). Hole
(See Chart)
Wiring instructions (4-wire connection - See fig. 33)
Before wiring the range review...
Installation Instructions - Page 8
Range installation instructions
OR _S _ 3-Wire connection instructions (for any reason, a separate ground wire must be attached to an adequate ground source.
For 3 & 4=Wire permanent connections ONLY
3 = Wire permanent 1,2 & 5 below . connection connection
= follow = follow
Steps Steps
Before wiring the range, review the suggested power source location drawings in Fig. ...
Installation Instructions - Page 9
... compression connections must be set at approximately 22in./Ibs. Be sure to install using the ground screw & plate as shown in Fig. 36. Remove the factory installed ground screw & plate...Regulator Location and Installation of the appliance. Cut and discard the copper strap from the ends of electrical connection may occur if these 3 nuts are tightened securely and replace the rear access...
Installation Instructions - Page 10
... gas supply line (Refer to range, review the suggested power source location drawings (Figs. 1,3 & 4). Range installation instructions
Provide an adequate gas supply.
if regulator has been converted for gas leaks. Do not use the 2 Flare Adapters supplied with inside diameter of combustion and ventilation air. Before servicing, disconnect electrical supply at least 11 inches...
Installation Instructions - Page 11
...separately until burner ignites. Be sure to follow the Installation Instructions before installing and using your new range.
2. Note: The...Skirts.
1. Remove all packing tape from cooktop area. Replace the Burner Heads and Caps on the cooktop. To ... Heads (Fig. 38). 5. Visually check that the flexible appliance conduit does not become
pinched or kinked! Carefully slide range ...
Installation Instructions - Page 12
... level the range and check gas connections for proper anti-ti p anchoring instructions. Range installations steps Adjust the "LO" setting of the appliance. Push in and turn of this document for leaks. Care, cleaning and maintenance
Refer to the Use & Care Guide for servicing and cleaning. Disconnect the gas and electrical supply. Finish removing the range...
Kenmore 4812 Reviews
We have not received any reviews for Kenmore yet.