Kenmore 33176 - Power Miser 12 Support and Manuals
Get Help and Manuals for this Kenmore item
View All Support Options Below
Free Kenmore 33176 manuals!
Problems with Kenmore 33176?
Ask a Question
Free Kenmore 33176 manuals!
Problems with Kenmore 33176?
Ask a Question
Most Recent Kenmore 33176 Questions
Water Heater Shuts Down 1-2 Minutes After Start Up When Reignitings Pilot Light
water heater shuts down 1-2 minutes after start up when reignitings pilot light to put water heater ...
water heater shuts down 1-2 minutes after start up when reignitings pilot light to put water heater ...
(Posted by crfettuccine 3 years ago)
Is There An Energy Guide For This Model?
(Posted by jimmyhogu 11 years ago)
Anode Rod
I have a kenmore power miser 12 80 gallon electric tank - where do I find the anode rod and can it b...
I have a kenmore power miser 12 80 gallon electric tank - where do I find the anode rod and can it b...
(Posted by rogers6540 11 years ago)
Popular Kenmore 33176 Manual Pages
Owners Manual - Page 3
... to instruction manual for safe temperature setting. Explosion Hazard -
Temperature limiting valves are at highest riskfor scald injury. Read instruction manual for installation and service.
o Properly sized temperature and pressure relief valve must be installed in severe injury or death. Do not obstruct water heater air intake with codes. improper installation and...
Owners Manual - Page 5
...and your local
dealer, wholesaler, public utilities or California Office of The National Fuel Gas Code ANSI Z223.1/NFPA 54.
See instructions
for purchasing a Kenmore water heater.
Abbreviations
Found In This instruction Manual:
UL- Energy Policy Act
This gas-fired water heater is available from the Canadian Standards
Association, 8501 East Pleasant Valley Rd, Cleveland Ohio...
Owners Manual - Page 12
.... Valves for safe temperature setting.
The minimum short side dimension
of these people or at highest riskfor scald injury.
Read instruction manual for
reducing point of installed gas utilization equipment.
12
HOT WATER
OUTLET
{
COLD WATER INLET
TEMPERED WATER OUTLET
*MIXING VALVE
FROM HOT WATER
OUTLET ON WATER HEATER
TO COLD WATER
LET ON WATER HEATER
FIGURE 15,
Toxic...
Owners Manual - Page 13
... Troubleshooting
Guide or contact
local plumbing authority or local Sears Service Center on this system. Figure 16 shows the typical attachment of problems. When
these types of the water piping to match existing piping. NOTE: If using copper tubing, solder tubing
before attaching the adapter to cold water inlet. . Look at the top cover of the water heater...
Owners Manual - Page 15
...local Sears Service Center or gas supplier to aid you in determining the proper venting for your water heater from the hot water faucet before turning "ON" gas to the water heater.
Never operate the water heater unless it fails to completely
reset and continues to release water, immediately close the
cold water inlet to the water heater, follow the draining
instructions, and replace the...
Owners Manual - Page 18
... the lines before changing temperature. Do not touch any part has been under water, immediately contact a qualified installer or service agency to "OFF". Do not use this appliance if any electric switch; It must be located by turning thermostat dial fully clockwise f_ until it . LIGHTING INSTRUCTIONS
FIGURE A
FIGURE e
FIGURE C
THERMOCOUPLE
BURNER TUIBE
IGNITOR GENERATOR...
Owners Manual - Page 19
Read instruction manual for installation
of the
valves. Water heated to be permanently
injured by hot water than 5 minutes
FIGURE 23.
19 Mixing
valves are available at highest riskforscald injury. Follow manufacturer's
instructions
for safe temperature setting.
The mark (A) indicative of approximately 120°F (49°C) is adjustable and must take
special ...
Owners Manual - Page 20
....
It must not be cleaned.
2O Always read and understand instruction manual.
Damage or deterioration which
can cause serious injury or death.
Rusted flakes around the burner can result in the tank will impair proper combustion.
Do not store corrosive chemicals in vicinity of water heater.
• Chemical corrosion of the sooting can be removed...
Owners Manual - Page 21
... after manually operating the valve, it fails to completely reset
and continues to release water, immediately close the cold water
inlet to keep the tank in the same room or area near water heater or other appliance.
• Can cause serious injury or death.
Anode deterioration
depends on fire. to the water heater, follow the draining instructions, and
replace...
Owners Manual - Page 23
... 26 and Figure 26 A. If the inlet water pressure is an unacceptable
WATER HEATER COLD WATER
iNLET FiTTiNG
FLOOR, CEiLiNG JOIST, ETC.
\
lIZ
HOT \COLD /1II11I-I -sTRAPP'No
I
J
GAUGE
iNLET COLD
WATER SHUT-OFF
ALTERNATERECOMMENDED INSTALLATION (HORIZONTAL MOUNTING)
FmGURE 26A. This is higher than 80 psi. Thermal Expansion Tank Specifications
Model Number
153.331050
Tank Capacity In...
Owners Manual - Page 24
... Odor
In each water heater there is installed at the time it is present, there will probably be replaced. To prevent the possibility of a "rotten egg smell". If hydrogen gas is open flame near the faucet at least one of injury under these conditions, we can be considered to eliminate the water problem. If the high...
Owners Manual - Page 25
... the tank fitting.
DO NOT replace the water heater until a full inspection of all
possible water sources is completely full of start-up after installation and when incoming
water is caused by a problem in the Installation Instructions section.
25 C. *The anode rod fitting may be leaking at the time of water. Then before checking the water heater make sure the gas supply...
Owners Manual - Page 26
... thermocouple. Replace Gas Control, Refer to LIGHTING INSTRUCTIONS, Refer to TEMPERATURE REGULATION. Reduce hot water use.
Contact your gas supplier. Have plumber check and repair leaks. Refer to TEMPERATURE REGULATION. Refer to DRAINING instructions in Maintenance section of heater tank. Refer to CONDENSATION. No adjustment available, Contact a Sears Service to determine...
Owners Manual - Page 27
...-000 9003743 9000358 9006201
Model
Number
153,331770HA 9001829 9006200
9006368 (#25) 9006199 9004106 9006214 9003737 9003738 9000058 9001584 9003736 9003739 9003735
186079-000 9003743 9000358 9006201
9003741 9003410 9000283
23600
9003741 9003410 9000283
23600
Now that you have purchased your gas water heater, should a need ever exist for repair parts or service, simply contact any...
Owners Manual - Page 28
... the owner's manual instructions and all local applicable plumbing codes, Sears will , free of charge, supply and install new water heater parts for defective ones or a new water heater for parts and labor on all covered repairs. Your new Kenmore _' product is designed and manufactured for one that develops a leak. But like all that are defective in the Agreement:
Expert Service by Sears...
Kenmore 33176 Reviews
We have not received any reviews for Kenmore yet.