IBM DDRS-39130 - Ultrastar 9.1 GB Hard Drive Support and Manuals
Get Help and Manuals for this IBM item
View All Support Options Below
Free IBM DDRS-39130 manuals!
Problems with IBM DDRS-39130?
Ask a Question
Free IBM DDRS-39130 manuals!
Problems with IBM DDRS-39130?
Ask a Question
Popular IBM DDRS-39130 Manual Pages
Hard Drive Specifications - Page 1
S00K-0097-03
OEM HARD DISK DRIVE SPECIFICATIONS for DDRS-39130 / DDRS-34560
3.5-Inch Hard Disk Drive ( 9130 / 4560 MB ) Revision (2.0)
Hard Drive Specifications - Page 3
S00K-0097-03
OEM HARD DISK DRIVE SPECIFICATIONS for DDRS-39130 / DDRS-34560
3.5-Inch Hard Disk Drive ( 9130 / 4560 MB ) Revision (2.0)
Hard Drive Specifications - Page 6
... German Safety Mark 59 6.13.5 Flammability 59 6.13.6 Secondary Circuit Protection 59 6.14 Packaging 59
Part 2. of DDRS-3xxxx EVPD = 0 72 7.6.2 Inquiry Data Format - Page Code = 00 74
iv O E M Spec. SCSI Interface Specification 61
7.0 SCSI COMMAND SET 63 7.1 Flag and Link Bits 64 7.2 Abbreviations 65 7.3 Byte ordering conventions 65 7.4 F O R M A T U N I T (04 66
7.4.1 Defect...
Hard Drive Specifications - Page 11
1.0 General
1.1 Introduction
| This document describes the specifications of the following IBM 3.5 inch SCSI drives.
|
DDRS-39130
|
− SCSI-3 FAST-20 SE 50-pin
(with SCSI terminator)
|
− SCSI-3 FAST-20 SE 68-pin WIDE (with SCSI terminator)
|
− SCSI-3 FAST-20 SE 80-pin SCA-2
|
− LVD FAST-40 68-pin WIDE (can be used also as SCSI-3 FAST-20 SE)
|
−...
Hard Drive Specifications - Page 19
... (68/80-pin FAST-40 WIDE)
384 Kbyte 6 x 64 Kbyte 3 x 128 Kbyte
7200 134 (Ave) / 156 (Max)
10000 1560 (Max)
8
© Copyright IBM Corp. 1997
9 Formatted Capacity
DDRS-39130 9130 512 165-264 10 5
17,850,000 9,139,200,000
DDRS-34560 4560 512
165-264 5 3
8,925,000 4,569,600,000
3.2 Data Sheet
Figure 2.
Hard Drive Specifications - Page 42
... 6 on LVD models (Force SCSI Single-End Mode)
| If a shunt jumper is installed, the drive is defined as Single-End mode drive.
32 OEM Spec. 6.2.1 Jumper Signal Description
Throughout this paragraph ON means a shunt jumper is installed and O F F means that no shunt jumper is installed.
6.2.1.1 Device address select lines. (-DAS0, -DAS1, -DAS2, -DAS3)
These four lines defines DDRS-3xxxx device...
Hard Drive Specifications - Page 46
... of DDRS-3xxxx of 50-Pin Model
36 OEM Spec. The schematics of the the jumper pins, the following pins can be used to drive LED.
68-Pin Model : Auxiliary Connector Pin #8 and #11. 80-Pin Model : SCA-2 Connector Pin #77 as follows.
6.3.1 50-Pin Model
DDRS 39130 / DDRS 34560 50 Pin Model +5V o > < 620 Ohm > o Jumper Pin #1 for LED Anode o Jumper Pin...
Hard Drive Specifications - Page 48
of 80-Pin (SCA-2) Model
38 OEM Spec. LED Circuit of DDRS-3xxxx 6.3.3 80-Pin Model
DDRS 39130 / DDRS 34560 80 Pin (SCA 2) Model :
:
:
:
+5V
+5V
:
o
o
:
:
:
>
>
:
1K Ohm <
< 620 Ohm
:
>
>
:
:
:
:
\/
:
LED \ /
:
Jumper Pin #1
for LED Anode
o
:
:
:
o
/
Jumper Pin #2
for LED Cathod
\
:
:
:
SCA 2 Connector Pin #77
///
o
for LED Cathod
:
:
: Example...
Hard Drive Specifications - Page 83
... of microcode. Product ID Maximum LBA
DDRS-34560 8924999
DDRS-39130 17849999
DDRS-34560W 8924999
DDRS-39130W 17849999
Number of inquiry information that follows. Formatted Capacity
17850000
8925000
17850000
Product Revision Level indicates the level of SCSI (ECMA-111).
Wb_32 is set to zero to indicate that the file does not support 32-bit wide data transfers.
The file...
Hard Drive Specifications - Page 138
... Figure 99 on page 129.
128 OEM Spec.
If another value is specified, the command is reserved. Allocation Length The file terminates the DATA IN phase when allocation length bytes of DDRS-3xxxx The initiator should normally be set sense key to ILLEGAL REQUEST and additional sense code to ILLEGAL FIELD IN CDB. Buffer...
Hard Drive Specifications - Page 164
...SCSI bus integrity.
Buffer ID must be emptied. All other modes are performed and the command is used in conjunction with CHECK CONDITION status. If another value is specified, no download function are not supported by a four-byte header. And File shall set sense key to ILLEGAL REQUEST and additional sense code... not alter the medium of DDRS-3xxxx
WRITE BUFFER (3B)
The...OEM Spec. MODE...
Hard Drive Specifications - Page 165
... to ILLEGAL REQUEST and additional sense code to ILLEGAL FIELD IN CDB.
Buffer Offset specifies the offset of the buffer size. on a sector boundary.
Parameter List Length specifies the Parameter List Length. less than the capacity of the memory space specified by the Target:
SCSI COMMAND SET 155 Buffer ID field is used...
Hard Drive Specifications - Page 166
... will be zero.
Following Buffer IDs are supported by separete data sets) 80h : EEPROM Data 81h : Reserved Area Data 82h : R O M code (only for Flash R O M version)
156 OEM Spec. File shall set sense key to ILLEGAL REQUEST and additional sense code to ILLEGAL FIELD IN CDB. of customers for functional upgrade and configuration change by a power on the...
Hard Drive Specifications - Page 167
... Save (Buffer_ID = 00h)
There are 3 types of data set .
File shall set is starting without "Power on the card type and version if card has update capability.) This download function is available when the file is running without header, R A M code and 2 Overlay codes are supported. File shall set as the single binary. The 3 blocks must be sent...
Hard Drive Specifications - Page 168
... ILLEGAL FIELD IN CDB. If an invalid value is specified, the command is updated. This is terminated with CHECK CONDITION status . Buffer Offset must be 0C000h.
158 OEM Spec. Buffer Offset must be operational with newly downloaded R O M code. Otherwise file shall set to ILLEGAL FIELD IN CDB. If an invalid value is specified, the...
IBM DDRS-39130 Reviews
We have not received any reviews for IBM yet.