Jamo MPA-101 Support and Manuals
Get Help and Manuals for this Jamo item
View All Support Options Below
Free Jamo MPA-101 manuals!
Problems with Jamo MPA-101?
Ask a Question
Free Jamo MPA-101 manuals!
Problems with Jamo MPA-101?
Ask a Question
Popular Jamo MPA-101 Manual Pages
Owner/User Manual - Page 1
MPA-101
WARNING: Improper installation could result in damage to the amplifier and/or speakers. Read all instructions before installation.
Owner/User Manual - Page 2
...polarized plug has two blades with an amplifier, loudspeakers or headphones - Please note...Guide must be of sufficient Leave all service to qualified service...within the product's No user-serviceable parts inside.
Ensure that
corresponds to... on the product. maintenance (servicing) instructions in the
enclosure that may...replacement of time, or for later reference.
3. Heed warnings : ...
Owner/User Manual - Page 3
Contents:
Introduction Features: Jamo MPA-101 front panel Jamo MPA-101 rear panel Connection Connecting examples
Passive subwoofer Fullrange stereo 2 x 100W bridged Daisy chain
Specifications Warranty
Page 4 Page 4 Page 5 Page 6 Page 7 Page 8
Page 8 Page 9 Page 10 Page 11
Page 12 Page 13
Owner/User Manual - Page 4
... its ample power and two-channel capacity (stereo), it becomes full range amplifier.
Features
1. Subwoofer amplifier, adjustable crossover frequency 50 Hz - 150 Hz 4. Narrow width chassis is specifically designed for the best possible performance 7. Extensive heat sinks for the Jamo MPA-101 power amplifier are obtained using fixed value test load impedances and high intensity sine wave...
Owner/User Manual - Page 5
Standby mode Blue - Amplifier On Flashing red - Overload protection
d Level adjustment 5 Thermal protection Red - Jamo MPA-101 front panel
c Power LED Flashing blue -
Owner/User Manual - Page 6
auto turn on mode j Line in: Line level input from source k Line out: Line level output
6 Amplifier ON
AUTO - Jamo MPA-101 rear panel
c Power switch d Socket for mains cable e Speaker output: Speakers terminals f Low pass adjustment: Output frequency
is selected g g Low pass: f
Flat: Fullrange
h Stereo/mono: ...
Owner/User Manual - Page 7
... used to connect the + terminals to ensure correct phase.
7 Twist the conductor ends 4. terminal. Carefully remove approx. 3/8" (10 mm) of the MPA-101 2. Ask your Jamo MPA-101 as a short-circuit could damage the Jamo MPA-101's output section. Always make sure that the stripped + and - wires do not touch each other, as follows: 1. Usually, the loudspeaker cable...
Owner/User Manual - Page 11
Daisy chain
When using this feature you can connect all the MPA-101 in parallel you need. 11
Owner/User Manual - Page 12
... Depth Clearance for ventilation - noise+hum Vol Max Clearance for ventilation Top Back
50 Watts (Stereo) into 4✡ Load 100 Watts (BTL) into 8✡ Load Specifications
Rated Power Output Total Harmonic Distortion (THD) Signal-to-Noise Ratio Crossover Freq. Response (-3dB) Input Impedance Line In Max. Responce (-3dB):
Auto Turn On...
Owner/User Manual - Page 13
... to repair or replace defective parts or products.
The warranty will come into force as from the use of non-original spare parts • Defects on the invoice. The scope of the warranty
The warranty period will apply for the following period of time: • 2 years for electronics (power supply, amplifier, etc.) • 7 years for service...
Cut Sheet - Page 1
... but capable amplifier that's an excellent choice for powering passive subwoofers. Specifications System Type Weight (kg/lb) Product dimensions (mm/in /line-out connections to operate full range (20-20,000Hz), or set in an adjustable low-pass mode for 2-channel stereo or other amplification • Compact design, simple controls
MPA-101 The MPA-101 is supplied...
Jamo MPA-101 Reviews
We have not received any reviews for Jamo yet.