Jenn-Air JDRP536HL Support and Manuals
Get Help and Manuals for this Jenn-Air item
View All Support Options Below
Free Jenn-Air JDRP536HL manuals!
Problems with Jenn-Air JDRP536HL?
Ask a Question
Free Jenn-Air JDRP536HL manuals!
Problems with Jenn-Air JDRP536HL?
Ask a Question
Jenn-Air JDRP536HL Videos
Jenn-Air JDRP536HL Cuisinière
Duration: :35
Total Views: 2
Duration: :35
Total Views: 2
Jenn-Air JDRP536HL Review - One Minute Info
Duration: 1:04
Total Views: 172
Duration: 1:04
Total Views: 172
Jenn-Air JDRP536HL Range
Duration: :36
Total Views: 25
Duration: :36
Total Views: 25
Popular Jenn-Air JDRP536HL Manual Pages
Warranty - Page 1
...not apply to review the Troubleshooting or Problem Solver section of merchantability or fitness, so this major appliance was purchased or, at its sole discretion replace the product. ... the purchaser for factory specified replacement parts and repair labor to province.
03/18
W11213280A This is installed, operated and maintained according to instructions attached to or furnished with ...
Owners Manual - Page 4
... UNITS OR AREAS NEAR UNITS - Verify the anti-tip bracket has been properly installed and engaged per installation instructions. Failure to follow basic precautions, including the following:
I CAUTION: Do not store items of glass, glass/ceramic, ceramic, earthenware, or other servicing should never be allowed to a qualified technician.
children climbing on hot surfaces may...
Owners Manual - Page 18
...Wi-Fi module that allows the unit to be scanned or manually added. Follow the prompts in the Bake mode position.
... for the SAID code on the lower right of the front side panel.
3.
Reference the "Internet Connectivity Guide" for each time... when the Sabbath Mode is set and the appliance is enabled. Wi-Fi Connectivity and Remote Operation
Models are disabled during the entire ...
Owners Manual - Page 27
...cool. SEALED SURFACE BURNERS
1. Remove burner cap.
5. Turn on burner. Contact a trained repair specialist.
2. Clean gas opening with damp cloth.
27 Do not use oven cleaners, bleach, ...not light, check cap alignment.
If the burner needs to be adjusted, contact a trained repair specialist.
4. Replace burner cap. Do not use a wooden toothpick. After Each Use:
1. Wipe off...
Owners Manual - Page 35
...instructions. See the Installation Instructions for valid knob combinations. This will sound to the "Warranty," or visit https://jennair.custhelp.com. An invalid mode and temperature selection has been made of the surface burner and contact a service technician. The control knob is not working properly. The updated cooking mode selected is not set to start . SOLUTION Replace...
Installation Instructions - Page 6
... for Mobile Home Construction and Safety, Title 24, HUD Part 280).
Any method of this range must be installed. Model/serial/rating plate location/SAID label
(located on the wheels...codes and ordinances.
A
■ Follow the range hood or microwave hood combination installation instructions for Manufactured Home Installations, ANSI A225.1/NFPA 501A or local codes. Model/...
Installation Instructions - Page 9
...Install a manual gas line shut-off valve. Do not block access to shut-off valve in an easily accessible location. The valve is factory set...). Flexible metal appliance connector:
■ If local codes permit, a new CSA design-certified, 4-5 ft ...model/serial/rating plate. Shut-off valve must be disconnected from the gas supply piping system by a qualified service technician. The parts...
Installation Instructions - Page 13
... adapter to the user instructions located in the middle rear of the anti-tip bracket. Use pipe-joint compound. Flexible connector
HG
F
E. Manual gas shut-off valve. Install a shut-off valve ...parts package. Closed valve B. Correct any leak found.
3.
Clean griddle before using. Open the manual shut-off valve. Failure to pressure regulator located in the Use and Care Guide....
Installation Instructions - Page 17
... [35.6 cm] WCP)
The range and its individual manual shut-off of that system at test pressures equal to ...at test pressures in order to remove or replace kick plate. A
NAT
LP
B
NAT
LP...Locate the "LP" and "NAT" position on the model/serial/rating plate. Gas pressure regulator
4. Tighten the gas...as follows for operation and checking the regulator setting:
Propane Gas:
Minimum pressure: 10" ...
Installation Instructions - Page 21
... regulator and gas supply line. Set gas orifice spud aside.
5. simmer
16,000 BTUs 180
1.80 mm Grill burner
NOTE: Refer to the regulator should be at test pressures in excess of a 1/4" (7 mm) nut driver to the end of 1/2 psi (3.5 kPa). Access cap B. If the burner grates are installed, remove them. 2. Place Propane...
Internet Connectivity Guide - Page 1
... Appliance: You will be guided through the steps to set of knobs needs to be turned to the "WiFi" position.
STEP 2 Create a User Account Once installed, tap the JennAir® app icon to change. Follow the instructions in Your User Account Select Add Appliance on the appliance. Subject to Terms of Service available at 1-800...
Owners Manual 1 - Page 4
... elements. Surface units may result in color. Only certain types of the range unless specifically recommended in death or serious burns to
persons, or damage when using the range. IMPORTANT SAFETY INSTRUCTIONS
WARNING: To reduce the risk of the part code mentioned herein will not tip during normal use a towel or other glazed utensils...
Owners Manual 1 - Page 18
...Guide" for more information. Within a few seconds, the Start light indicators will control the oven functions. Wi-Fi Connectivity and Remote Operation
Models... part code ...set "Away," the app will light until turned off.
■■ When a button is pressed, no longer be automatically replaced by using the JennAir® app, available for each time it cannot be scanned or manually...
Owners Manual 1 - Page 27
....
16-Jan-2019 04:15:32 EST | RELEASED
In some European factories the letter "W" of the part code mentioned herein will be adjusted, contact a trained repair specialist.
4. Replace burner cap.
If the burner still does not light, do not service the sealed burner yourself. COOKTOP SURFACE
After Each Use:
1. Wipe off cooktop, grates, and caps...
Owners Manual 1 - Page 35
...set correctly.
SOLUTION Replace the fuse or reset the circuit breaker. Clean clogged burner ports with a straight pin.
The function has not been entered.
See the Installation Instructions...burner is not set correctly. If the problem continues, call , refer to -heavy cookware made of the surface burner and contact a service technician.
Contact a trained repair specialist.
Use ...
Jenn-Air JDRP536HL Reviews
We have not received any reviews for Jenn-Air yet.