IBM DTNA-22160 - Travelstar 2.1 GB Hard Drive Support and Manuals
Get Help and Manuals for this IBM item
View All Support Options Below
Free IBM DTNA-22160 manuals!
Problems with IBM DTNA-22160?
Ask a Question
Free IBM DTNA-22160 manuals!
Problems with IBM DTNA-22160?
Ask a Question
Most Recent IBM DTNA-22160 Questions
What Is The Linear And The Angular Density?
I have to make full specification for my hardware class in university of Ruse, Bulgaria?
I have to make full specification for my hardware class in university of Ruse, Bulgaria?
(Posted by nikeca96 6 years ago)
Driver
I need a driver for my DTNA-22160 E182115 s hard drive please.
I need a driver for my DTNA-22160 E182115 s hard drive please.
(Posted by kurkduncan123 12 years ago)
Popular IBM DTNA-22160 Manual Pages
Hard Drive Specifications - Page 5
... 12 3.3.6 Drive Ready Time 12 3.3.7 Operating Modes 13
4.0 Data Integrity 15 4.1 Data Loss by Power Off 15 4.2 Write Cache 15 4.3 Equipment Status 15 4.4 WRITE Safety 16 4.5 Data buffer test 16 4.6 Error Recovery 16 4.7 Automatic Reallocation 16
4.7.1 Non Recovered Write Errors 16 4.7.2 Non Recovered Read Errors 16 4.7.3 Recovered Read Errors 17
5.0 Specification 19 5.1 Environment...
Hard Drive Specifications - Page 6
... 9.2 Command Register 50 9.3 Cylinder High Register 50 9.4 Cylinder Low Register 50 9.5 Data Register 50 9.6 Device Control Register 51 9.7 Drive Address Register 51 9.8 Device/Head Register 51 9.9 Error Register 52 9.10 Features Register 53
iv O E M Specifications of drive Registers 42
Part 2. 5.5 Vibration and Shock 26 5.5.1 Operating Vibration 26 5.5.2 Non-Operating Vibration 26...
Hard Drive Specifications - Page 9
Do not touch the interface connector pins and the surface of the following IBM 2.5-inch, ATA interface hard disk drives: DTNA-21800 (1800 MB) DTNA-22160 (2160 MB)
Note: The specifications are user's responsi- bilities.
.
© Copyright IBM Corp. 1997
1
1.0 General
This document describes the specifications of printed circuit board. Do not cover the breathing hole on the top cover...
Hard Drive Specifications - Page 17
... Maximum 8 3 5/6 Embedded sector servo
© Copyright IBM Corp. 1997
9 Figure 3. Drive Parameter Descriptions
Logical Head Number Logical Sectors/Track Logical Cylinder Number Logical Sector Size Total Customer Usable Data Sectors Total Customer Usable Data Bytes
DTNA-21800 16 63
3500 512 3 528 000 1800 MB (1,806,336,000)
DTNA-22160 16 63
4200 512 4 233 600 2160...
Hard Drive Specifications - Page 23
... the drive is disabled.
This means that there is complete. 4.0 Data Integrity
4.1 Data Loss by Power Off
The drive retains recorded data under all data in the cache and have been flushed onto the disk. Hard reset ... This status normally exists at power-on time and will report hard data error when read , write, or seek. Checking just before power off while write cache is a...
Hard Drive Specifications - Page 24
... system. When the result of this verification meets the criteria, this sector is reallocated.
16 OEM Specifications of those show some errors may be dispersed. When one of DTNA-2xxxx 2.5 inch H D D The conditions for reallocation are located at Power-on the drive are monitored during a write operation. Errors that the data is requested by the error recovery procedure.
Hard Drive Specifications - Page 32
...Figure 18. Physical Dimension and Weight
DTNA-21800 / DTNA-22160 12.7 +0.0/-0.5 69.85 ± 0.25 100.2 ± 0.25 140 Max
5.4.2 Hole Locations
The Figure 18 on page 24 shows the outline of DTNA-2xxxx 2.5 inch H D D 5.4 Mechanical Specifications
5.4.1 Mechanical Dimensions and Weight
The following chart describes the dimensions for the 2.5" hard disk drive form factor.
Height (mm) Width...
Hard Drive Specifications - Page 43
... is set by Drive 1 within 400 msec to determine the drive address, Master or Slave, when the jumper on the interface connector is present. Signal level of the status register or a write to send or receive a 16-bit wide data word.
The rising edge clocks data from a register or data register of the Command Block Registers (Data, Error{Features...
Hard Drive Specifications - Page 53
... described in 8.0, " Deviations From Standard" on October 26, 1995. DTNA-xxxxx supports the following function as Vendor Specific Function.
Security Mode Feature Set S.M.A.R.T.(Self-Monitoring, Analysis, and Reporting Technology) Function
DTNA-xxxxx supports the following functions included by ATA-3 standard. Format Unit Function Protected Area Function
7.2 Terminology
Device Host First...
Hard Drive Specifications - Page 70
...servo remains operational. After each user's data and access pattern is different. This ...it can now be instantaneous without servoing. Recovery time to Active mode from LP Idle ... burst of interest, usually several seconds. DTNA-xxxxx support this mode, power consumption is 15-20...62 OEM Specifications of commands is complete, it places the device in mobile hard drives. When...
Hard Drive Specifications - Page 80
... completion of Write Sectors is ignored when write cache is accessed by setting device Max LBA as
|
0FFFFFh via Set Max LBA/CYL command with volatile option. The retry bit of Soft...all of a write command, soft reset or hard reset does not affect its operation. By using protected area
The data in protected area is enabled.
72 OEM Specifications of DTNA-2xxxx 2.5 inch H D D And the device...
Hard Drive Specifications - Page 99
Command Descriptions 91 The execution time of this command is shown below. about 10min.24sec.
DTNA-22160 DTNA-21800
about 9min.00sec.
Hard Drive Specifications - Page 103
... Mode Feature. Bit assignments
0
Capability
1= Support
1
Enable/Disable
1= Enable
2
Lock
1= Locked
3
Freeze
1= Frozen
4
Expire
1= Expired
8
Security Level
1= Maximum, 0= High
9 15 Reserved
XXXXH * Current Set Feature Option.
The model number in 'Content' field indicates the use of user addressable sectors is 409980H for DTNA-22160, 35D540H for DTNA-21800,
Note 3.
Hard Drive Specifications - Page 124
... bytes )
Reserved
User)
Figure 73. Erase Unit information
116 OEM Specifications of DTNA-2xxxx 2.5 inch H D D
If the password does not match then the device rejects the command with an Aborted error. 12.20 Security Erase Unit (F4h)
Command Block Output Registers
Register
76543210
Data
Feature
Sector Count
Sector Number
Cylinder Low
Cylinder High
Device/Head...
Hard Drive Specifications - Page 125
... lock function), however the master password is still stored internally within the device and may be completed immediately prior to zero with read operation whether the sector of data is shown below.
|
DTNA-22160
|
DTNA-21800
about 9min.00sec. The execution time of this time, the initialized sector of data is set. about 10min.24sec. One indicates...
IBM DTNA-22160 Reviews
We have not received any reviews for IBM yet.